As shown in figure below, oil can be siphoned from a tank using a flexible hose, provided that the end of the hose at Point B, is below the free surface in the tank at Point A. The maximum elevation of the hose is at Point C. Oil is being siphoned from the tank through a constant-diameter hose. The end of the siphon at Point B is 6.71 meters below the oil top surface level of the tank at Point A. kg If the gauge pressure at Point C is 90.257 KPa and the density of oil is 890 the vertical distance between Point C and Point B in meters is Blank 1 **EXPRESS YOUR ANSWER INTO TWO (2) DECIMAL PLACE** Point C ... Point A (Top surface) OIL

As shown in figure below, oil can be siphoned from a tank using a flexible hose, provided that the end of the hose at Point B, is below the free surface in the tank at Point A. The maximum elevation of the hose is at Point C. Oil is being siphoned from the tank through a constant-diameter hose. The end of the siphon at Point B is 6.71 meters below the oil top surface level of the tank at Point A. kg If the gauge pressure at Point C is 90.257 KPa and the density of oil is 890 the vertical distance between Point C and Point B in meters is Blank 1 EXPRESS YOUR ANSWER INTO TWO (2) DECIMAL PLACE Point C ... Point A (Top surface) OIL

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Air is pumped into a sealed cylindrical tank at 100 CFM. If the tank is originally at atmospheric pressure and is 5t in diameter and 10 ft long, what will the increase in the air pressure in the tank be in: (All Answers in psi.) a 5 min? b. 10 min? c 20 min? d. 30 min? e. 40 min? f. 50 min ? 9. 1 hr?
Shown below is an inverted U-tube which is used to drain alcohol from a tank reservoir. The bend of the inverted tube is 1 meter above the free surface of the alcohol in the tank and 10.5 meters above the ground where the alcohol is discharged. Alcohol exits the tube at atmospheric pressure. The Specific gravity of alcohol is 0.89 while g= 9.81. The pressure, in kilopascal, in the bend is Blank 1 P=? 1m
If a 200-gal. steel hydraulic reservoir twice as long as its square end section is wide and overheats the fluid with a temperature rise of 100°F, how large would the reservoir have to be to reduce the temperature rise to 70°F?
A 400cm long pipe with a smaller diameter of 3.937 inchesand a larger diameter of 11.81 inches as shown below, isinclined at a 30° angle with the horizontal. Calculate the pressure differencein KN/m²between the smaller and bigger diameter parts of the pipe if the velocity of water at the smaller diameter section is 6.56 ft/s. Pi. V₁.d₁. A1 41-0 P2. Vz, dz. Az 32 Datum
Please don't provide handwritten solution ....
In Fig. is shown a plot of pump net head as a function of pump volume flow rate, or capacity. On the figure, label the shutoff head, the free delivery, the pump performance curve, the system curve, and the operating point.
On a trip to the beach (Patm 1 atm or 101.3 kPa), a car runs out of gasoline and it is necessary to siphon gasoline from a Good Samaritan's car. The siphon is a hose with a small diameter and to start the action it is necessary to insert one end into the tank full of gasoline, fill the hose with it through suction and then put the other end in a can that is placed under the tank level. The difference in pressure between point 1 (on the free surface of the gasoline in the tank) and point 2 (at the outlet of the tube) causes the liquid to flow from the highest elevation to the lowest. In this case, point 2 is located 0.75 m below point 1, and point 3 is 2 m above 1. The siphon diameter is 4 mm and friction losses in it must be ruled out. Determine: a) theminimum time to bring 4 L of gasoline from the tank to the can and b) the pressure at point 3. The density of the gasoline is 750 kg / m3.
A 1 cm in diameter vertical pipe has a pressure difference of 200 kPa with liquid Sodium (Na) flowing through. What is the flow rate through the pipe?
There is a storage tank with a height of 5 m. Initially the tank is empty. The cross- sectional area of the tank is 1m?. There is a hole in the storage tank at a level of 2m from the bottom of the tank. The relationship between the volumetric flowrate through the hole and the level of the tank is q=vh. In addition there are two valves at the top and bottom of the tank for inlet and outlet streams. Suddenly, the two valves at the top and bottom of the tank are opened where inlet and outlet stream volumetric flowrates became 1m/s and 0.2m2/s. a)Determine the time for the liquid level to reach 2m