Based on the following traffic speed frequency table, the median and 85th percentile speeds are approximately & .....* respectively. Speed class 30- <40 40- <50 50- <60 60- <70 70- <80 80- <90 90- <100 100- <110 (kph) Frequency 5 8 12 20 25 22 15 8

Based on the following traffic speed frequency table, the median and 85th percentile speeds are approximately & .....* respectively. Speed class 30- <40 40- <50 50- <60 60- <70 70- <80 80- <90 90- <100 100- <110 (kph) Frequency 5 8 12 20 25 22 15 8

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: On a two-lane intersection approach, following traffic queue data were observed. Clock Time Cycle #…

A: Hi there! since you have posted a question with multiple sub-parts, we will solve the first three…

Q: Estimate the probability that not more than or equal to 4 left turn vehicles will come in a cycle.…

A: Using binomial distribution, the probability of occurence of an event 'r' times out of 'n' times is…

Q: Determine minimum cycle length and LOS of North bound approach for che intersection shown below.…

Q: Traffic volume data has been collected for 10 min time intervals as shown below, Find the total…

A: Please find the attached images for the solution! Thank You!

Q: There are 2 routes connecting two cities. The total demand is 1000 veh/hr. The first route has…

Q: Distance: 12km Width: 45m wide (4 lane road) Maximum Speed Travel Time 80 mph (128 km/h) 00 hours 06…

A: Distance(L)=12 km Width of road=45 m (4 Lane road) Maximum speed(vmax)=128 km/hr Travel time(t)=6…

Q: An intersection has a three-phase signal with the movements allowed in each phase and corresponding…

Q: 2) Given the following data for five traffic analysis zones (TAZ): Zone Production Attraction 1 1…

Q: Based on the table below which represents 5-minutes stopped-time delay data at a specific…

Q: A given movement at signalized intersection receives 28-seconds green time, 3.5 seconds of yellow…

Q: A three-zone city has the following characteristics: Zone 1 Zone 2 Zone 3 Initial travel time…

Q: 11. If cars pass a certain point on a highway at a mean headway of 10 seconds, the vehicle flow rate…

Q: Q3- For the traffic signal data below; 1- Fill the table with Data. 2 - calculate optimum cycle…

A: Phases Yellow Time (sec) All Red time (sec) Lost time (s) Geff (sec) Green time (sec) Red time (sec)…

Q: Estimate the maximum number of cars in a single lane of traffic that would pass a check-point in one…

A: Average speed of car=50mph Spacing of vehicle is 1 car length per 10mph

Q: For a given control stations the following data are: (A) Typical hourly variation of traffic volume.…

A: Note: Hi! Thank you for the question As per the honour code, We’ll answer the first question since…

Q: The speed of the traffic flowing past EDSA between the hours of noon and 7:00pm is approxima…

Q: Traffic volumes on multilane highways O a. 15000 – 35000 veh/h. O b. 20000 – 40000 veh/h. O c. 15000…

A: Answer is option C 15000-40,000 veh/h The traffic volumes generally varies from 15,000 - 40,000…

Q: Compute the peak hour factor if the hourly volume of traffic is 1882 veh/hour and the highest 15-min…

Q: Based on the following traffic speed frequency table, the median and 85th percentile speeds are…

A: Given - speed - frequency Calculate - - the median -85th…

Q: The approaches of a 4-leg signalized intersection are configured with 1 NB lane, 1 SB lane, 1 EB…

A: Signalized intersections generally involve the following steps in design:- 1. Signal phasing 2. Lane…

Q: Question (1) Traffic Volume on a four lane freeway (two lanes in each direction) were counted…

A: a) The peak hour factor for each direction and each lane. Finding peak hour factor for lane 1 From…

Q: Problem 17.2W You are given the following design hourly volume (pc/h) of an intersection with 4…

Q: The factor reflecting the proportion of peak-hour traffic traveling in the peak direction is K-…

A: As per guidelines we need to answer only 1st question.

Q: TRANSPORTATION ENGINNERING-TRAFFIC SIGNALS An approach to a predetermined signal has 25 seconds of…

A: Given data:Cycle time = 60 sec.Effective green time = 25 sec.Approach volume = 500…

Q: Traffic at a certain intersection is 2076 cars per day. A consultant has told the city that traffic…

A: Given:Present traffic= 2076Rate of traffic growth = 4% per year Required:Traffic at the end of 7…

Q: An intersection has a three-phase signal with the movements allowed in each phase and corresponding…

A: Calculate minimum cycle length,Cmin?

Q: The following 10 vehicle speeds (in mi/h) were in measured on a roadway segment: 60, 65, 64, 71, 66,…

A: Using formula

Q: You are assigned to evaluate the level of service for a section of a that stretches along a level…

A: According to given data You are assigned to evaluate the level of service for a section of a…

Q: Traffic demand shown in the figure below uniformly arrives at an intersection. Determine the optimal…

A: Given:- The saturation flow rate of each approach for the first 40 sec = 2000 veh/hr The flow rate…

Q: Compute the peak hour factor if the hourly volume of traffic is 1969 veh/hour and the highest 15-min…

A: Given data, Hourly volume of traffic = 1969 veh/hr Peak 5 min volume = 737 vehicle To find out the…

Q: The uniform arrival and uniform service rates observed on an approach road to a signalized…

A: Given data- Normal flow qi=20 vehicles/min, Saturation flow Si=50 vehicles/min, Cycle length Co=60…

Q: vehicles in angles (0°,45°, and 90° degree) if the length of the curb -240 ft, then show the layouts…

A: Disclaimer; Since you have asked multiple question, we will solve the first question for you. If you…

