circular cylinder 400 mm in diameter and 750 mm long has 600 mm of its length submerged in kerosene (S.G. = 0.823). What is the specific weight of the cylinder? a. 1.86 KN/m° C.) 0.608 kN/m3 b. 6.45 kN/m3 d.) 0.805 kN/m3

Q: A 40 mm plastic sphere (?? = 1.3) is dropped in a certain oil (?? = 0.85, μ = 3.6 × 10−2 Pa∙s). (a)…

A: Note: we experts are required to answer only one question. Please send the remaining question to the…

Q: 45 Liquid 1 SG y Liquid 2 SG2 .--- Both the top of the tank and the end of the slanted tube are open…

A:

Q: The head produced by a liquid of relative density 1.62 is equal to the pressure of 250 kPa. What is…

A: given- relative density ρ=1.62pressure P=250 kPa=250×1000 Pa

Q: A vertical 150-mm-diameter pipe leaves a water tank that has a surface elevation of 12m. Between the…

A: Velocity of flow at 0 elevation=Q/A Area=A=πd24 d=150/1000=0.15 m A=3.14×0.152/4=0.0177 m2…

Q: A sump pump (used to drain water from the basement of houses built below the water table) is…

A:

Q: 7. An ejector mechanism consists of a helical compression spring having a spring constant of k =…

A:

Q: Oil of specific gravity 0.82 flows through an orifice at the vertical side of a closed cylindrical…

A:

Q: An open vessel in the form of a frustum of a cone with a radius of 1.2m (bigger base), the smaller…

A: The radius of frustum at base, R=1.2 m The radius of frustum at top, r=1 m The slope of vertical…

Q: A 2 m diameter cylinder containing oil of s.g. = 0.80 is immerged in water in a tall metal cylinder…

A:

Q: SITUATION: A cylindrical tank with radius 0.5 m and 2 m high weighs 1200 N. The tank is to float in…

A:

Q: shaft = 44 kW and mechanical efficiency 94%. Q53. The following data were obtained from a test on a…

A:

Q: Vin = 4 m/s %3D 0.2 in Air Water 3 т h 1 in 2 m How long will it take for the water level to reach 1…

A:

Q: A sharp-edged circular nozzle with a cross-sectional area of 10 cm2. Water flows from it under the…

A: Actual velocity calculation:…

Q: ts Question 13 of 25 A reservoir of glycerin has a mass of 1200 kg and a volume of 0.952 cu.m. Find…

A: Given Data  Mass of glycerin (M) = 1200 kg  Volume of glycerin (V) = 0.952 m3  Determine the…

Q: 4.11 A solid cylinder of circular section of diameter d is of material with specific gravity S This…

A:

Q: Current Attempt in Progress A sound wave is observed to travel through a liquid with a speed of 1250…

A: Given: Velocity of sound wave in fluid  Specific gravity of fluid To find: Bulk modulus of fluid…

Q: 180 kg M

A:

Q: A cone with a height of 1.5m and a diameter of 500mm is filled with a liquid that weighs 0.8 KN.…

A:

Q: A cylindrical tank, 1.20-m diameter and 2.50m high weighs 2850 N. The tank float in water with a…

A: Diameter of cylinder, D=1.2mHeight of cylinder, H=2.5mCylindrical tank is floating with a draft of…

Q: A horizontal nozzle of 30 mm diameter discharges a steady jet of water into the atmosphere at a rate…

A:

Q: The head produced by a liquid of relative density 1.62 is equal to the pressure of 250 kPa. What is…

A: Given data- Relative density- RD=1.62, Pressure P=250 kPa, To Find- The head produced by the liquid…

Q: The liquid in blue color has a density of 500 kg/m. Calculate the gage pressure Pain kpa for h = 5…

A: Given  Density = 500 kg/m3 Height = 5 m We need to find PA

Q: A horizontal nozzle of 30 mm diameter discharges a steady jet of water into the atmosphere at a rate…

A:

Q: A projectile is fired with a speed of 60m/s at an angle of 60 degrees from the ground surface. A…

A:

Q: A horizontal nozzle of 30 mm diameter discharges a steady jet of water into the atmosphere at a rate…

A:

Q: In an ore-mixing operation, a bucket full of ore is suspended from a travelling crane which moves…

A:

Q: A horizontal nozzle of 30 mm diameter discharges a steady jet of water into the atmosphere at a rate…

A: Given: Diameter of nozzle Discharge  Density of water  To find:  Force exerted by jet  Notations: Fx…

Q: both the top of the tank and the end of the slanted tube are open to the atmosphere. if L = 3.18 m.,…

A: Specific gravity and height of liquid in a tank is given and it has been asked to determine the…

Q: A horizontal nozzle of 30 mm diameter discharges a steady jet of water into the atmosphere at a rate…

A: Given: Diameter of nozzle, d =30 mm = 0.03 m Discharge of water, Q=15 l/s = 0.015 m3/s Density of…

Q: A vertical cylindrical tank 1 m in diameter and 3 m tall weighs 3.86 kN. Which of the following most…

A: Given data- A vertical cylinder tank- Diameter d=1 m,Height h=3 m,Weight W=3.86 kN,Unit weight of…

Q: If benzene flows through the pipe line showed in the figure 3, and its velocity where is the benzene…

A: Using continuity equation :vAAA=vBAB8π4(6)2=vBπ4(4)2vB=18fpsso,

Unit Conversion

Standard units are also called SI units. SI units are used for measuring a physical quantity satisfying certain conditions. There are two types of units: fundamental units and derived units. Fundamental units are physical quantities that are independent, that is, they do not depend on other quantities like mass, length, or time. There are plenty of quantities in our lives which need to be measured and compared. Measuring is the comparison of a particular physical quantity with its reference value. A unit is a measure of a fixed physical quantity. A physical quantity is the product of a unit and the numerical value we need to compare with.