Consider the data path below for a single cycle 32-bits MIPS processor Assume that we are executing the following instruction lw $t0, 48($t1) What is the value of the element pointed by arrow number 1 by in hexadecimal? Note that the PC and the content of registers $t0 and $t1 are found in bottom left of the figure below Select one: a. None

Q: After the SHR instruction is executed in the code sequence below, what is the final value for AL?…

A: Correct Option is B⇒ 0010_1011

Q: Ox00400028 Ox0040002C Ox00400030 sll $s0, $0, 3 addi $to, $s1, -20 sub $t1, $to, $s0 NEXT_4:…

A: It is defined as the way of specifying data to be operated by an instruction is called addressing…

Q: H\W: assume Ds= 2400, show the content of register as each the following instruction execute Mov Bx,…

A: The register is created as the storage area built in the central processing unit. The most modern…

Q: corresponding Which one of the following is the binary representation of the machine code that to…

A: Given that, opcode  of lw = 35 register is $t1=9 register $t2= 10 lw $t1, 20($t2)

Q: The following program is stored in the memory unit of the basic computer. Show the contents of the…

A: Step 1: To analyze and demonstrate how the program progresses through its execution on a basic…

Q: 3. Find out the MIPS instructions for the following code: A = B - X[4]; If(A >= C){ C - 800; D =…

A: SUMMARY: - hence, we got the desired output.

Q: Q2. Refer to datapath design on slide no. 26 with added blocks for jump instructions as shown in…

A: In a datapath design with control and jumps, the datapath includes additional logic to handle branch…

Q: Fill in the blank areas in the following table. The memory accesses column should include all memory…

A: The memory accesses column here includes all memory accesses to get the instruction, the operands,…

Q: Assume the following register contents: $t0 = 0x01234567, $t1 = 0x56781234. Set back to these values…

A: The value of $t1, $t2, $t3, $t4 after the above instructions are given below

Q: Show the code to perform the computation X=4 + (B + C) *D + E using microprocessors which use the…

A: Given that, X = A + (B + C) * D + E using microprocessors whIch use the instruction formats shown…

Q: 16. If the first instruction "LXI H, 1100H" is positioned at address 7000H in memory, at what…

A: Correct answer of above given question is Option(1) 7003H i.e next instruction is located at address…

Q: Instruciton or addi sub bne sd www Instruction Memory Data Memory ImmGen/Sign-Extend

A: The result of the bitwise OR operation on the contents of the first source register and the second…

Q: Assume SHFT A instruction in which %MW1 has been assigned to the input labeled IN and the output…

A: Answer: I have given answered in the handwritten format in brief explanation.

Q: After the execution of the instruction: sts $00FF, r3 the memory location with the address will have…

A: About the sts instruction: ================================== sts stands for,Store to data space.…

Q: tapati ign on side no. 26 with added b Jump nown III slide 33 in Chapter 4 (part 1). Let's assume a…

A: Datapath design refers to the process of designing the hardware components of a microprocessor or…