The sulfur dioxide (SO2) stack-gas concentration from a fossil-fuel combustion plant was measured as 5 µg/m3 at STP (at 0 ºC and 1 atm pressure). Determine the SO2 concentration in the stack-gas in units of ppmv a) at 0 ºC and 1 atm pressure. b) at 350 ºC and 0.5 bar pressure

Q: A 6.75 g sample of roronite oxide (MM = 115.75 g/mol) was burned in excess oxygen in a…

A:

Q: (a) Calculate the effect on the chemical potential of 672 moles ice and water of increasing the…

A: Given data: Number of moles of ice = 672 mol Number of moles of water = 672 mol Initial pressure = 1…

Q: A 50/50 blend of engine coolant and water (by volume) is usually used in an automobile's engine…

A: Total volume = 5.4 gal = 5.4*3.78 = 20.412L Volume of water= volume of glycol = 10.206L Kb =…

Q: Liquid benzene (A) in a laboratory tube with a vapor pressure of 0.20 atm at a temperature of 298 K…

A: Evaporation rate for the system is asked.

Q: A mixture of 100 k mole which contain 70% mole percent n-pentane and 30% n-heptane are vaporized at…

A: Distilling a mixture of n-pentane and n-heptane allows us to separate them based on their boiling…

Q: Example (H.W): Ammonia is to be removed from a 10 percent ammonia-air mixture by countercurrent…

A:

Q: At high temperature and pressure N2 obey the equation of state P (V-b) = RT. Calculate the fugacity…

A: The nitrogen gas obeys the following equation of state at high temperature and pressure. PV−b=RT…

Q: # 4: What is the amount of energy given up by 300 kgs of ethanol that is initially at a saturated…

A: Given: 300 kg of ethanol ( 1 atm and 78.5 °C) Condensed and subcooled at 15 °C (1 atm) Consider…

Q: The exit gas from a drier in a chemical plant consists of an N2-CS2 mixture (30) containing 3.0…

A: The schematic diagram for the given absorption column is prepared as shown. Given molar flowrate of…

Q: Solve for an and b. draw the flow diagram with include values like example below. I also attach…

A: Step 1:To solve the problem of calculating the rate of evaporation and the time required for…

Q: Problem 29-6E. Natural gas from a "fracking" operation containing hydrogen sulfide vapor enters to…

A: A mixture of H2S and CH4 is contacted with a brine solution to separate the H2S from the mixture.

Q: Calculate the mass (in pounds) of carbon dioxide and carbon monoxide emitted by burning a gallon of…

A:

Q: CMC of a surfactant in water at 25 oC is 0.5 g L−1 and at 45 oC is 0.3 g L−1. The molar mass of the…

A:

Q: This example illustrates the use of liquid-liquid phase equilibria in material balance calcu-…

A: Assume outlet phases are in equilibrium. The solubilities of the components at 200C are:EDC in…

Q: Give the state of the system, phases present, compositions (more volatile) represented by each…

A: Given the T xy diagram of butane-Pentane System at 1.5 atm .  As pentane is heavier in nature than…

Q: the tube, and the wall temperature is maintained at 55°C. What fraction of the vapour will condense…

A:

Q: The figure below shows the phase diagram of Ni-Cu isomorphous system at 1250 °C wi total mass of 300…

A:

Q: 2. Find the smallest diameter particulate (pp = 1700 kg/m') to be collected with 100% efficiency in…

A: Given: L1 = 2m, L2 = 1 m and H = 35 cm  At 20 0C, μ = 1.825×10-5 kg/m.s and density of gas = 1.204…

Q: A total feed of 100 hr kmole having an overall composition of 45 mol % toluene and 55 mol % benzene…

A: Hi, thank you for the question. As there are more than 3 sub-parts, we are allowed to answer only…

Q: Calculate the mass flux (kg/m2-s) for the following tank leaks given that the storage pressure is…

A: Introduction The rate of mass flow is referred to as mass flux in physics and engineering. kg/m2sare…