By calculating the osmolarity of each of the following solutions, which solutions can be used in intravenous administration? Note that the osmolality of blood is (Osml/L 0.3) 0.3 M glucose (¹ 0.15 M glucose ( 0.1 M NaCl ( 0.3 M NaCl ( I need the answer as soon 0.3 M MgCl₂ (

Q: The total hardness is always listed in parts-per-million (ppm) of CaCO3 (or mg CaCO3 / Kg H20).…

A: Volume of water sample = 25.00 mL Volume of EDTA required for end point =…

Q: A harmful chemical named TNF has been found to be in the regional environment in Reno. Environmental…

A: Based on the given data, it is identified that TNF is consumed through fish, water, air, and settled…

Q: B. Calculate the following information. USE THE FACTOR-LABEL METHOD TO DO YOUR CALCULATIONS!!! 1. A…

A: The density of a solution is calculated by the formula: Density=MassVolume   Note: Since you have…

Q: B. C. D. E. F. 10nM solution 5nM solution 2.5nM solution 1.25nM solution 0.6nM solution I

A: Solutions- To converted concentration in 1 ml total volume of each assay. we have to consider…

Q: Open Sans 12 BIUA * 職 日 、 +] GO D bacterum can grow in the environment which has a laCK of…

A: 2. Arsenic and phosphorus are chemical analogues. They shows lot of similar behavior on chemical…

Q: what is 34 and 35 answers

A: 34) Given

Q: 28.9 nm to μm. could I get a step by step, please?

A: 1 nanometre = 0.001 micrometre  1 nm = 0.001 μm   By using this conversion factor we can convert the…

Q: Calculate the C1 V1- 0.5 L V2- 0.6 L C2-0.0836 M C1- ?

A: It is given that the initial volume (V1) is 0.5 L with a final volume (V2) of 0.6 L and a final…

Q: Why is important to add a spin bar, spin vane or boiling stones to a mixture to be heated? These…

A: Bumping of solution result in loss of solution.

Q: Please help with number 12 and this is not a graded.This is not a graded question as it is a…

A: We see that the reaction rate significantly increases when dissociation of iodine bond takes place…

Q: You are asked to perform an experiment to determine the density of square block below. In order to…

A: Concept: Density is defined as mass per unit volume. Density =massVolume

Q: What's the answer for the second picture?

A: The answer is as follows:

Q: Why is appropriate sampling important in relation to food?

A: Approach to solving the question:SamplingDetailed explanation:Appropriate sampling is crucial in…

Q: Imagine you have a solution that is comprised solely of component A. You have another solution that…

A: Paper chromatography is a widely used technique in analytical chemistry for separating and…

Q: AICI3 a) d)

A: Carbocation always have tendency to rearrangement.

Q: Hey,  do you think that the answer should be 187.65 or 187.7? Thankyou for your help!

A: Rules for determining the number of significant figures in an answer : The result of an addition or…

Q: Sea Surface Temp (°C) 10 20 32

A: Sea surface temperature (SST) (also known as ocean surface temperature) is the temperature of water…

Q: Part A 3.00 L of 0.500 M NaOH Express your answer with the appropriate units. HA Value Units m%3D…

A:

Q: MRI machines primarily work using ____. a. The nuclei of carbons in fatty acid chains b. The nuclei…

A: Magnetic resonance imaging (MRI) utilizes natural magnetic properties of the body for producing…

Q: ased on the given data, what is the λmax of cobalt?   0.1M Cobalt 300 0.451 325 0.467 350 0.584…

A: Given : We have to tell the lambda max for cobalt.

Q: 47. A small amount of resin weighing 4.56g occupies a height of a 10-ml graduated cylinder…

A: Since you have posted multiple questions, the answer for first question is given below. Kindly…

Q: COMUUZ 55610 170 160 150 140 130 120 110 100 90 C8H100 58466 Il C5H1002 59252 80 160 150 140 130 120…

A: DEPT Distortionless Enhancement in Polarization Transfer  DEPT is one of the important technique in…

Q: J L 23. A = 3.75 U A = 2.20 11.2 TMS 90 Hz & nom

A: We can determine the number of distinct hydrogens for the given compounds, by observing the chemical…

Q: What are in the distillate collected from the distillation?

