Circle the letter corresponding to the correctly aligned set of orthographic views. 1. 2. A 1:5: A B B correctly the C aligned set of orthographic views. Circle the letter corresponding to D 06:2 D

Q: 5-4 Composite A-36 steel bar shown made from two segments AB and BD. Area AAB = 600 mm2 and Agp =…

A:

Q: 3. A car has an initial speed of 25 m/s and a constant deceleration of 3 m/s^2. Determine the…

A: Using equations:v-u=atv2-u2=2ass=ut+12at2

Q: 2. The rigid bar BC weighs 50 lb/ft, is supported by the steel rod AC of cross-sectional area of…

A:

Q: (Bernoulli/continuity) Water flows steadily through a diverging tube as shown in the figure below.…

A: Given data: d1=0.52 ftd2=0.70 ftd3=0.92 ftSG=2y=2.4 ft

Q: 4. Find the dimensions of a concrete lined open channel used to convey a discharge of 70 m/s. The…

A: Given data  Discharge  Mannings roughness coefficient  Side slope  Bed slope

Q: II. Draw the moment diagram for each of the beams and obtain the maximum moment for each of the…

A: Note : Since you have asked multiple methods, we will solve the first method (consistent…

Q: Question 5 of 20 A structural member is fabricated with the cross section show below and is…

A:

Q: A gasoline service station sees on average 27 arrivals of vehicles every one hour in the morning.…

A: Start time 8:15 AM t1 = 35 minutes t2 = 100 seconds = 1 minute 40 second t3 = 45 minutes Total time,…

Q: Problem 2. The following observations were taken during a tacheometric survey using the stadia lines…

A: Given- The observation obtained from tacheometric survey using stadia lines of a theodolite.…

Q: The laboratory tests on a soil sample gave the following results: 1). Natural water content, W₁ =…

A: Given: Natural water content, wn=25 % Liquid limit, wl=60 % Plastic limit, wp=35 % % of particle…

Q: Problem 13. In a stream line steady flow, two points A and B on a stream line are 1 m apart and the…

A:

Q: A simply supported wood beam of length L = 12 ft carries a concentrated load Pat midspan, as shown.…

A:

Q: Answer in whole number w C A x В L- L/2

A:

Q: Determine the force in each member of the loaded truss. The forces are positive if in tension,…

A: Given data in question  Load 3350 N Angle 46° a= 1.9 m To find out  Forces in each member

Q: The channel is 2 m wide and transports water at 18 m3 /s. The elevation of the bed is raised 0.25 m.…

A: The flow in upstream is equal to the flow in the downstream, let considering the energy head in the…

Q: Refer to Figure P-02. A channel shape, C8 x 18.75, is used as a tension member. The channels are…

A: Answer  a) Calculation of ultimate capacity of the channel if yielding on the gross area governs We…

Q: 5/101 Determine the reactions at A and B for the beam subjected to a combination of distributed and…

A: Using equilibrium equation

Q: Problem 2. A well is located in a completely confined aquifer with a hydraulic conductivity of 12…

A:

Q: Part A Determine the depth y that will produce maximum velocity for the flow. Express your answer in…

A: Hydraulic Characteristic of circular sewer:  As in the figure the sewer shown in figure, is circular…

Q: 5. Segment AB of the bar is a tube with an outer diameter of di and a wall thíckness of 0.125 in.…

A: To Find:- Diameter d1 Diameter d2

Q: A lagoon having three cells, each 100,000 m2 in area, a minimum operating depth of 0.5 m, and a…

A: Given data- 3-cells with area=100,000 m2 eachDischarge (Q)=2,000 m3/dayAvg. BOD5=200 mg/L To find-…

Q: Situation 4. Determine the Centroid of the configuration of the steel sections below. Also determine…

A:

Q: Part 8

A: Data given Load P = 250 kN Modulus of Elasticity of Steel, Es = 200 ×106 kN/m2 Modulus of…

Q: The uniform beam has a mass of 48 kg per meter of length. Determine the reactions at the supports. A…

A: Given Data  Uniform beam has a mass of 48 kg/m  Find the support reaction in terms of Netwon(N).

Q: A column is supported on a footing as shown in the figure below. The water table is at a depth of 10…

A: Given- Water table at a depth of 10 m, Size of footing- 1.5 m × 3 m, Depth of footing Df=1 m, Unit…

Q: Which of the following is the equation of the deflection curve at segment AB? P kN/m В A 000 2 O…

A:

Q: H k, H, k, Н. H. k, Referring to the figure above, estimate the equivalent hydraulic conductivity…

A:

Q: Homework: (Column Strength Interaction Diagram ) Assume equal rebar at four sides Check if a column…

A:

Q: 6. A biodegradable fuel having a specific gravity of 0.95 and a viscosity of 0.04 grams per cen-…

A: Solution (6) Reynolds number of the biodegradable fuel is calculated by. Re =ρvDμv =Re ×μρD Where, ρ…

Q: The hydraulic conductivity, k of a soil is 7.15 x10-°cm/s at a temperature of 20° C. Determine its…

A:

Q: Q8 Which of the following requires an LRFD strength reduction factor of 0.9 for overall member…

A:

Q: Review Water flows at 25 ft³/s in the channel, which is originally 6 ft wide and then gradually…

A:

Q: A truss is shown.

A: Given -  P= 44 kips length of panel is  10 ft. each    Solution-  Sum of all vertical forces is 80…

Q: ∫sec3βtan3βdβ

A:

Q: 4. Determine the distance 'a' as a fraction of the beam's length 'L' for locating the roller support…

A: Given moment at B should be zero. I have considered the moment at B from right end side .

Q: A steel [E = 200 GPa ] rod with a circular cross section is 20 m long. Determine the minimum…

A:

Q: A Site requires 250,000 m3 of soil having a void ratio of 0.45, determine the required volume of…

A: Please refer the attached image for complete solution. THANK YOU.

Q: 11. What is the significance of the number of the sieves? To be precise, what does 200 mean in # 200…

A:

Q: Determine the moment of inertia with respect to the horizontal centroid of the figure. 250 38 300 25…

A: A section have been given and it has been asked to determine moment of inertia about horizontal…

Q: The force F has a magnitude of 710 N. Express F as a vector in terms of the unit vectors i and j.…

A:

Q: A survey of a closed traverse ABC shows the following latitudes and departures: Line AB latitude…

A:

Q: 2. A steel bar, whose cross section is 0.60 inch by 4.10 inches, was tested in tension. An axial…

A: Note :- as per our guidelines we are supposed to answer first three subparts only. Please repost…

Q: The hydraulic conductivity, k of a soil is 8.26 x10-°cm/s at a temperature of 20° C. Determine its…

A:

Q: 24 m^4

A:

Q: A pump is to deliver 150 gals per min. of water at a head of 120m. If pump efficiency is 72%. What…

A:

Q: SITUATION 4. For Items 10-11. | 60 kN 40 kN/m 120 kN • m |E im---1m-| 10. Find the maximum shear…

A: