As gas mixture consists of 75% (by volume) methane (CH4) and 25% (by volume) hydrogen sulfide (H2S). If the total pressure is 17.2 psi and the system is in equilibrium, what is the mass concentration (in mg/L) of hydrogen sulfide gas?

Q: 9. A student carried out a fractional distillation of an unknown binary (2-component) mixture from a…

A: Given is a graph, based on data from an experiment, in which 50 ml of the binary mixture was…

Q: A 17.13 g mixture of sugar (C12H22011) and table salt (NaCl) is dissolved in 199 g of water. The…

A: The mass of sugar and table salt, m = 17.13 g The freezing point f the solution, Tf = -3.90 °C The…

Q: Express the concentration of the given solute in parts per million (ppm).

A: (1).  (a). V = 330 ml, mass = 50 mg To Calculate the concentration of the given solute, Conc. =…

Q: Since NH3 gas does not dissolve at a boundary, it diffuses in N2, which does not spread. Total…

A: Total pressure PT = 1013 × 105 Pa Temperature T = 298 K Partial pressure of NH3 PA1 = 1333 × 104 Pa…

Q: a) Calculate the bubble point of a binary liquid solution containing 0.30 mole fraction of the more…

A: (a) Binary liquid mixture with most volatile component mole fraction is 0.3. At 1 bar, P×y1=Pvap1×x1…

Q: Liquid mixture of 600 moles of methanol and water containing 40 mole % methanol is subjected to a…

A: Let methanol be A and water be B. Moles of feed mixture, F = 600 mol Mole fraction of methanol in…

Q: Using an alcohol for one method and an alkyl halide for the other, show two ways to make each of the…

A: Synthesis of propyl acetate (odour of pears) ester using alcohol Alcohol + Carboxylic acid…

Q: Two component VLE calculation:  Calculate the bubble point temperature for a liquid hydrocarbon mix…

A:

Q: Humid air is travelling through a drying channel, removing water from it. Inside the channels,…

A:

Q: Hydrogen gas is typically purified by diffusion through a palladium sheet. Compute the concentration…

A:

Q: What is the pH of an aqueous solution consisting of 0.070 M formic acid (HCOOH) and 0.070 M sodium…

A: Formic acid is a weak acid with dissociation constant Ka = 1.8 X 10-4  And since we have weak acid…

Q: 2. In the methanol synthesis described above, small quantities of non-reactive gaseous impurities…

A:

Q: 5-4. A liquid mixture of hydrocarbons has 40% by weight of cyclohexane, 40% of benzene, and 20%…

A: Given that 40 %  cyclohexane 40 %  benzene 20 % toluene   According to bartleby rule ,I can solve…

Q: . An ideal solution of two homologous liquid alkane compounds have an overall vapor pressure of 550…

A:

Q: Q4- A gas stream (0.1 CO, 0.3 CO2, 0.4 N2, 0.2 NO), the gas stream at 1200 K. Determine the absolute…

A: Given: Mole fraction of species in a gas mixture: xCO=0.1xCO2=0.3xN2=0.4xNO=0.2 The temperature of…

Q: Sodium carbonate is recovered as decahydrate from 1000kg of 5% solution of sodium carbonate in…

A: The molecular weight of Na2CO3 = 106g The molecular weight of Na2CO3.10H2O = 106+180 = 196g 50kg of…

Q: 3- What is a group of atoms bonded to a carbon of an organic compound called?

A: A group of atom that share bond with a carbon atom is called a functional group .

