Bugs Bunny (m=32 kg) starts at rest atop a h;=33 m tall hill, and then slides down. After that, Bugs:I.) slides into a swing set at the bottom of the hill, which has a R = 11 m long chain. He swings up and over the bar, with the chain managing to staytaut. (Labelled points A, B & C are at the bottom, side and top of the loop respectively.)II.) continues on flat ground, where he then hits a friction patch which is L=41.25 m long, from which he exits (at labelled point D) at speed vD =17.98 m/s.III.) slides off a cliff that is hp=17 m tall, into a lake.h,DRPart I: (around the swing set)a.) Sketch in the correct directions of all forces that act on Bugs at each of the points A-C.Note: At point A, Bugs has already lifted his feet off the ground.B f.) Examining parts d-e, which could have been done with the energy method? With older methods? With either? If both methods would work, re-dothe part with the other method (the one you did not already use) and show it gives the same result. If you cannot use both methods, explain why theother method doesn't work.Finally:g.) Elmer Fudd (unknown mass) wishes to repeat Bugs Bunny's feat. Assuming he starts from rest, what is the minimum height up the initial hill thathe must start, in order to successfully swing around the top of the swing set bar?Please express your answer as a number and as a multiple of the circle's radius.Elmer's minimum h; =m =

Answered: Image /qna-images/answer/edac7c2a-9f23-4c21-b850-47875a5a6a2a.jpg

Answered: Bugs Bunny (m=32 kg) starts at rest…

Similar questions

A ball of mass m is attached to a string of length L. It is being swung in a vertical circle with enough speed so that the string remains taut throughout the ball's motion. (Figure 1)Assume that the ball travels freely in this vertical circle with negligible loss of total mechanical energy. At the top and bottom of the vertical circle, the ball's speeds are vt and vb, and the corresponding tensions in the string are T⃗ t and T⃗ b. T⃗ t and T⃗ b have magnitudes Tt and Tb. Find Tb−Tt, the difference between the magnitude of the tension in the string at the bottom relative to that at the top of the circle. Express the difference in tension in terms of m and g. The quantities vt and vb should not appear in your final answer.
As depicted above, for my Hot Wheels cars to loop the loop I’ve decided to get the car moving using a compressed spring instead of letting it roll down the track from some initial height. The diameter of the loop is 9 inches and the mass, m, of the car is 40 g. a) If I use a spring with constant of k = 60 N/m, by what distance will I have to compress the spring so that the car successfully loops the loop? b) What initial speed will the car need to successfully loop the loop?
Plz do.it Correctly
A roller coaster has a circular loop with a diameter (height) of 39 meters. When the coaster is upside down at the top of the loop, what is the minimum speed it must be traveling so that the passengers do not fall out?
The ABC part of the road in the figure is frictionless, beyond C the friction coefficient is u = 0.5. A ball with m = 2 kg is thrown from point A with a speed of 3 m / s. How many meters will the ball travel from point C until it stops? 3m/s 1.2 m a) 3.24 m b) O 2.53 m C) O 2.82 m d) 4.14 m e) 1.24 m
2. For this series of 4 questions, a 1-lb ball is dropped from rest and falls a distance before striking the smooth plane at A. It bounces from the plane, and then strikes the plane again. You will be asked to solve for different things. Please pay attention: the numbers may change from problem to problem since they are randomized. 1) If the ball is dropped form rest at a height h = 5.2 ft, what is its speed right before it strikes the plane at A? Your answer must include 2 places after the decimal point. Take g = 32.2 ft/s². h A Your Answer: Answer B units
Two blocks are connected by a light string that passes over a frictionless pulley as in the figure below. The system is released from rest while m, is on the floor and m, is a distance h m1 above the floor. m1 h (a) Assuming m1> m2, find an expression for the speed of m, just as it reaches the floor. (Use any variable or symbol stated above along with the following as necessary: g.) V = (b) Taking m, = 6.9 kg, m, = 3.6 kg, and h = 3.7 m, evaluate your answer to part (a). m/s (c) Find the speed of each block when m, has fallen a distance of 1.0 m. m/s Neéd Heln?
Identify how many degrees of freedom there are in the following mechanical systems: (a) a dumbbell, (b) two components of a double star that revolve in the same plane, and (b) the Earth-Moon-Sun system.
A person picks up an iron ball on a rope and starts to spin it around them. The person does 500 J of work to get the mass spinning. While spinning, the person steps onto ice (take friction out of the equation). The result is both the mass and the person are spinning around the same point in space (the mass is circling faster on a larger radius and the man is circling slower on a smaller radius). There is a point between the masses that is stationary. The iron ball has a mass of m = 10 kg. The person has a mass of M = 80 kg. Vb Point that masses rotate around 3 M ор When the person lets go of the rope, how fast will the person move and how fast will the ball move?
In which of the following situations can we use a = v2/r? Select all correct Question 1 options: A ball on a string is at the right-most point of a vertical circular loop. A car is driving at a constant speed over the peak of a round hill. A ball on a string is at the bottom of a vertical circular loop. A car is driving up a constant slope A ball on a string is at the top of a vertical circular loop After we cut the string on a ball that was being spun in a circle.
In the Skycoaster amusement park ride, riders are suspended from a tower by a long cable. A second cable then lifts them until they reach the starting position indicated is shown. The lifting cable is then released, and the riders swing down the circular arc shown. If the four riders have a total mass of 270 kg, what are the tensions in the two cables just before release?
Don't use chat gpt It Chatgpt means downvote

SEE MORE QUESTIONS