Answered: The increase in pressure required to…

The increase in pressure required to decrease unit volume of mercury by 0.1 % is ..* ? Given K=28.5 Mpa a) -28. 5 MPa b)-28.5 kPa с) — 28500 kPa d) —28500 MPа

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: A sound wave is observed to travel through a liquid with a speed of 1380 m/s. The specific gravity…

Q: lastic sphere (?? = 1.5) with a diameter of 30 mm sinks in a body of oil (?? = 0.85, μ = 3.0 × 10−2…

Q: A column of mercury produces 600kPa. What is the equivalent height of water column?

A: We will use formula of pressure.

Q: rate of jet = 350 Liters/sec velocity of jet = 30 meters/sec *The jet guts the blade moving in the…

A: Dynamic force is a force acting on a jet that causes it to vary or change its size, position, or…

Q: A 40 mm plastic sphere (?? = 1.3) is dropped in a certain oil (?? = 0.85, μ = 3.6 × 10−2 Pa∙s). (a)…

A: Note: we experts are required to answer only one question. Please send the remaining question to the…

Q: An unknown liquid X is stored in a cylindrical storage tank (bottom diameter: 80 cm). After dropping…

Q: Estimate the submerged height of a steel cube 0.3 m on a side that floats in mercury. The relative…

Q: Determine the unit weight in kN/m³ of the fluid if at a point 6.58 m below the surface, the pressure…

Q: A volume of 0.03 m' of O, mi larally at 220 F and pressure 4 bar is compressed reversibly at…

A: Given data- Volume V1=0.3 m3temperature T1=220+273=493 Kpressure P1=4 bar=400 kPaV2=0.6 m3molar mass…

Q: 3. A cube, 60 cm on an edge, has its upper half having a specific gravity of 0.60 and the lower half…

Q: 1. A certain liquid has a unit weight of 57 KN/m^3. Compute the mass density. Unit of the correct…

Q: A solid sphere (diameter 6 mm) is rising through oil (mass density 900 kg/m3, dynamic viscosity 0.7…

Q: A sphere of 5 mm diameter rises through a fluid of mass density 1200 kg/m³ and dynamic viscosity 0.8…

A: Given- Diameter d=5 mm, Mass density=1200 kg/m3, Dynamic viscosity = 0.8 N-s/m2, Velocity=0.4 cm/s,…

Q: A pump handling a liquid raises its pressure from 1 bar to 30 bar. Take the density of the liquid as…

A: Given- Pressure= 1 bar increases to 30 bar, Density of liquid = 990 kg/m3,

Q: Determine the pressure required to reduce the given volume of water by 1 % (Bulk modulus or…

A: Given data in question Bulk modulus 2×108 N/m2 Reduction volume ratio 1% = 0.01 To find out…

Q: 1. A water sample is known to contain 300 g/m3 of casein (C8H12O3N2). Estimate the COD, BODu, and…

A: Given data: Mass of sample of casein m=300 gm/m3 Deoxygenating Constant at temperature 20°C=…

Q: If we compress water by applying 20433.5 Mpa pressure, how much volume change can be observed?. Bulk…

Q: w A В 1.2 m 3.6 m 0.8 m

Q: During the 20th century, the United States would often dispose of nuclear waste by dumping them into…

A: In order to calculate the change in volume of the cube we have ∆V = εv*V ∆V = change in volume of…

Q: QI/ A car moves along a straight line with an accekration ( a = 4V ) When kad to S= 0, V = 2,…

A: Given data- Acceleration- a = 4V-2 At t=0, S=0 and V=2 Final velocity- V=10 m/s At t=2s,…

Q: 3. A liquid which is compressed in a cylinder has a volume of 1200 cm' at 1.2 MN/m² and 990 cm' at 2…

A: The proportional reduction in the material thickness under some specified conditions of improved…

Q: Calculate the approximate depression (in meters) of mercury at 20°C in a capillary tube of radius 2…

A: Given data- The capillary tube radius (R) = 2 mm = 0.002 m Surface tension for mercury = 0.514 N/m…

Q: 6m hi 2.3m 6m dos 300mm 2m 3m 2m 45 45 6m 1.

A: Given Data ; tank 1 diameter = 6 m tank 2 dimension = (3m , 2m) water level diffrence = 2.3 m H1=…

Q: A sound wave is observed to travel through a liquid with a speed of 1260 m/s. The specific gravity…

Q: Vin = 4 m/s %3D 0.2 in Air Water 3 т h 1 in 2 m How long will it take for the water level to reach 1…

Q: Determine the mass density, specific weight, and specific volume of the oil acting on a plate.

