Complete feature control frame that controls perpendicularity of the hole to .012" diameter at MMC relative to datum feature A and straightness of the hole to .004" diameter at MMC

Q: How many auxiliary views are found on this print?

A: Some objects are too complex that do not show the best geometry of the part by three principle view.…

Q: - PITCH 0.962 The bolt in the accompanying figure has 7.3 threads. Determine the pitch to 3 decimal…

A: Given data Total thread length  = 0.962 inches The number of threads = 7.3 Pitch length needs to be…

Q: what is the MMC of shaft dimension 1.375 /- .030?

A: Given: The dimension of shaft  is 1375/-0.30 MMC :MMC stand for  Maximum Material Condition.

Q: C 80±0.5 - 40 50±0.5 20 la be oxi odr wode wo B A.

A:

Q: Dimension the holes & shafts for the required linear tolerance. Also calculate the hole tolerance,…

A: For Hole: For RC3 : RC stand for Running Fit . The nominal diameter is 2.00 in. Hole tolerance is…

Q: For the following hole and shaft assembly, determine hole and shaft tolerance and type of fit. Hole…

A: Hole      Upper limit of hole =20.025 mm      Lower limit of hole =20.000 Mm Shaft       Upper limit…

Q: 7. The three functional gages below can be used to verify the three segment position specification…

A:

Q: 8. If the limits of size for a hole are .384" and .394" diameter, and the position tolerance is…

A: Write the given data. Minimum limit=0.384"Maximum limit=0.394"Positional tolerance at MMC=0.009"

Q: Produce a 3D solid model of the Guard casing and test boss and produce an assembly of the two parts…

A: Given Guard casing Test boss To find Parts Assembly

Q: The term "Allowance" in limits and fits is usually referred to 1. Minimum clearance between shaft…

A: Allowance :- (A) Minimum clearance between the shaft and hole The minimum clearance in a shaft and…

Q: Apply geometric tolerancing to part according to the instructions below. This exercise will provide…

A: The asked all three questions are answered and are marked in the image below clearly please refer to…

Q: Mill the part to a depth of .375" starting at the origin and travelling in Counter Clockwise. Use a…

A: Label the given figure. Write the coordinates of the figure.

Q: Refer to the figure below. Read the feature control frame in the figure and write it out below.…

A: A feature control frame is used in GD&T to show the condition and tolerance of a geometric…

Q: On the drawing attached, identify the large diameter as datum feature A. Specify a 0.1 cirular…

A:

Q: 5. Given the following sentence descriptions of the geometric tolerance information, correctly…

A: d. The planer surface must be perpendicular with in five thousandths of an inch tolerance zone…