As young chemical engineers you are responsible for preparing the preliminary design calculations for the pipeline of the last part of isopropyl alcohol production plant. In the plant, isopropyl alcohol is taken at a flow rate of 1730 kmol/h as the bottom product (ground level) of the purification column and is transported to final storage tank that is 310 m away from the column. The bottom of the column, which is the start point of the pipeline, is being operated at 25o C and 1.1 atm. The storage tank, which is the end point of the pipeline, is pressurized with nitrogen at 2 atm due to safety regulations. Also, the entrance point to the storage tank is 35 m above the ground level. Can you draw the form of this narrative ?

Q: The design fluid (typically water and antifreeze) flow rate through a solar hotwater heater system…

A: The flow rate of the fluid = 0.025 gpmft2or gallonsmin.ft2 Dimension of each solar panel = 4ft×8ft…

Q: The single vapors of the gas mixture containing air and CH4 are contacted with pure water in the…

A: Given  Mole of gas enter = 8 kgmol Mole of water enter = 4 kgmol  Pressure of CH4 in gas = 2×104 Pa…

Q: 1. In the benzene plant, the pressure drop at some point of a pipeline in which benzene is passing…

A: ρbenzene = 876 kg/m3 ρwater = 997 kg/m3 ρCCl4 = 1587 kg/m3 Water hight left side = 4 cm = 0.04 m…

Q: In the concentration of mango juice, a 250 kg/h raw juice enters the evaporator machine. In the…

A: Concentration of mango juice Raw juice flow rate=250kg/h After evaporation concentrate juice…

Q: In the biomass gasification process to improve Hz production performance, spherical particles of the…

A: The given question is a question of fluidization which involves application of minimum fluidization…

Q: 1. Consider a solution that contains albumin at a concentration of 54 g/L. This solution is fed…

A: Evaporation is the process of turning from a liquid into vapor. It occurs at any temperature with…

Q: A rotameter with float shape type "B" (see figure below) has a tube of 0.3 m long. The internal…

A:

Q: 2. Effluent from a wastewater treatment is discharged to a surface stream. The characteristics of…

A:

Q: (a) If wastewater leaves the plant at ṁ1 the treatment unit (i.e., ṁ5) and to the waste lagoon…

A: Given that: Waste water has Cr =5.15 % = 0.0515 Cr has to be removed = 95%= 0.95   Wastewater leaves…

Q: Substance A from the gas mixture A-B is pure in a packed column operated at 30 °C and 1 atm. will be…

A: Given data: Initial concentration of A in the gas stream = 8 % Final concentration of A in the gas…

Q: An evaporator is used to concentrate 100kg/h of 10.0% salt solution. The evaporator operates such…

A: An aqueous solution of salt is concentrated in a crystallizer.

Q: Using a continuous distillation column operating under atmospheric pressure, the alcohol-water…

A: Given that in a continuous distillation column, alcohol water mixture is distilled wherein the…

Q: two distillation columns in series,

A: There are two distillation columns in series. Three components are associated with the process…

Q: 250 Ibm/h contains a mixture of methanol and propanol feed to a distillation column.The composition…

A:

Q: A mixture of 10 wt% water and 90 wt% chloroform enters a gravity separator at the flow rate of 20…

A:

Q: If the tank is filled initially with 1000 kg of the inlet solution, how long after the outlet pump…

A:

Q: A stirring tank reactor is to be filled with an unknown liquid (density 1200 Kg/m , Viscosity: 0.06…

A: The power required for the pump to accomplish the given task is to be calculated.   Consider the…

Q: Fuel used as the main energy source for incineration contains M% of carbon. The amount of carbon…

A:

Q: A primary wastewater treatment uses centrifugation for dewatering of primary sedimentation sludge.…

A:

Q: A concern with plans for capture of CO 2 directly from ambient air (DAC), is the sheer volume of…

A: Given data:speed of fan,height of rectangular installation,thickness of rectangular…

Q: the result of extraction of hazelnut containing 25% fat by mass with pure ethyl ether in a…

A: Oil is to be extracted from the hazelnut with the help of pure solvent ethyl ether in a multistage…

Q: A wastewater treatment plant must disinfect its effluent before discharging the wastewater to a…

A: The length of the pipe required by the given wastewater plant for the disinfection process is to be…

Q: Using a packed column, ammonia is absorbed from air to water. The incoming gas contains 6% NH3 and…

A:

Q: A Pollution Control Officer is asked to design a system to drain the sugar central's wastewater.…

A: Given Details: for a Pipe, Flow rate through pipe, Q =171.5 kg/s Available head, h =4.57 m of H2O…

Q: A process to purify glycerine from 10% to 25% is composed of an extraction tower and a distillation…

A: The flow sheet of the process can be shown as below Let x, y be the flow rate of top and bottom…

Q: theoretical number of racks, the actual number of racks, and the location of the

A:

Q: to a mixer and also to make the temperature constant water (H20) will be added to the reactor.…

A: Introduction to concept The degrees of freedom of a system is the number of parameters of the system…

Q: 2. Calculate the value of the mass transfer coefficient and the flux for mass transfer from a sphere…

A:

Q: 8

A: To find the pressure drop across the catalyst bed in a fixed-bed catalytic reactor, you can use…

Q: In the aqueous phase, reactant A is fed to a batch reactor with an initial concentration of 1 mol /…

A:

Q: Malaysia has been known as one of the world's leading producers and exporters of palm oil products.…

A: POME(Palm oil mill effluent Treatment Plant): Treatment process of POME are: Ponding System or Land…

Q: Fuel used as the main energy source for incineration contains M% of carbon. The amount of carbon…

A:

Q: Fresh apple juice contains 71.2% water flowing at a mass flow rate of 210 kg/h. The fresh juice is…

A: Given: Juice contains 71.2 % water at 210 kg/h is concentrated in evaporator. 90 % of water entering…

Q: A container contains 600 kg solution which includes 6% sugar and it is stirred. Another solution…

A: Consider the container contains 600 kg of solution with 6% sugar. Another solution is added at 1000…

Q: A single effect evaporator is used to concentrate a dilute stream of sugar syrup containing 15%…

A: Concentration of solids entering the evaporator = 15 % Concentration of solids exiting the…

Q: A spent sulfuric acid solution is prepared for a pickling process in a mixer. The spent 3% sulfuric…

A: Given that The weight% of sulfuric acid in the spent stream 1 = 3% The weight% of sulfuric acid in…

Q: Bernoulli. Air flows from a large, pressurized tank at gage pressure, Pg.0 through a small pipe of…

A:

Q: A stirring tank reactor is to be filled with an unknown liquid (density 1200 Kg/m', Viscosity: 0.06…

A:

Q: 10. A container is separated into two halves by a membrane. Your lab partner assistant, Thurmond, is…

A: In an osmosis process, when a two solutions containing two different concentration  are separated by…

Q: An open storage tank initially contains 10 000 kg aqueous solution of a non-volatile organic…

A: The non-volatile compound is referred to as a substance that does not readily evaporate into gas…

Hazard Analysis and Design in Chemical Engineering

Hazard is the intrinsic property of a material or process which harms the people, buildings, or environment. Health, safety, hazard, risk assessment, loss prevention, and environmental consideration play an important role while designing a chemical processing plant. Hazard is often confused with risk. Risk measures the magnitude of loss and injury of likelihood incidents or the consequence and frequency of incidents.