calculate the power (kW) delivered by the pump

Q: Find the discahrge through pipe having cross sectional area of 4 mm2 and velocity of flow is 3.31…

A: Given data : Velocity of flow V=3.31 m/s Cross sectional area A=4 mm2   To find : Discharge through…

Q: Piston Pum 0.12 m saline 0.3 m

A: The work done in a piston cylinder assembly can be determined using the formula given below as-…

Q: Problem 109. Show that the expressions v = rw and ar = ra hold for the motion of the center O of the…

A:

Q: Two reservoirs with top surfaces placed on the flat ground and connected with each other with a…

A: Write the given data with suitable variables. z1=10 mz2=30 mhf=40 m

Q: Compute the Cross sectional area of Pipe Discahrge=0.8 m3/s Velocity=2 m/s

A:

Q: The uniform concrete block in (Figure 1) has a weight of 300 lb. The coefficients of static friction…

A: iven Data:

Q: Compute the Cross sectional area of Pipe Discahrge=0.8 m3/s Velocity=2 m/s

A: Yygg

Q: As seen in Figure 3 below, the water from the tank 1 is pumped to the tank 2 with a flow rate of…

A:

Q: a pumping station working with a pump head of 25m. the output power of the motor for that pump is…

A:

Q: Flow Pump 6-in Schedule 40 4-in Schedule 40 4 in Engine Oil 30 in Mercury (sg =13.54)

A: Calculate the pressure change from point 1 to point 2. P1-ρoilg4 in-ρhgg30 in+ρoilg34…

Q: ● Compute the time needed for the cylinder position to retract from the maximum position 1m to…

A:

Q: Water is to be pumped through 1500 ft of pipe from the lower to upper reservoir at a rate of 4…

A: Given:Length of pipe, L=1500 ft =457.2 mVolume flow rate, Q=4 ft3/s =0.113267 m3/sdiameter, d=8 in…

Q: A hose pipe of 75 mm bore and length 450 m is supplied with water at 1.4 MPa. A nozzle at the outlet…

A:

Q: Saturated water at 310K is being pumped from a tank to an elevated tank at the rate of 7L/s. All of…

A: Given-Data:- To-Find:- Power (W)=?

Q: A damacana water pump with batteries will be designed. The pump is asked to fill a 200 ml glass of…

A: Volume of glass, V=200 ml = 0.2 Liter = 0.2*10-3 m3 Time required to fill the glass, T=3 s Pump…

Q: 1 J A pump is used to circulate a water from lower Tank to upper tank. The height difference between…

A: Given data: The height difference between the free surface is h=5 m The total head losses in the…

Q: Q2- A (0.14 m/s) oil has (density 880 kg/m & viscosity 0.026 pa.s) is pumping from first tank to…

A: Given: The flow rate is 0.14 m3/s. Density of the oil is 880 kg/m3. Viscosity is 0.026 pa.s Diameter…

Q: The centrifugal pump in the figure pumps the water at 25°C from the tank 1.22 m above its inlet…

A:

Q: e power required to drive t e pump.

A: Need to find the power required to drive the pump.

Q: onsider the hydropower schematic shown below with a lake of 70m elevation above a turbine house.…

A:

Q: Water at 15°C flows through a small pipe 5 mm in diameter. The average velocity is measured to be…

A:

Q: Calculate the Net Positive Suction Head (NPSH) for a pump handling 100,000 kg/hr flow of water…

A:

Q: (P. = 850 kg/m³, µ = 2.33 kg/ms, Patm = 101.325 KN/m²) oil 1 m = 13600 kg/m³) mercury Oil ball valve…

A: Given: The flow rate inside the tank, Q = 0.03 m^3/s The outside diameter of 4in scheduled 40 pipe,…

Q: The velocity of the liquid flowing through the rusty iron pipe having a 150 mm diameter is 2.5 m/s.…

A:

Q: Saturated water at 310K is being pumped from a tank to an elevated tank at the rate of 7L/s. All of…

A: The power required by the pump can be calculated using the formula given below- P=ρgQhm where, g is…

Q: 4. Determine the pressure required, in psi, in the pipe just ahead of the nozzle shown in the figure…

A: Given jet velocity v2= 75 fps diameter d1= 1 in  diameter d2 = 0.75 in

Q: Saturated water at 310K is being pumped from a tank to an elevated tank at the rate of 7L/s. All of…

A: Given  Rate of flow of water = 7L/s 5in schedule 40 steel pipe. 2 fittings of 90o ell standard long…

Q: Problem 4: Water is supplied at 150 ft³/s and 60 psig to a hydraulic turbine through a 3-ft inside…

A: The pressure at the inlet of the turbine is P1=60 psi. The pressure at the outlet of the turbine is…

Q: Problem 3 Water is issued steadily from a pipe to the air with a diffuser as shown below. Gravity…

A: From continuity equation, volume flow rate is,Here  is cross-sectional area of the long pipe,  is…

Q: A centrifugal pump is required to pump water to an open water tank situated 4 km away from the…

A:

Q: Calculate the minimal head of the pump required to pump 1 m³ of water per second to the height 10 m…

A: Minimum head is the suction head required in centrifugal pump which avoids cavitation in pump…

Q: A centrifugal pump works on 220 v power supply and draws 18.5 ampere by pumping water from 23 kPa at…

A: Fluid is a state of matter which deforms continuously on the application of force externally,…

Applied Fluid Mechanics

A fluid is a substance that is continuously deformed by the application of shear stress. The rate of deformation of a fluid depends on its viscosity. The fluid tries to flow when it interacts with some other system.