As water is flowing from a water tower to someone house, water is flowing at a speed of 3 m/s in a pipe with diameter of 0.3 m. The pipe gradually increases to a diameter of 1.8 m and then gradually decreases to a diameter of 1.1  m. Draw neat sketch. i) what is the speed of the water when it reaches the pipe diameter  of 1.1 m? ii) what is the flow rate of water flowing through the pipe in lit/hr?

Q: A 150 mm diameter pipe carries 81.3 L/s of water. The pipe branches in to two pipes one is 50 mm in…

A:

Q: Suppose we have planned to design a hydraulic system.In this aspect, the pump selection is to be…

A: Given that , flow rateV˙ =3299.5 liters/ minute                =0.05499 m3/s minimum fluid…

Q: 4. A pipe has an initial radius of 30cm, which then changes to a radius of 10cm. The velocity of the…

A: Given data: r1=30 cmr2=10 mh=0.5 mv1=2 m/s Need to determine the pressure difference between the two…

Q: 5) Consider the flow in pipe in figure. If P₁ -AP/y. b) The flow direction is from 2 to 1 if AZ…

A:

Q: Find the total time of flight of a ball that is shot from 5 m and has a rim height of 10ft if you…

A: Given:

Q: Water flows through a 125 mm diameter pipe at a velocity of 7.5 m/sec. Find the mass flow rate in…

A:

Q: a) At what velocity does the water leave the pipe? b) What is the pressure near the pump?

A: For solution refer below images.

Q: Water flows through a in a constant diameter pipe shown below with the help of pump. What will…

A: It is required to determine effect on velocity

Q: Q1) Benzene with specific gravity of 0.8 flows through 200 mm diameter pipe at velocity of 5 m/s.…

A:

Q: nlet and throat diameters of a horizontal venturimeter are 280 mm and 100 mm respectively. The…

A: Given: Inlet diameter of venturimeter (D1)=280mm or 0.280mThroat diameter (D2)=100mm or 0.1mPressure…

Q: A wind turbine generates power by transferring the kinetic energy of the wind to rotational energy…

A: Given:Wind inlet velocity, V1=7 m/sWind exit velocity, V2=1.75 m/sBlade diameter of wind turbine,…

Q: A liquid flows through a pipe with a diameter of 15 cm at a velocity of 10 cm/s. If the diameter of…

A:

Q: a) A locomotive is travelling at 35 m/s up an incline of 0.006 radians when the engine cuts out. How…

A:

Q: A pipe has an initial radius of r1, which then changes to a radius of r2. The velocity of the water…

A: To Find : The pressure difference between the two parts of the pipe.The volume flow rate in the…

Q: A pipe transports 1962 N/s of water. The pipe tees into a 2"-diameter pipe and a 3"-diameter pipe.…

A: Given   Velocity, V = 82 ft/s Diameter, d = 2 in                   = 0.166 ft Find  Flow rate

Q: 3) A small rock is thrown vertically upward with a speed of 18# from the edge of the roof of a 30 –…

A: The rock is thrown upward with an initial speed v0,y=18m/sfrom the initial heighty0=30.0m. The…

Q: 1) The equation for finding the water head in an open channel flow is given below. is given. In this…

A: Given: The width of channel, B = 8 unit The flow rate, Q = 5 unit The height, H = 0 to 2 unit

Q: a) Speeds V1, V2, V3 b) The diameter of pipe 4, D4 c) The total volumetric flow in liters/ s, the…

A:

Q: Water flows through a circular pipe with a radius of 15 cm at a rate of 1.5m/s into a storage tank.…

A:

Q: Q1) A stationary nozzle produce a water jet and the jet strikes an axisymmetric plate as shown. The…

A: Given data

Q: choose the correct answer  Water flows horizontally from section 1 to section 2. If the area of…

A: According to continuity equation the mass in flow in a fixed region or control volume should be…

Q: Q= 200 L/s Z2 =10m 71 =5m Datum

A: Given Data Q=200 l/s=0.2 m3/s Z1=5 m Z2=10 m V2=4 m/s

Q: Water flows through a pipe as shown in Figure 1 at the rate of 80 L/s. If the pressure at Point 1 is…

A: Given that, Flow rate from the pipe, Q = 80 L/sec, Pressure at point 1, P1 = 180 kPa, Radius at…

Q: A car is traveling on a highway at 28 m/s. a) What is the pressure at the bottom of a car's gas…

A:

Q: 1. Fill in the missing spaces and determine the direction of from in Pipe D. C Pipe Flow (ft³/sec))…

A: Fill in the missing spaces and determine the direction of from in Pipe D.

Q: ne depth of the well in mete

A: We need to calculate the depth of well

Q: Given below are pipe lengths, sizes, and connections. All pipes have a friction factor of 0.020. If…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: Water flows from a large reservoir through a pipe system and into the atmosphere at the open end as…

A: As per honor code and answering guidelines I can answer first 3 subparts at a time. If you want…

Q: A pipe has a cross-sectional area of 16.5cm2 at point A, where the speed of the fluid (water) is 1.2…

A: Given: The cross-sectional area at point A is, AA=16.5 cm2. The speed of the fluid at A is, VA=1.2…

Q: Q1. a) In an adult, the aorta's radius is normally 1.5 cm and blood moves through it at the average…

A: Given:Arota Radius =1.5 cm Average Velocity=30 cm/s Capillary Vein radius =5×10-6m=5×10-4 cm  blood…

Q: Pipe in Parallel: Two pipes connect two reservoirs which a height difference of 10m. Pipe 1 has…

A:

Fluid Dynamics

The study of the flow of gases and liquids, usually in and around solid surfaces, is known as fluid dynamics in physics and engineering. Fluid dynamics, for example, can be used to evaluate the movement of air through an airplane wing or the surface of a vehicle. It can also be used in ship design to increase the speed at which ships pass through water.