Can you draw me a half size breadboard circuit with a 9V source, a multimeter, 220ohm resistor in series and a 1N914 forward biased diode? Im reading about 9.8mA and others are reading 35.02mA. Can you tell me what about it should read for current and voltage? The simulation has two multimeters but we only use one for the live experiment. I feel like Im getting low current reading so I may have it wired wrong.

Can you draw me a half size breadboard circuit with a 9V source, a multimeter, 220ohm resistor in series and a 1N914 forward biased diode? Im reading about 9.8mA and others are reading 35.02mA. Can you tell me what about it should read for current and voltage? The simulation has two multimeters but we only use one for the live experiment. I feel like Im getting low current reading so I may have it wired wrong.

Electric Motor Control

10th Edition

ISBN:9781133702818

Author:Herman

Publisher:Herman

Chapter59: Motor Startup And Troubleshooting Basics

Section: Chapter Questions

Problem 12SQ: How is a solid-state diode tested? Explain.

See similar textbooks

Similar questions

How is a solid-state diode tested? Explain.
What is the difference between a diode and rectifier?
Diodes and rectifiers allow current to _________. flow in one direction only flow in both directions divide paths of flow none of the above
Find the current I if both diodes are identical. Voltage V = 0.8V and let the reverse saturation current be 10-⁹A. D1 D2
Determine the minimum and the maximum input voltages that can be regulated by the Zener diode shown in figure 5. From data sheet the Zener diode has the following values: Vz=9.5 V at IZ1=65 mA, IzK =5.5 mA, PDmaxN)=1.25 W, and Z, = 15 N . R Vout 650 Q Vin 4 Vz Figure 5
If one of the diodes in the figure below is open, the average voltage across the load is:(a) increases (b) decreases (c) does not change
Draw the input waveform and output waveform for the circuit given below with proper values marked in the figure. Assume D1 as silicon and D2 as germanium diodes. Input Vpp=20V, V1=3 V and V2=8 V. R www D2 DI Vin Vout V2 Maximum voltage of output waveform Minimum voltage of output waveform
3
Q2: Draw the output waveform for the three shown circuits. 1- +10V 1O kf V. 0- 5V 5V -10V Diodes are IN914. 2- Assume Vm=20v, show the Vdc on the graph D Ds 3- Assume Vm=18V and V-5V.
Diode circuitsFor each circuit below, use the diode approximation with forward dropVF= 0.7 V to find the output voltage. No current flows to the output.
Assuming an ideal diode model for all the diodes in the circuit below, chose the correct state (bias) for each diode. 9kO IN1199C R2 01 18KO IN11990 D3 IN1199C R3 V2 12 V R4 5kQ
for the circuit shown below (when the diodes are ideal), the values of ID1, and ID2 ipi ip2 D2 Vpi V p2 500 Q V, = 5 V V2 = 3 V is E Vs=5 V