3. A rectangular box culvert has a 90º headwall with 33.7º bevels, and the inlet is mitered. The width of the culvert is b = 4 ft and the height is d=5 ft. The culvert is 100 m long with a slope of S = 0.01. Prepare a plot of HW versus Q for this culvert if it is to operate under inlet control.

Q: ngular channel 3 m wide and 1 m  deep, the value of Bazin's constant is 1.75 for earthen channel in…

A:

Q: A circular culvert of 1.532 m diameter, flow Q = 2.32 m3 / s, depth 1 m and n = 0.014, calculate the…

A: Discharge (Q) = 2.32 m3/sDiameter of culvert (d) = 1.532 mDepth of water (y) = 1 m n = 0.014To…

Q: 6. Find the normal depth for a discharge of 125 cfs in a trapezoidal channel with a bottom width of…

A: Given data  Bottom widht (B) = 3 ft  Side slope = (1:m) = (1 : 2 ) Bed slope (So) = 1% = 0.01…

Q: Q1: A box culvert of (3×3)ft designed to accommodate 135 ft³/sec. the culvert length and slope are…

A: Given, Q = 135 cfs L = 100 ft  S = 2.5% TW = 5 ft

Q: )A 3 foot diameter culvert has a free discharge and steep slope. The entrance loss coefficient is K.…

A: step1-

Q: rm flow occurs in a 4.4m diameter circular concrete culvert, but ding on the weather (due to…

A: We knowθ=cos-1(1-yr)θ=cos-1(1-3.54.42)θ=126.22°Area…

Q: An unlined canal under regime conditions along with a silt factor of 1 has a width c flow 71.25 m.…

A:

Q: Using the parameters for flow given below, determine the dimensions of a suitable chute to lower the…

A: To determine the dimensions of a suitable chute to lower the upstream and downstream water levels by…

Q: uniform flow occurs in a 4.3m diameter circular concrete culvert, but the depth changes depending on…

A:

Q: A box culvert with two sections is to be constructed under the road. Find the discharge of square…

A:

Q: bot can't answer it right.

A: The objective of the question is to calculate the hydraulic radius, mean velocity of the flow, and…

Q: a total discharge (4.5 cumecs), if the length of each one is 20 m at slope 1/ K1=0.5, K2= 1, n=…

A: Discharge on each culvert is Q=4.52=2.25m3sv=QAR=AP=π4D2πD=D4

Q: A flownet below a dam consists of 24 equipotential drops and 7 flow channels. The difference between…

A: Given - Equipotential drops ,Nd  =24 no.of flow channels, Nf = 7 Water level, H = 6 m Specific…

Q: 1. An unsymmetrical trapezoidal channel with one side vertical and the other inclined from…

A:

Q: 4497) Determine tha force in bars BD, CD, and DE of the nacelle trus showa in Fig. P427. 600 b 1200…

A:

Q: discharge = 2.40 m^3/sec velocity = 1.5 m/sec   Given that the rectangular-shaped timber flume…

A:

Q: A rectangular open channel has a width of 5 m and a bed slope of 0.001. For a uniform flow of depth…

A: Given- Width B=5 mBed slope S=0.001Depth y=2 mVelocity V=2 m/sIt is needed to find the Manning's…

Q: Q. M The hydraulic radius (m) for a circular pipe of diameter (D) behaving as open channel is given…

A:

Q: A a B V P b X h

A:

Q: H.W.1: A concrete pipe culvert is to be constructed under road to carry a maximum discharge 9 m3…

A: When a pipe is fixed in an excavated trench to move water away called a pipe culvert. It is the most…

Q: in a border irrigation run, Q= 8 l/s, n= 0.15, and %3D S=0.45%. The water depth at the inlet can be…

A:

Q: discharge = 6.5 m^3/sec   Considering the best hydraulic cross-section, what is the critical depth…

A: Given- Discharge = 6.5 m3 /sec Best hydraulic cross section   Top width (T) = 2z ( side length)…

Q: A rectangular channel (b = 9 feet) crosses beneath a roadway inside a 70-inch RCP culvert with a C =…

