An oil sample had its iodine number determined using the pyridinium tribromidemethod. The sample and reagents used are as follows:Oil sample: 0.19 mL, density: 0.954 g/mLPyridinium tribromide: 0.472 gNa2S203: 0.1 M, endpoint 27.68 mL%3DWhat is the approximate Bromine Number?O 13889O 120O 200

Answered: Image /qna-images/answer/bc4ae2b6-634c-46d5-9632-d265e23ca0d2.jpg

Answered: An oil sample had its iodine number…

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

Please answer as soon as possible. Thank you! A 10.000-g cocoa powder sample was dissolved in concentrated acid and then diluted to 100.00 mL using distilled water. The solution was found to contain 5.45 uM Fe. Calculate concentration of Fe (MM: 55.845) in the cocoa powder sample in parts-per-million (ppm) (weight by volume).
Six 50.0 ml volumetric flask 1-6 are labeled. 10.00 ml of 2.00 x 101 M Fe(NO3)3 solution was then pipet into each volumetric flask. A 1.00,2.00,3.00,4.00 and 5.00ml of 2.00 x 10-3M NaSCN solution was then pipetted to flask 2 through 6 respectively. A sufficient 0.10 M nitric acid was then added to each flask to make them total volume of 50.00ml. 1.a)Calculate the final Fe(NO3)3 concentrations for each. 1.b)Also how would you find the initial concentration of SCN- for each flask? Please show calculations to solutions.Thanks
Sixty mL of an impure acid solution was diluted to 500mL. A 30.00mL portion of this solution was titrated with 25.00mL of 0.1230M NaOH solution. Calculate the % (w/v) HAc in the sample. (FWt HAc = 60) Show all the solutions involved and round-off final answers to two decimal places except for Molarity. (Molar concentrations should be in four decimal places)
A 20-tablet sample of soluble saccharin was treated with 20.00 mL of 0.08181 N AgNO3. After removal of the solid, titration of the filtrate and washings required 2.81 mL of 0.04124 N KSCN. Calculate the average number of milligrams of saccharin (205.17 g/mol) in each tablet.
Chemistry Nitric acid solutions with a pH of about 5 are often used to simulate acid rain. A nitric acid solution with a pH of 5 has a concentration of 0.00001 M. Describe how to prepare 10 mL of a 0.00001 M solution using a 1 M stock solution and the serial dilution technique
Shana, a student in the Analytical Chemistry class, performed a Redox Titration to determine the content of hypochlorite ions (% w/w) in an unknown solution. First, Shana prepared a primary standard solution of KIO3 by dissolving 0.4791 g dry KIO3 in 250.00 mL DI water. Next, using the procedure in your lab manual, Shana used 50.00 mL of this primary standard solution to standardize the Na2S2O3 titrant, and 26.25 mL of titrant was consumed. Next, Shana prepared the unknown solution by diluting 12.8624 g of the solution in 250.00 mL of DI water. A 50.00 mL portion of this dilute unknown solution was titrated using the procedure in your lab manual, and 19.25 mL of Na2S2O3 solution was consumed. Answer the following questions about this titration. Recall the stoichiometry of the NET chemical equation for this reaction. Note: use appropriate significant figures in your answer! A. Calculate the concentration (M) of Na2S2O3 titrant. B. Determine the amount (g) of hypochlorite ion in 50.00 mL…
Hello, I'm going wrong somewhere in solving. Could you help me? Picture attached
A 0.1093-g sample of impure Na2CO3 was analyzed by the Volhard Method. After adding 50.00 mL of 0.06911 M AgNO3, the sample was back titrated with 0.05781 M KSCN, requiring 27.36 mL to reach the end point. Report the purity of Na2CO3 sample.
Assuming that the standard solution contains 20.0 g/L of Red Dye #40, report the concentration in g/L of Red Dye #40 in your unknown. The path length is 1.00cm To test the unknown and standard solution, 0.1 mL of the unknown was dispensed into a 50-mL volumetric flask about three-fourths full with deionized water. this was done 1 more time for the unknown and two times for the standard solution. Therefore at the end, there were 4 flasks each with 0.1 mL of sample (2-unknown and 2-standard solution).
Bay Water Titration The concentration of Cl- in ocean water is about 500-600 mM. The baywater is diluted by a factor of 12.5 using a 20.00 mL volumetric pipet and a 250 mL volumetric flask. Using a 15.00 mL volumetric pipet, 15.00 mL is transferred into three clean Erlenmeyer flasks. 10 mL of 1% dextrin solution, 20 mL of de-ionized water, and 3-4 drops of indicator are added and titrated each with the AgNO3 solution. From the procedure, find: Dilution factor Volume of diluted bay water Then calculate: The [Cl-] of diluted bay water The [Cl-] of bay water Consider this information: [AgNO3] = 0.04043177 trial # Veq 1 13.91 2 13.73 3 13.9 4 13.86 5 13.87 6 13.84 average 13.85167 [Cl-]Bay = ([AgNO3](Veq(ave))/Vdil bay water pipeted) (Vflask/Vbay water)
In the Vitamin C analysis, you determined Vitamin C content in a tablet using redox titration method. Calculate the mass of vitamin C in the tablet which was dissolved in 50 mL of water. A 25 mL aliquot of this stock solution was titrated with 18.5 mL of a 0.0250 M KIO3 to the blue starch end point. If the same KIO3 solution was used to titrate 20 mL of a commercial juice blend and the juice blend required 1.5 mL of KIO3 to reach the end point. How many milligrams of vitamin C are in the sample of juice blend? Molar mass Vitamin C = 176.16 g/mol.
Please help to calculate a dilution factor and the amount of mg in the vitamin. There are 1.13 ppm of iron. An unknown vitamin was dissolved in 25 ml of 6 M of HCl. Then brought up to 100 mL with DI water. Dilute 5.00 mL of solution A to 100.0 mL in a 100.0-mL volumetric flask. This is Solution B.Transfer 10.00 mL of Solution B to a 100.0-mL volumetric flask. Based on this dilution, the dilution factor is 200, so how many mg of iron is in vitamin?

