B-Correct the wrong sentences: 1. A heat engine is a system operating in a complete cycle and supply heat from work input. 2. Enthalpy refers to degree of disorder or randomness in the system. 3. The thermal efficiency for Otto cycle depends on the pressure ratio and temperatures. 4. In dual combustion cycle, the heat supply at constant pressure only. 5. Since entropy is a property, therefore the change of entropy depends on the process itself.

B-Correct the wrong sentences: 1. A heat engine is a system operating in a complete cycle and supply heat from work input. 2. Enthalpy refers to degree of disorder or randomness in the system. 3. The thermal efficiency for Otto cycle depends on the pressure ratio and temperatures. 4. In dual combustion cycle, the heat supply at constant pressure only. 5. Since entropy is a property, therefore the change of entropy depends on the process itself.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Steam enters the turbine of a vapor power plant at 600 lbf/in.², 700°F and exits as a two-phase liquid-vapor mixture at 100°F. Condensate exits the condenser at 95°F and is pumped to 600 lbf/in.2 The turbine and pump isentropic efficiencies are 90 and 80%, respectively. The net power developed is 1 MW. Determine: (a) the percent steam quality at the turbine exit. (b) the percent thermal efficiency. (c) the steam mass flow rate, in lb/h.
11.5 thermodynamics
Mechanical EngineeringThermodynamicsTopic: Brayton Cycles
4
1
answer 89
Thermodynamics: - Clear writing please!!! Thank you - Sketch and label all numbers on the turbine. - Sketch and label all numbers on the process on a T-s diagram. 7.133E A large condenser in a steam power plant dumps 15 000 Btu/s by condensing saturated water vapor at 115 F with an ambient temperature of 77 F. What is the entropy generation rate?
Determine:(a) the cutoff ratio.(b) the heat addition per unit mass, in kJ/kg.(c) the net work per unit mass, in kJ/kg.(d) the percent thermal efficiency.
(b) Consider a steam power plant operating on an ideal Rankine cycle. This steam power cycle can achieve a cycle thermal efficiency of at least 25 percent. i) Decide about the systems' components, working temperature and pressure of this power plant. ii) Illustrate system schematic and T-s diagrams with completely labelled on the systems' components, working temperature and pressure. iii) Evaluate the compatibility between proposed parameters and thermal efficiency of the plant.
At steady state, a power cycle develops a net power output of 20kW while receiving energy by heat transfer at a rate of 20kJ per cycle of operation from a source at a temperature T. The cycle rejects energy by heat transfer to cooling water at a lower temperature of 5mm K. If there are Inn (engine thermodynamic) cycles per minute, what is the minimum theoretical value for T, in K? mm=04, nn=54 www
Exercise 7.1 Compression and expansion of an ideal gas 50 mol/s of an ideal gas at 300 K and 1 bar (flow 1) is compressed to 10 bar (flow 2). The compression takes place adiabatically, the adiabatic efficiency is 80%. Stream 2 is expanded in a valve down to 1 bar (stream 3) and then cooled to 300 K (stream 4). A constant heat capacity Cp= 30 J/mol*K is assumed. a) Make a table showing temperature, pressure, enthalpy [J/mol] and entropy [J/mol*K] for the four streams. Choose 298 K and 1 bar as the reference state. b)Calculate added heat and work [J] in the process. c)Calculate the total entropy increase [J/mol*K] for each of the three process steps (compression, pressure relaxation and cooling) (ie the entropy change in the process plus the ambient; the ambient is assumed to be at 1 bar and 289 K).
Support your selected answer with the mass, energy, entropy or exergy equations, the ideal gas equation or other equations used in class. a) Two identical boilers are operating side by side, producing the same amount of heat. One boiler produces a flame temperature equal to 2000K while the other produces a flame temp equal to 700K. Which boiler has the potential to produce more useful work? a. Boiler with 2000K flame temp b. Boiler with 700K flame temp c. It is the same since both boilers are identical and have same heat output d. Need more information to determine b) A rigid tank contains 4 mol CO₂ and 1 mol N₂ at a total pressure of 2atm. N₂ is removed completely through a membrane that allows only N₂ to permeate. What happens to the partial pressure of CO₂ if all CO₂ remains in the tank? Assume ideal gases and an isothermal process. membrane a. CO2 pressure decreases b. CO₂ pressure increases c. CO₂ pressure stays the same d. need more information to determine CO₂ + N₂