Q: A 5,000-lb batch of 20 wt% aqueous MgSO4 solution is fed to an evaporative crystallizer operating at…

A: Given data: Amount of feed = 5,000 lb Composition of MgSO4 in the feed = 20 wt%  Operating…

Q: Problem 4. Nine-hundred forty-seven cubic feet of wet air at 70oF and 29.2 in Hg are dehydrated. If…

A: Given: The volume of wet air is V = 947 ft3 = 26.82 m3. The mass of water vapor removed is m = 0.94…

Q: The data given below are for the adsorption of Nitrogen Gas on Silica Gel. The Saturation Vapor…

A: We are given the data for V adsorbed and P  and we are asked to find the parameters c and k for…

Q: stock solution of 12.0 M nitric acid (HNO3) is available to you. You have been told to make a 2.37 M…

A: As it is given in the question that we have M1=12M HNO3. Using V2=20.5L of stock  solution, we have…

Q: Table 1. Answers in Item (a). Point Phases present Compositions (more volatile) Temperature, °C 2 3…

A: Given graph is T-x-y for butane-pentane system. The graph consists of three phases. They are liquid…

Q: If the air (35 degrees celsius, 1 atm, 760 mmHg) contains 3% (volume fraction) water, what is the…

A: To calculate the relative humidity (RH) and the changes in water content with temperature, we start…

Q: One way of purifying gaseous H₂ is to pass it under high pressure through the holes of a metal’s…

A: Palladium is used for absorbing H2 under high pressure. Density of absorbed H2 approaches density of…

Q: A gaseous mixture of methane, ethane and propane has their percent volume of 38%, 42% and 20%…

A: Given data: Volume percent of methane=38%Volume percent of ethane=42%Volume percent of propane=20%

Q: The sulfur dioxide (SO2) stack-gas concentration from a fossil-fuel combustion plant was measured as…

A: Given, The concentration of sulfur dioxide is 5 μg/m3. The conditions are standard temperature and…

Q: A total feed of 100 hr kmole having an overall composition of 45 mol % toluene and 55 mol % benzene…

A: Hi, thank you for the question. As there are more than 3 sub-parts, we are allowed to answer only…

Q: One thousand kg/h of a 45 wt% acetone-in-water solution is to be extracted at 25oC in a continuous,…

A: a) The minimum solvent flow rate corresponds to an infinite number of equilibriumstages(1) Points…

Q: Many metals react with halogens to give metal halides. For example, iron reacts with chlorine to…

A: Given reaction is- Fe(s)+ Cl2 (g) →FeCl2 (s)   Mass of iron (Fe) = 10.0 g Molar mass of Fe=55.845…

Q: A solution is prepared by dissolving iodine, I2, in carbon tetrachloride , CCl4, at 25 °C. For a…

A: Given data: Temperature of solution = 25 0C Molality of solute = 0.1 mol/kg Value of universal gas…

Q: 1.

A: Thus mass of KNO3 will precipitate out = 480g KNO3  I hope this helps you.Explanation:Step 1: Mass…

Q: 26.20 The data provided in Figure 26.7 are based on the diffusion of O₂ into SiO₂ formed from the…

A:

Q: 1. An impure sample of compound A is contaminated with two impurities B and C. The sample is to be…

A:

Q: To analyze the alcohol content of a certain wine, a chemist needs 1.36 L of an aqueous 0.199 M K 2Cr…

A:

Q: b) At 25°C, S0 ml of saturated solution of benzoie acid requires 12.8 ml of 0.05 M NaOH to…

A: The neutralization reaction is taking place in the above mentioned question M1V1=M2V2

Q: from where we obtain the density of natural gas at different temperatures??

A: 1. Density of natural gas at different temperatures is obtained in 3 steps Subtract the initial…

Q: Styrene (3.0 M) is copolymerized with methacrylonitrile (1.5 M) in benzene solution by adding…

A: Note: We are authorized to answer three subparts at a time, since you have not mentioned which part…

Q: 4, A mixture liquid containing 40 kg A and 60 kg B is contacted with a pure solvent in a…

A: Given xA/xB in raffinate=1/3 β = 6 A=40kg B=60kg Find Mass fraction of A in extract phase,yA0…

Q: Time remaining: 00 :09 :37 Chemistry Please show steps and formula: 6a. How grams of Sodium…

A: 6.a.  Given, Volume of solution, V=100 mL Molarity of solution, M=1.00 M