(b) A separately excited DC motors supplied from the convertor is shown in Figure Q2b. The converter has the following parameters: input voltage Va = 12 V, duty cycle D = 0.6, filter inductance = 50 µH, capacitance = 200 µF, the switching frequency = 40 kHz, load resistance = 102and ignore load inductance. Calculate: (i) The output voltage. (ii) The average, max, min inductor current. (iii) The output voltage ripple.

(b) A separately excited DC motors supplied from the convertor is shown in Figure Q2b. The converter has the following parameters: input voltage Va = 12 V, duty cycle D = 0.6, filter inductance = 50 µH, capacitance = 200 µF, the switching frequency = 40 kHz, load resistance = 102and ignore load inductance. Calculate: (i) The output voltage. (ii) The average, max, min inductor current. (iii) The output voltage ripple.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

A DC-DC converter shown below is being utilized for keeping a constant voltage in order to distribute electricity under any environmental condition. The output voltage is kept constant at 28 V while the input source voltage varies between 24 and 32 volt. The variation in the output load current is between 7 A to 10 A. Design the value of CCM inductance if the converter switching frequency is 11 kHz. SWI SW2
2. Given the circuit a. State how each switch can be realized using transistors and/or diodes, and whether the realization requires single-quadrant, current/voltage bi-directional two quadrant switch or four quadrant switches then redraw the circuit. b. Solve the converter to determine the inductor currents, capacitor voltages and conversion ratio. Ignore all losses.
c) A buck converter with constant frequency peak current mode control has Vs = 28V, V = 20V, L = 301uH, fs = 100 kHz. Find the ramp slop for the optimum compensation and the peak compensation voltage. %3D
Can you solve the question step by step clearly ?
the way of working for boost dc-to-dc converter.
3. A three phase bridge rectifier is supplied by 380 Volt line voltage through a Star/delta connected transformer of which turns ratio is 1. The firing delay angle is a=30° and the load is resistive R=2.2 Ohm. Draw the circuit diagram and mark the followings on this figure : average values of output voltage, the currents and voltages of each transformer leg.
A load consists of XL=70 and XC=150 are connected in parallel across 120 Volt supply.The reactive power of the circuit is.......
Creating buck-boost converter diagram using the following: Voltage: 12V-5V The diagram includes voltage regulator.
need quick solution please
Design an insulated DC-DC converter. Give some detailed information about the topology yousuggested.
EX2: (Buck dc-dc converter. Evaluation of the output voltage ripple) A buck converter has the following specifications: Vin= dc input voltage =50 V, D = duty cycle=D0.4, L=400 µH, C=100 µF f,= switching frequency = 20 kHz, R=20 2 Assuming that the converter is ideal, calculate: a) The output voltage. b) The maximum and minimum inductor current values. c) The output voltage ripple.
Q2) A 3-phase, half-wave thyristor converter is connected through a voltage source 150 V as input voltage and used to supply resistive load of 10 2. Determine rsm voltage, rms current, ripple factor and dissipated power in the resistor R. If a = 45° and f = 50 Hz. %3D