b) Design a box culvert for the given data: Q = 43.8 m³/sec; length of culvert (L) = 50 m; Ke = 0.3; Ko= 0.6; n = 0.015; operating head (HL) = 0.4 m. If the inlet height of the culvert does not exceed 3 m.

Q: A circular culvert of 1.532 m diameter, flow Q = 2.32 m3 / s, depth 1 m and n = 0.014, calculate the…

A: Discharge (Q) = 2.32 m3/sDiameter of culvert (d) = 1.532 mDepth of water (y) = 1 m n = 0.014To…

Q: 6. Find the normal depth for a discharge of 125 cfs in a trapezoidal channel with a bottom width of…

A: Given data  Bottom widht (B) = 3 ft  Side slope = (1:m) = (1 : 2 ) Bed slope (So) = 1% = 0.01…

Q: A municipal WWTP receives 20,000m3/d of flow. They use two circular primary clarifiers operate in…

A:

Q: Design a canal culvert 200 meters long to pass a normal full supply discharge of 5 m3/s with 0.3 m…

A:

Q: ta triple concrete box culvert 1.5 m by 3.7 m (n=0.012) conveying a discharge of 46m3/s operates…

A: Culvert dimensions: 1.5 m x 3.7 m n = 0.012 Discharge, Q = 46 m3/s Length, L = 32 m Slope = 0.75%…

Q: Using the parameters for flow given below, determine the dimensions of a suitable chute to lower the…

A: To determine the dimensions of a suitable chute to lower the upstream and downstream water levels by…

Q: A square culvert is connected to the outlet point of the natural flow path for the 50yr return…

A: Given:  Design discharge Q= 3.6 m3/s Culvert length = 25 m  Slope S = 0.003  Darcy friction…

Q: A rectangular channel (b = 9 feet) crosses beneath a roadway inside a 70-inch RCP culvert with a C =…

A: Width of rectangular channel,  Diameter of Culvert,  Design Flow rate,  Standard Length of 70-in RCP…

Q: Triangular or “V” shaped channel with the sides inclined at an angle, θ = 60O from the horizontal…

A: Objective: To determine the hydraulic radius of the triangular channel.   Given: Depth of water in…

Q: A concrete lined channel is to be constructed. For concrete in this case take Manning’s n to be…

A: Given Discherge Q=8.5 m3/secmanning co efficient n=0.014 side slope S=1450velocity by…

Q: 3. A culvert with a headwall is to be laid through a road embankment at the natural stream slope of…

A: Given data:-  Length of the culvert, L = 100 m Natural steam slope, S = 0.004  Width, w = 1500 mm…

Q: 1. Determine the discharge rate through three parallel corrugated metal pipe culverts shown in the…

A: The invert elevation of the culvert at the outlet is ft  and the crown elevation at the outlet is…

Highway Drainage

Highway drainage is the process of extracting and regulating the excess surface water on the pavement by giving the desired slope. The construction of a highway drain helps to divert the water present on the surface, and sub-grade by the means of slope. Highway drainage systems are a necessary part of smooth functioning of traffic, since the highway drainage systems provide proper disposal of unwanted substances from the highways.