Required information Experimental data for the density of n-pentane liquid for high pressures, at 50°C, are listed as follows 100 10230 20700 34310 Pressure, kPa Density, kg/m3 586.3 604.1 617.8 632.8 Evaluate pat 30 MPa. 0.08956 kg/m³

Q: The specific gravities of solids and carrier fluids of a slurry are usually known, but the specific…

A: Specific gravity is defined as the ratio of the density of solids in the slurry and the density of…

Q: Taking the coefficient of compressibility of water to be 2200 MPa, determine the pressure increase…

A:

Q: 2.48 A spherical soap bubble has an inside radius R, a film thickness t, and a surface tension o.…

A:

Q: Calculate the location of the center of pressure, Lp, to in m to the nearest 1000th. Fluid: Orange…

A: Concept: Center of Pressure The total pressure force acting on a fully submerged body is called the…

Q: The plastic block shown below measures I.5 m xl.S m x(.7 m and has a specific gravity of 0.38. The…

A: Given data: Note : in diagram height is given as 0.5 m is  but in question 1.5m is given assuming…

Q: After being filled to a depth d with SAE 30 oil (SG = 0.91), a glass is placed to float in a tank of…

A: Depth upto which SAE oil is filled in a glass to make it float on water = d , Specific Gravity og…

Q: 3. A differential manometer is attached to two tanks, as shown in figure. A) Calculate the…

A: The objective of the question is to calculate the difference in pressure between two chambers, the…

Q: The cyclindrical tank with hemispherical ends shown in the figure below contains a volatile liquid…

A: Reference : Fluid mechanics, Pressure analysis for Volatile liquid. We know that , Gage pressure is…

Q: Problem 13.84 The converging nozzle has an exit diameter of 0.25 m. The fuel-oxidizer mixture within…

A:

Q: An upright conical tank contains a liquid to a height of 0.85 m. the liquid was found out to weight…

A: We knowWeight=ρliqVolumeγliq=Slρwso,V=π0.2820.85m=0.209355m3

Unit Conversion

Standard units are also called SI units. SI units are used for measuring a physical quantity satisfying certain conditions. There are two types of units: fundamental units and derived units. Fundamental units are physical quantities that are independent, that is, they do not depend on other quantities like mass, length, or time. There are plenty of quantities in our lives which need to be measured and compared. Measuring is the comparison of a particular physical quantity with its reference value. A unit is a measure of a fixed physical quantity. A physical quantity is the product of a unit and the numerical value we need to compare with.