A: (1) A receiver

Q: Answer and explain the 2 questions below. No copy-paste in google, please.  When is magnetic…

A:

Q: Q 25 please

A: Given:Molar mass of KMnO4 is 158.0g/mol.Volume of the solution is 3.00 liters.Molarity of the…

Q: 17. A stat chemistry test is requested. Which of the following tubes is recommended to use? O A.…

A:

Q: • Stock solution: 1000 mg/L Target sample concentrations: 50-400 mg/L • Create a 5-point standard…

A: Given that, The concentration of the stock solution is C1 = 1000 mg/L. The volume of the final…

Q: Discuss a basic laboratory technique and its importance.

A: Lab techniques are defined as the processes and practices that are recommended for equipment use in…

Q: 9/5(31)+32

A: Given,  9/5(31)+32

Q: M Review | Constants | Periodic Table MISSED THIS? Watch KCV 9.6, IWE 9.7; Read Section 9.6. You can…

A:

Q: The question prompt wants 2 answers

A: •As mentioned above one property is surface tension helps insect to stride on surface of water. •As…

Q: Please answer the question in the photo!!

A: To know the limiting reagent, the number of moles of product formed from each reactant should be…

Q: Instructions: Draw the structure of the each compound next to its matching spectrum. Mark peaks on…

A:

Q: a. How many hydrogen atoms are in the picture? Nitrogen? b. Does the formula indicate how many atoms…

A:

Q: Please let me know which 2 answers are correct, an explanation including evidence

A: Picture models of a solid, a liquid and a gas.

Q: An oil barrel at 4500 psi and 160 °F has been exposed to the standard conditions. a. Oil expand or…

A: We are given with tempreture and pressure.  Consider the standard tempreture and pressure.  And to…

Q: Plz answer

A: To answer this question, we need to follow these steps:List the Ingredients of Each Toothpaste:…

Q: From the data in Table 2.5, compute the concentration of the undiluted and diluted ovalbumin samples…

A: Given concentration Absorbance 0 0 0.125 0.075 0.25 0.139 0.5 0.244 1 0.486 1.5 0.699…

Q: Can you please type it out? It's hard to read

A: Galvanic cell reaction:  Zn(s)+ Cu(NO3)2(aq) → Zn (NO3)2(aq) + Cu(s) Since in given cell reaction,…

Q: nonmetal Lithium is a and sodium is a Lithium is in' group , and main group metal sodium is in group…

A: In this question we have to fill the blanks according to the options. And in the options we have…

Q: Draw the starting alkene that would lead to these major products under these conditions.

A: Alkenes are hydrogenated by the reaction with hydrogen in presence of finely divided nickel,…

Q: . What is the difference between temporary and permanent hardness?

A: Difference between temporary and permanent hardness :

Q: Absorbance 1.40 Beer's Law Plot 1.20 1.00 0.80 0.60 0.40 0.20 0.00 0 10 20 30 40 50 Concentration (M…

A: Step 1: Given the slope of the line = 80.23 and absorbance (a) = 0.5786 Step 2: We know that slope =…

Q: Which construction would you never use in the laboratory? (A) (B) (C) (D) (E) Construction D…

A: Different types of equipments are used in the laboratory such as beaker, flask, pipette, burette,…

Q: SECTION 1: KNOWLEDGE 1. In nature, silicon is composed of three isotopes. These isotopes (with their…

A: The average atomic mass of an element having a number of isotopes is calculated by the formula:…

Solutions

Solutions can be considered as homogeneous mixtures which contain two or more than two chemical substances. The chemical substance which is the greater part is defined as solvent. And the chemical substance that is dissolved in a solvent is referred to as solute. Solution chemistry plays an important role in chemistry since it supports many commercial applications of solutions.