2. A full wave rectifier is using a center tapped step down transformer. The input to the primary of the ransformer is 110 volts rms and the turns ratio of the transformer (N1:N2) is 5:1. Load resistance (RL) is 3,900 ohms. No capacitor is connected at the output of the rectifier. Determine the following. 1. RMS voltage at the whole secondary and rms voltage at ½ of secondary e. Average voltage at the whole secondary and average voltage at ½ of secondary . Peak voltage at the output of the rectifier (across RL)

Q: QUESTION 10 With reference to the instruction below, what will be the value of each of the bits in…

A: First we should select the correct option for given instructions Value of each bit in word B3:3 will…

Q: "Implement the yellow highlighted table using multiplexers considering the digits used above (88 72…

A: According to the question, for the given table as shown belowWe need to implement the yellow…

Q: Design the following function F using: AB CD 00 01 11 10 00 1 01 1 11 1 10 1 1 1.4:16 decoder block…

A:

Q: L-march or T-match matching box

A: An L-match or T-match is a type of impedance-matching network used in radio frequency (RF) circuits…

Q: A code 10110 need to be send to the receiver.Using Hamming code find out the code word and the…

A:

Q: I need the correct answer, not the explanation

A: Step 1:I have explained the answers in detailed manner below. Step 2:

Q: 3. Using Mason's Rule, find the transfer function T(s) = for the system represented in the fugre.…

A: Signal flow graphwe have to find Transfer function

Q: how did you find Rth?

A:

Q: 6. A digital signal is sent using a Hamming code for error detection and correction. The signal…

A: The parity code is checked as shown below.

Q: Assume that carry flag is 1 at the beginning, and execute the following code: mov al, OE8H rcl al, 1…

A:

Q: Question 15 Covert (521) from base 8 to base 11

A:

Q: 10. An analog system is one in which processed data is in analog form only.

A: we need to find in analog system  processed data is in analog form only.this statement is true or…

Q: Can I get a version of this that can be read?  Maybe a space between equations could help.  Better…

A: It is given that:

Q: Which is easier to use a bnc connector or sma connector

A: BNC are bigger and easier and faster to handle. SMA are quite a bit higher in frequency capability…

Q: QUESTION 10 With reference to the instruction below, what will be the value of each of the bits in…

A: The destination of the CLR (clear) instruction has a value of bits. All of the bits in the…

Q: The flags are located inside the.

A: The flags are located in the,

Methods of Wiring

Electrical wiring is the way of integrating cables and wires to interconnected equipment such as fuses, switches, sockets, lights, fans, and so on to the main distribution board, which is a specific structure attached to the utility pole that ensures a constant power supply.