At the bottom of an incline at 45° to the horizontal, a 0.170 kg box is forced against a spring with constant 1500 N/m until the spring has been compressed by 0.11 m. How far does the box move up the incline before coming to rest if a) the incline is frictionless? b) there is a coefficient of kinetic friction of 0.3?

At the bottom of an incline at 45° to the horizontal, a 0.170 kg box is forced against a spring with constant 1500 N/m until the spring has been compressed by 0.11 m. How far does the box move up the incline before coming to rest if a) the incline is frictionless? b) there is a coefficient of kinetic friction of 0.3?

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A box (m=7.02 kg) is placed on a horizontal surface with u=0.2. If a force of 5.9 N is pushing the box to the right but the box does not move. What is the magnitude of the static friction force ( in N) during the effect of the 5.9 N force? Select one: O A. 5.90 O B. 79.213 OC. 25 OD. 68.80 OE. 13.8 Next pag page
Mass 80 kg
According to the following figure, A) Make the free-body diagram including all the forces acting on you and the bicycle at the time of descent. Define each of them. B) Argue for which cases you have jobs equal to zero according to your free-body diagram from part (A)
4) This Atwood's machine includes two blocks connected by a cable, going over a pulley without slipping. Block 1 (30.0 kg) is connected to a spring (70.0 N/m), and slides on a horizontal surface with a coefficient of kinetic friction of 0.0100. Block 2 is 50.0 kg, and hangs vertically from the cable. The pulley is a disk with a radius of 0.500 m, and its moment of inertia about the center of mass is 10. 0 kg-m“. a) Draw the three free body diagrams, and write out Newton's 2nd Law for each. b) Derive the equation of motion (inhomogeneous 2nd order ODE) for this system. c) Use u-substitution to rewrite this as a homogeneous 2nd order ODE. d) Assume the position x as a function of time t is of the form x(t) = A cos (wt + p) I disk for undamped natural frequency w, phase angle P, and amplitude A. The initial conditions are: x(0) v(0) = -3. 00 m/s. Solve for the position of the mass as a function of time (you need to solve for w, 4, and A). = 2. 00 m and Mz
A sled of mass 500kg sits at rest on a rough slope that is inclined at 10* to the horizontal. The coefficient of friction between the slope and the sled is 0.3. The sled is held in place by a wire attached to a winch. The tension in the wire is TN. a) Find the maximum possible value of T. A load of mass mkg is added to the sled, and tension in the wire is increased to 5000N in order to pull the sled and load up the slop. Given that the sled and load are pulled a distance of 100m in 80seconds, b) Work out the value of m
Please don't provide hand written solution....
I need an answer with a free body-diagram. Show all work as quickly as possible. Question: A wooden plank of negligible mass and length L = 2.8 m is used to keep in balance, horizontally, a small cube of mass 20.0 kg when applying a force F of 80.0 N at one end of the board. The distance, in meters, between the support point of the board and the position where find the cube is: a) 0.56 b) 0.80 c) 1.00 d) 1.12 e) 1.40
You need to push a cupboard by applying a horizontal force F on its side. The cupboard width is L, height is H and mass is m. You are applying the force at a point that is a height h above the floor. The coefficient of kinetic friction between the dresser and the floor is u. The ground exerts upward normal forces of magnitudes Np and No at the two ends of the dresser. a) How much force do you need to apply for the cupboard to move with constant velocity? b) What are the magnitudes of normal forces Np and Na if the cupboard legs are separated by a distance L? c) What is the maximum height h where you can push the cupboard before it tips over? F H Pl Np N.
B5
Please give pertinent solutions
A crate of mass m = rough ramp at a constant speed v by a motor with a power input of Pm = 2 kW. The ramp is angled at 0 = 40° with respect to the horizontal, and the coefficient of friction between it and the crate is u = 0,5. Find the crate's speed v up the ramp if the motor is 60% efficient. Р.5) 50 kg is pulled up a %3D т
1. The small rocket engines used in model rockets are rated by the impulse they exert on the rocket. The graph below shows the force exerted by an engine during the 1.0 second from when it is ignited until when the fuel is completely bumed. a) What is the impulse of this rocket engine? F(N) 0.2 0.4 0.6 0.8 1.0 b) One of these engines is put horizontally on a frictionless cart of mass 780 g so that it will accelerate the cart. How fast will the cart be going after the engine has burned all of its fuel? The mass of the engine itself is small enough that we can ignore it.