A: Width of rectangular channel,  Diameter of Culvert,  Design Flow rate,  Standard Length of 70-in RCP…

Q: in a border irrigation run, Q= 10 1/s, n= 0.2, and S=0.41%. The water depth at the inlet can be…

A: The water depth at inlet can be calculated using the following formula: Y0=(Q×n60×S0.5)0.6 Where, Q…

Q: flow is 2m. If the same material has been used for a trapezoida having the same wetted perimeter,…

A:

Q: Q3: A box culvert (1mx1m) with Headwater, H=1.15 and built on steep slope equal to 0.008. Identify…

A: n = 0.013 Ke= 0.5 So= 0.008 TW = 0.45 HW = 1.15

Q: .Hydraulic jump occurs in a 4 m wide rectangular channel. Discharge in channel 7.5 m^3 /s, hydraulic…

A: Given data: Width of the channel (b) = 4m Discharge through the channel (Q) = 7.5 m3/s Depth of…

Q: 1. Uniform flow occurs in a rectangular channel 3.05 m and 1.52m. deep. Compute the mean shear…

A: Given data Width of channel (B) = 3.05m  Uniform depth of flow (y) = 1.52m  Bed slope of channel (S)…

Q: ▪ An unlined canal under regime conditions along with a silt factor of 1 has a width o flow 71.25 m.…

A:

Q: estion 3 Determine the magnitude of the maximum bending moment in member AB of the frame loaded as…

A:

Q: b) Design a box culvert for the given data: Q = 43.8 m³/sec; length of culvert (L) = 50 m; Ke = 0.3;…

A:

Q: 5. A radial flow circular sedimentation tank 22 m diameter treating 10,000 m%d of water has an…

A:

Q: Determine the discharge through a right angled triangular section for a normal depth of 3.7 ft;…

A:

Q: 3. A culvert with a headwall is to be laid through a road embankment at the natural stream slope of…

A: Given data:-  Length of the culvert, L = 100 m Natural steam slope, S = 0.004  Width, w = 1500 mm…

Q: 1. Determine the discharge rate through three parallel corrugated metal pipe culverts shown in the…

A: The invert elevation of the culvert at the outlet is ft  and the crown elevation at the outlet is…

Q: The concrete pipes culvert (n = 0.012) must carry the flow from open channel half square section 4m…

A:

Q: gular Weir, L = 5.55 m., Cd = 0.996 1.816 c. 44.303 3.683 d. 44.033 ular Weir, 0 = 66°, Cd = 0.904…

A:

Q: cular concrete culvert, but the depth changes depending on the weather (due to storms). The Manning…

A: We knowθ=cos-1(1-yr)θ=cos-1(1-3.54.12)θ=135.017°Area…

Q: A trapezoidal notch having bottom width of 1.0 m is installed in a 2.0 m X 2.0 m rectangular…

A: Using relation for trapezoidal notchQ=cd2gH32[23B+815Htanθ]cd=0.64H=depth=1.5mTop width=2mBottom…

Q: Design a canal culvert 45 metres long to pass a normal full supply discharge of 5 m3/s with 0.lm…

A: Solution: Given Data: Length of culvert=45 m=147 ftQ=5 m3/s=176 cfsK1=0.1 mAssuming a flow velocity…

Q: The channel consists of a smooth cement section (m = 0.109) and overflow regions on each side that…

A: Given: The value of m in the cement section is 0.109. The value of m in a light brush is 1.54. The…

Q: 2. Designing an open channel_to convey the water to the two downstream communities where, the level…

A: given data:- Q= discharge =8.5m3/s bed slope=0.001m/m side slop 2 for concrete  linned channel…

Highway Drainage

Highway drainage is the process of extracting and regulating the excess surface water on the pavement by giving the desired slope. The construction of a highway drain helps to divert the water present on the surface, and sub-grade by the means of slope. Highway drainage systems are a necessary part of smooth functioning of traffic, since the highway drainage systems provide proper disposal of unwanted substances from the highways.