17. At 32 deg. celcius and 308 KPa absolute, the specific weight of a certain gas is 13.7 N/m^3. What is the gas constant of this gas? * 750 J/kg -K 730 J/kg -K 723 J/kg -K 713 J/kg -K 18. A cylindrical tank 0. 80 m in diameter and 0.90 m high is filled with a liquid. The tank and the liquid weighed 420 kg. The weight of the empty tank is 40 Kg. What is the unit weight of the liquid in KN/m^3? * 6.24 KN/m^3 7.24 KN/m^3 8.24 KN/m^3 9.25 KN/m^3

17. At 32 deg. celcius and 308 KPa absolute, the specific weight of a certain gas is 13.7 N/m^3. What is the gas constant of this gas? * 750 J/kg -K 730 J/kg -K 723 J/kg -K 713 J/kg -K 18. A cylindrical tank 0. 80 m in diameter and 0.90 m high is filled with a liquid. The tank and the liquid weighed 420 kg. The weight of the empty tank is 40 Kg. What is the unit weight of the liquid in KN/m^3? * 6.24 KN/m^3 7.24 KN/m^3 8.24 KN/m^3 9.25 KN/m^3

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

- A certain gas a value of R = .18896 KJ/kg°K and K = 1.288. Calculate the value of Cp and Cv. %3D
Problem A gas weighs 16 N/m³ at 25°C and at an absolute pressure of 0.25 N/mm². Deter- mine the gas constant and density of the gas.
One pound of an ideal gas undergoes and isentropic process from 95.3 psig and a volume of 0.6 ft³ to a final volume of 3.6 ft3. If Cp = 0.124 BTU/lbm-°R and Cy = 0.093 BTU/lbm-°R, determine: 1. Final temperature in °F 2. Final pressure in psia 3. Change in enthalpy in BTU 4. Work in BTU
CIVIL ENGINEERING Que. 10 The increase in pressure required to decrease unit volume of mercury by 0.1 % is ..* ? Given K=28.5 Mpa а) — 28.5 МРа b)-28.5 kPa c) –28500 kPa d) -28500 MPa
A pipe contains an oil of specific gravity 0.9. A differential manometer connected at the two points A and B shows a difference in mercury levels as 15 cm. The difference of pressure at the two points A and B will be (Note: consider the density of mercury as 13600 kg/m-). O 18688 N/m2 O 15981 N/m2 O 288 N/m2 O6528 N/m2
1. If the work done 10000 cal, and the initial pressure 100 atm, when the ideal gas | expand isothermally and reversibly from the initial l volume (V1) to the final volume (10 V1), R = 1.987 cal/mole.K. ~ (A) calculate V1. (B) If there are - 2 moles from ideal gas what is the temperature.
The cyclindrical tank with hemispherical ends shown in Fig. contains a volatile liquid and its vapor. The liquid density is 800 kg/m', and its vapor density is negligible. The pressure in the vapor is 120 kPa (abs), and the atmospheric pressure is 101 kPa (abs). Determine: (a) the gage pressure reading on the pressure gage; and (b) the height, h, of the mercury manometer. Open Vapor 1m 1 m Liquid 1 m Mercury E E
(a) Glycerine at 25 °C flows through a straight copper tube (D = 73.8 mm), at a flow rate of 180 L/min. Calculate the pressure difference between 2 points which are 25.8 m apart, if the first point is 0.68 m below the second point. Gven: At 25 °C density and dynamic viscosity for glycerine is 1286kg/ and 0.96 Pa.s respectively(b) If benzene at 50 °C is used in question (a) above instead of glycerine, evaluate the new pressure difference. ...
Required information Experimental data for the density of n-pentane liquid for high pressures, at 50°C, are listed as follows: 100 10230 20700 34310 Pressure, kPa Density, kg/m³ 586.3 604.1 617.8 632.8 Evaluate p at 30 MPa. 0.08956 kg/m³
A gas at 45 degrees Celsius is under pressure of 398.675 kPa. Assume gas constant of 287N-m/kg-K. a. Determine the density of the gas b. Calculate the specific weight
. A solvent used for plastic manufacturing consists of cyclohexanol in tank A and ethyl lactate in tank B. Determine the pressure on the top of tank A if the mercury in the manometer is at the level shown, where h = 0.75 m. Take Sc= 0.953, SHg = 13.55 and Sel = 1.03. po A T 1.5 m B mercury 4.5 m
A perfect gas has a value of R= 0.317 ks/ka-k and k = 1.27 If 120k] are added to 2.75 KG of this gas e constant pressure when the initial temp. 15 33°C, Find: 9] 1₂ b) Wkn c) pv and TS drag.