Q: A porous media is overlain by water. A pressure of 100 psia is exerted o he other end of porous…

Q: Consider water molecules in a water film that surrounds a silt particle. All the water molecules in…

A: Consider water molecules in a water film that surrounds a silt particle. All the water molecules in…

Q: 6 Determine the absolute pressure at C in kPa if the atmospheric pressure is 101.325 kPa. * 105.525…

A: Figure is as shown

Q: find the specific gravity of the given unknown tluid, the hydrometry weight is 0.015 N. A = 0.1 cm2…

A: Given: Hydrometry weight = 0.015 N Area of cross-section of tube, A = 0.1 cm2 = 0.1×10-4 m2 z = 6.3…

Q: Two spherical vessels of different sizes contain the same gas and are connected by means of a pipe…

A: NOTE - Since we only answer up to 3 sub-parts, we’ll answer the 4, 5 and 6. Please resubmit the…

Q: The bulk modulus of water is 210x10 kN/m². What pressure is required to reduce the volume of water…

Q: In figure below, what is the pressure in pounds per square inch at A?

Q: The pressure 27 meter below a liquid is 772.64 kPa, determine its mass density (kg/m³).

Q: ts Question 13 of 25 A reservoir of glycerin has a mass of 1200 kg and a volume of 0.952 cu.m. Find…

A: Given Data Mass of glycerin (M) = 1200 kg Volume of glycerin (V) = 0.952 m3 Determine the…

Q: The cylinder in the figure is to be placed in fresh water. The top potion of the cylinder is foam…

Question

CIVIL ENGINEERING
Que. 10
The increase in pressure required to
decrease unit volume of mercury by
0.1 % is ..* ? Given K=28.5 Mpa
а) — 28.5 МРа
b)-28.5 kPa
c) –28500 kPa
d) -28500 MPa

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Mass and mass related variables in engineering

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Q2 For system shown, find the relation between variables that reflect the reaction force on the sphere neglect pressure force and buoyant force( use Rayleigh method ) For liquid Pu=0 e Ne0 ) M0 For sphere 0 D102 ~— VV2 V2= F F 03/ for cvetem helow find the
Solve this fast response..
A steel bar is 2 m long at room temperature 35°C and is then heated to 85°C. The coefficient of thermal expansion is a = 14x10-6 m/m/°C. Determine the change in length of the bar if it is free to expand. O a. 1.68x10-3 m O b. 1.40x10-3 m O. 1.05x10-3 m O d. 2.07x10-3 m
Situation 2: A liquid at 4°C has a relative density of 0.80 and a kinematic viscosity of 2.3 centistoke. 3. Determine its unit weight in (3 decimal places) kN m² na 4. Determine its dynamic viscosity in kg m-s (5 decimal places not in scientific notation)
Problem 2 -51 In Figure 13, in which fluid will a pressure of 700 kPa first be achieved? Ans: glycerin Po = 90 kPa ethyl alcohol p= 773.3 kg/m 60 m oil p = 899.6 kg/m2 10 m water p = 979 kg/m glycerin p = 1236 kg/m 5 m 5 m
Assuming that the system is in equilibrium, find the value of m3, knowing that:
In the Figure below, a pool of liquid sodium is sitting in open atmosphere (and somehow not exploding from the moisture in the air) and an absolute pressure measurement device. The measurement device reads an absolute pressure of P2 at the depth of L in the pool. dP a) Calculate the pressure gradient (-) b) Using Excel plot the pressure distribution from the P2 and P1. Figure 1: A 2-D pool of Sodium on Earth that magically is keeping all of it's liquid inside even though it has no front and back sides.
A liquid has specific gravity of S.G=0.9. The specific weight of this liquid is O a. 0.9 N/m^3 O b. 8829 N/m O c. 0.00111 N/m^3 O d. 8.829 N/m^3
An inclined manometer can measure the pressure difference of 200 Pa. The inclined manometer has a least count of 4mm using mercury. The sensitivity of manometer is
Please do,I want a quick solution.
(c) Consider the following conditions: Condition 1 Condition 2 A wooden cube of size 2 m and the 20% of the volume of a body is visible relative density of 0.5 floats in the over the free surface of the water. water. Calculate: (i) Volume of the cube submerged in the water, based on Condition 1. (ii) Density of the wooden cube, based on Condition 2.
1. If the work done 10000 cal, and the initial pressure 100 atm, when the ideal gas | expand isothermally and reversibly from the initial l volume (V1) to the final volume (10 V1), R = 1.987 cal/mole.K. ~ (A) calculate V1. (B) If there are - 2 moles from ideal gas what is the temperature.