Q: 1. The following data has been collected at a point along highway. Determine the Peak Hour Lane…

A: Tabulate the time interval and 5-min lane volume.Time interval5-min Lane volumeTime interval5-min…

Q: In order to determine the DHV from a traffic count worksheet, the first step is to: Group of…

A: The peak-hour factor (PHF), which can be applied to a specific location or a section of a street and…

Q: An intersection has a three-phase signal with the movements allowed in each phase and corresponding…

A: An intersection having 3 phase signal with all movements allowed in each phase and saturation flow…

Q: A freeway with flow rate ( VP) = 1600 %3D Pc/hr./In. and free flow speed = 55 mile/hr. the…

A: Given data: Flow Rate, Vp =1600 pc/hr/ln FFlow speed, S= 55 mi/hr

Q: Number of stations: Station spacing: Station dwell time: Minimum terminal time Maximum train speed:…

A: The given data in the question is: Line length: 30 km Number of stations: 16 Station spacing: 2 km…

Q: An intersection has a four-phase signal with the movements allowed in each phase and corresponding…

A: In the above given question there is given data about the saturation flow rates as a table. We have…

Q: Choose the right answer Volumes traffic can be expressed in terms of a-veh/hr,…

A: Volume is defined as the number of vehicles passing a given point in a certain interval of time.…

Q: :-A Section of route length of 60000cm, with average journey time 1.5min, average running speed 2100…

A: Route length = 60000cmAvg. Journey time = 1.5 minAvg. Running time = 1.9 min

Q: On a two-lane intersection approach, following traffic queue data were observed. Clock Time | Cycle…

A: Number of lane, N=2 Free flow speed, FFS=35 kmph Survey count interval, Is=20 sec Total vehicle in…

Q: Compute the peak hour factor if the hourly volume of traffic is 1829 veh/hour and the highest 15-min…

Q: The following figure shows the Level of Service (LOS) criteria for a multilane highway segment. If…

A: Solution: Given Data: Free flow speed, VS=45 mph Flow rate, S=1800 passenger cars per hour per lane…

Question

Based on the following traffic speed frequency
table, the median and 85th percentile speeds are
approximately
&
respectively.
Speed class
(kph)
30- <40
40- <50
50- <60
60- <70
70- <80
80- <90
90- <100
100- <110
Frequency
8
12
20
25
22
15
8
a
none

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

25 The table below shows the design flow rate and saturation flow rate for a major intersection on a highway. Using the Webster method, determine the optimum cycle length for the intersection and also determine the green time for each phase. Design Flow Rate (pcu/hr) Through Phase Saturation Flow Rate (pcu/hr) Intergreen period (sec) Left Through Left A 976 234 3700 1615 3.5 676 135 3700 1615 3.5 194 26 3700 1615 3.5 322 371 3700 1615 3.5
19 Compute the peak hour factor if the hourly volume of traffic is 1964 veh/hour and the highest 15-min volume is 722. Round off to two decimal places.
Transportation Engineering Determine the median speed, the modal speed
Please estimate the minimum cycle length and the green intervals for the following signalized intersection (Figure 7). Please note that the minimum cycle length will be influenced by the design of the phasing diagram. The arrival flow, in pcu/h, for each direction, is illustrated in Figure 7. Please assume any missing values. Lost time following each phase = 2 sec, Amber = 3 sec, Red all = 1 sec, saturation flow 1400 pcu/h. 196, 367, 170 JIL! 400, 140, 215 716 120, 417, 232 400, 433, 184 Figure 7. Intersection Layout and Traffic Flow Data
Determine the traffic flow if 100 cars pass a known location during 10 s.
A rail transit system has prescribed the following factors:1. Peak hour demand = 30000 passengers/hr2. Minimum required speed = 55 ft/sec3. Deceleration = 3 ft/sec24. Safety factor = 1.455. Vehicle length = 80 ft6. Allowable vehicle capacity = 150 pass/veh7. Guideway utilization factor = 0.838. Minimum headway = 110 secHow many cars should the train consist of to provide adequate passenger capacity?
Observers stationed at two sections XX and YY, 1000 ft apart on a highway, record the arrival times of four vehicles as shown in the table below. Vehicle Section XX Section YY A T0 T0 + 14.33 sec B T0 + 3.76 sec T0 + 18.14 sec C T0 + 7.94 sec T0 + 22.06 sec D T0 + 12.13 sec T0 + 27.87 sec If the total time of observation at XX was 20 sec, determine (a) the time mean speed, (b) the space mean speed, (c) the flow at section XX, and (d) the density on the highway
An intersection has a three-phase signal with the movements allowed in each phase and corresponding analysis and saturation flow rates shown in the table below. Assume the lost time is 4 seconds per phase and a critical intersection v/c of 0.90 is desired. Phase 3 Allowed movements NB L, SB L NB T/R, SB T/R EB L, WB L EB T/R, WB T/R Analysis flow rate 330, 365 veh/h 1125, 1075 veh/h 110, 80 veh/h 250, 285 veh/h Saturation flow rate 1700, 1750 veh/h 3400, 3300 veh/h 650, 600 veh/h 1750, 1800 veh/h Using v/c equalization ratio, calculate the effective green time for phase 1 O 15.954 sec O 12.105 sec O 14.127 sec O 13.190 sec
Please solve this question. Subject: Transportation engineering . Problem No.5 For the speed data in the table below, find the mean speed and the Standard Devaition of speed. Also find the 85th percentile, the 15th percentile and the median (50th percentile) speed from the cumulative frequency curve. Also find the Pace and Mode.