Answered: Consider a room that is initially at… | bartleby

Related questions

Question

Consider a room that is initially at the outdoor temperature of 20^oC. The room contains a 40-W lightbulb, a 86-W TV set, a 319-W refrigerator, and a 1,339-W iron. Assuming no heat transfer through the walls, determine the rate of increase of the energy content of the room when all of
these electric devices are on.

Expert Solution

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 5 images

SEE SOLUTION Check out a sample Q&A here

Blurred answer

Similar questions

If 370 J of work is performed with 45% efficiency, what is the amount of energy that goes into heating, parasitic losses, etc.? Give your answer in units of joules, to three significant figures.
For a total PV module of 25m2, what would be the PV power for each if conversion efficiency is 15% on days when an angle of a south-facing collector in [city] be tipped up to have it normal to the Sun's rays at solar noon?
A cylindrical resistor element on a circuit board dissipates 0.15 W of power in an environment at 40°C. The resistor is 1.2 cm long, and has a diameter of 0.3 cm. Assuming heat to be transferred uniformly from all surfaces, determine the amount of heat this resistor dissipates during a 24 h period;
A refrigerator removes 30.0 kcal of heat from the freezer and releases 68.5 kcal through the condenser on the back. How much work was done by the compressor?
A power plant burns coal to produce pressurized steam at 554 K. The steam then condenses back into water at a temperature of 334 K If the plant operates at 50.0% of its maximum efficiency and its power output is 1.23 * 10 ^ 8 * v means of a cooling tower ? at what rate must heat be removed by means of cooling tower?
Consider an electric motor with a shaft power output of 20 kW and an efficiency of 88 percent. Determine the rate at which the motor dissipates heat to the room it is in when the motor operates at full load. In winter, this room is normally heated by a 2-kW resistance heater. Determine if it is necessary to turn the heater on when the motor runs at full load.
On a February night, energy leaves a house by several energy leaks, including 1.50×103W by conduction through the ceiling, 450W by infiltration (airflow) around the windows, 140W by conduction through the basement wall above the foundation sill, and 40.0W by conduction through the plywood door to the attic. To produce the biggest saving in heating bills, which one of these energy transfers should be reduced first? Explain how you decide.
Would you be willing to financially back an inventor who is marketing a device that she claims has 25 kJ of heat transfer at 600o K, has heat transfer to the environment at 300o K, and does 12 kJ of work? Explain your answer.
46:56 WLwvimdGI A 52-kg package is lifted to the top shelf in a storage bin that is 4 m above the ground floor. How much increase in potential energy does the package get? O 1504733.118 Ib-ft 1937.104 BTU O 2040.48 kJ O 2.04 kJ
Three 105.0-g ice cubes initially at 0oC are added to 0.900kg of watter initially at 21.5oC in an insulated container. What is the mass of unmelted ice, if any, when the system is at equilibrium?
A certain coal-fired power plant has a rated power capacity of P = 850 MW. The output of this plant is W = 0.21QH, where QH is the energy input as heat from the hot reservoir. a) Which would increase the efficiency more, doubling QH or reducing QC by half? b) Calculate the maximum thermal efficiency of the power plant. c) Calculate the absolute value of the exhausted heat (QC) each second in MJ for the power plant. d) If the power plant operates for a full day at its rated capacity, how much energy QH in MJ is needed? e) If, on average, one ton of coal contains Q = 25 GJ of energy, how many tons nH of coal would the plant need to operate for a day at its rated capacity? f) How many tons nC of this coal is exhausted as wasted heat to QC in a single day?