SEE MORE QUESTIONS

Recommended textbooks for you

Chemistry

ISBN:

9781305957404

Author:

Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:

Cengage Learning

Chemistry

ISBN:

9781259911156

Author:

Raymond Chang Dr., Jason Overby Professor

Publisher:

McGraw-Hill Education

Principles of Instrumental Analysis

Chemistry

ISBN:

9781305577213

Author:

Douglas A. Skoog, F. James Holler, Stanley R. Crouch

Publisher:

Cengage Learning

Chemistry

ISBN:

9781305957404

Author:

Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:

Cengage Learning

Chemistry

ISBN:

9781259911156

Author:

Raymond Chang Dr., Jason Overby Professor

Publisher:

McGraw-Hill Education

Principles of Instrumental Analysis

Chemistry

ISBN:

9781305577213

Author:

Douglas A. Skoog, F. James Holler, Stanley R. Crouch

Publisher:

Cengage Learning

Organic Chemistry

Chemistry

ISBN:

9780078021558

Author:

Janice Gorzynski Smith Dr.

Publisher:

McGraw-Hill Education

Chemistry: Principles and Reactions

Chemistry

ISBN:

9781305079373

Author:

William L. Masterton, Cecile N. Hurley

Publisher:

Cengage Learning

Elementary Principles of Chemical Processes, Bind…

Chemistry

ISBN:

9781118431221

Author:

Richard M. Felder, Ronald W. Rousseau, Lisa G. Bullard

Publisher:

WILEY

SEE MORE TEXTBOOKS

An oil sample had its iodine number determined using the pyridinium tribromide method. The sample and reagents used are as follows: Oil sample: 0.19 mL, density: 0.954 g/mL Pyridinium tribromide: 0.472 g Na2S203: 0.1 M, endpoint 27.68 mL %3D What is the approximate Bromine Number?