m before the bend to 0.4 m after it. Water enters the bend at the rate of 0.5 m3/s with a pressure of 150 x 103N/m2. Assuming that there is no loss of energy. i) Determine pressure at the outlet, P2- ii) Calculate the magnitude and direction of the resultant force exerted on the

Q: Problem 3. A siphon, filled with water, is discharging that water. The discharge rate is 2.8 cfs. a)…

A: we have given

Q: 5) Consider the flow in pipe in figure. If P₁ -AP/y. b) The flow direction is from 2 to 1 if AZ…

A:

Q: As water is flowing from a water tower to someone house, water is flowing at a speed of 3 m/s in a…

A: Water velocity at 0.3 m diameter, V1=3 m/s Gradual increase in diameter, d2=1.8m Gradual decrease in…

Q: . From the following system determine: a) the pressure in A, B, C, D b) the speed in A, B, C D c)…

A:

Q: Figure 4.1 depicts a large reservoir of water. Water is released slowly from the reservoir, such…

A:

Q: A venture-meter is shown in Figure (1) carries water, find the flow rate if there are no losses…

A:

Q: QI/b) A pelton wheel is working under a head of 200 m and the rate of flow of water through the jet…

A: Given that, Head of pelton wheel, H=200 m,Flow rate of water through jet, Q=300 liters/sec,Mean…

Q: Diesel fuel with a specific gravity of 0.8, flows through the Venturi meter shown in figure below.…

A:

Q: r the system determine a) the flow rate in m°/s b) The pressure at point A, B, c) the speed at the…

A: Given:ZA=10 mZB=13 mZc=10 mZD=0dn=25 mmdp=50 mms=0.86 NOTE: According to Bartleyby's guidelines we…

Q: It is desired to refuel an airplane at the rate of 55.0 gal/min. The fuel line is a 3.0-inch hose…

A: Givendia of nozzle=dn=1.5inchdia of fuel base=3.0inch=dhrequired flow…

Q: a) At what velocity does the water leave the pipe? b) What is the pressure near the pump?

A: For solution refer below images.

Q: Q2/ Consider the following liquid level system shown below. The flow through the valve is related to…

A: Given Data:Find:Relationship between the head and time.

Q: I need the answer as soon as possible

A: Dear student,                     According to the guidelines I am allowed to answer only one…

Q: What would be the velocity of liquid (m/s) at radius of 8 cm? The rotation occurs around axis A-A,…

A:

Q: A jet of water of dia 10 cm strikes a flat plat normally with a velocity of 15 m/s The plate is…

A: Data given - v= 15 m/s d= 0.01 m u = 6m/s

Q: Find the wark done Farce = 2 N Displacement = 0.045m

A: Given data : Force=F Displacement=d   Required : Work done

Q: A Fluid flows at a velocity of 225 cm/s in a pipe with flow rate of 89.3 Litres/sec. then find…

A: Given data Velocity (v) = 225 cm/s = 2.25 m/s Flow rate (Q) = 89.3 lit/sec = 89.3 x 10-3 m3/s

Q: A horizontal Orifice meter is used to measure the flow rate of water through the piping system of 20…

A:

Q: Water at 83 L/sec is flowing inside a 6-inch schedule 40 nominal pipe. Determine the following. a)…

A: According to given information about the pipe which is 6- inch schedule 40 nominal pipe, Actual…

Q: b) Calculate the gage pressure at points A, B, C and D. Take air density as 1.21 kg/m. Open to…

A: For the given arrangement  the density of air = 1.21 kg/m3 To determine  gauge pressure at point A,…

Q: A compressor in a high performance car's turbocharger draws in air at 10 °C and atmospheric pressure…

A:

Q: For the siphon shown, use Bernoulli's equation to calculate the following. (Assume no friction or…

A: Here, the pressure asked are guage pressures. Dont take absolute pressure. The solution is provided…

Q: 4. FLUID FLOW 1. The figure below shows a water tank with piping system for a small manufacturing…

A: The data given is, Flow rate of water, Q = 40 L/s = 0.04 m3/s Viscosity,  = 0.08 Pa.s Water…

Q: A pipe that carries water, has section of radius r₁ = 12 cm; it is narrowed, so the section has…

A:

Q: A large pipe with a cross-sectional area of 1.00 sq m descends 5.00 m and narrows to 0.500 sq m,…

A:

Q: Water is stored in a pressurised container at a height Нт = 9 m. It then moves through a horizontal…

A:

Q: 1. volume flow rate of Benzene. 2. Mass flow rate of Benzene. 3. Weight flow rate of Benzene

A:

Q: Question 1: The diagram shows water leaving a tank through an inverted V-tube. y (D (All answers to…

A:

Q: Q1) Benzene with specific gravity of 0.8 flows through 200 mm diameter pipe at velocity of 5 m/s.…

A:

Q: In the figure below, Given: P (gage) = 2 atm A= 20 m B = 5 m P (atm) = 101.325 kPa What is the…

A: In the figure below, Given: P (gage) = 2 atm A = 20 m B=5m P (atm) = 101.325 kPa   To determine…

Q: oose the correct answer   3- when the flow is happened without change in its quantity or velocity…

A: Given Data⇒ Flow velocity time

Q: n the Picture above OBE locm /Bc = 2Scm Ehe Vtelve of nŋ or rotation cl dao rem Convert this vawe to…

A:

Q: resultant force vector acting on the body to be derived. Figure 2 shows a steady, uniform…

A: Impact of jets : Let us consider that we have one pipe through which liquid is flowing under…

Q: In car service station water flows through a vertical pipe reduced from a pipe of diameter D to…

A: The schematic diagram of pipe is as follows:

Q: 4. Friction factor (f) inside the pipeline plays a major role for the selection of the pump power.…

A:

Q: If the velocity of water is 8 m/s and the pressure is 140 kPa on the discharge side of a pump. a.…

A:

Q: 4. A2 ft x 2 ft x 1.5 ft high tank is one third full of water when water at 20 °C is supplied to…

A: Given : Volume V  = 2*2*1.5 = 6 ft³ mass in  = min = 3 kg/s mass out = mout = 80 kg/min = 80/60 =…

Q: A certain liquid (SG = 12) flows through a 401-mm diameter pipe at a velocity of 6.5 m/s. Find the…

A:

Q: As seen in the figure, the vacuum pump provides air flow in an insulated pipe with a cross section…

A: Given data, Calculating Mach Number at section using the given relationship: - Hence, the Mach…

Q: If the velocity of a liquid is 1.65 ft/s in a 12-inch diameter pipe  What is the speed of a 3-inch…

A: The initial velocity v1=1.65 ft/s The initial diameter d1=12 in The final diameter d2=3 in

Q: ! A B C D =150 mm 4-50 mm 1,5 m 3,6 m 2,4 m

A: given; vertical distance from point C to B (h1)=1.5mvertical distance from point C to D…

Q: possible methods. В A 4m 8m 4m 4m 600KN

A: To find magnitude of vertical and horizontal forces on each joint

Q: Water enters a fountain through a pipe with a cross-sectional area A1 at a flow rate Q. The pressure…

A: Given:

Fluid Dynamics

The study of the flow of gases and liquids, usually in and around solid surfaces, is known as fluid dynamics in physics and engineering. Fluid dynamics, for example, can be used to evaluate the movement of air through an airplane wing or the surface of a vehicle. It can also be used in ship design to increase the speed at which ships pass through water.