An inductor is connected to the terminals of a battery that has an emf of 15.5 V and negligible internal resistance. The current is 4.86 rmmA at 0.940 ms after the connection is completed. After a long time the current is 6.45 mA Part A What is the resistance R of the inductor? Express your answer with the appropriate units. Value Units R = Request Answer Submit Part B What is the inductance L of the inductor? Express your answer with the appropriate units. Value Units L =

Q: In the RC (series) circuit, R = 1.2 MQ and C = 5.00 µF. It is connected to a 30 volt power source…

A: The charging and discharging of a capacitor's energy is never instant but takes a certain amount of…

Q: ww 22. 3R R ٤٠ DC Circuit In this circuit R = 10.0 and ε = 5.0 V. a. What current flows through the…

A:

Q: L ll R R L + V L ell

A: Please see the answer below

Q: It takes 2.67 ms for the current in an LR circuit to increase from zero to 0.80 its maximum value.…

A:

Q: A 70 μF capacitor with a 13 μC charge is connected across a 18 mH inductor. What is the charge on…

A: a

Q: Plz don't use chat gpt

A: Step 1:

Q: S L R 2 R Consider the circuit on the left. The bat- tery has an EMF of 20.0 volts and negligi- ble…

A: b. Use Kirchhoff’s loop law in the bigger loop containing the battery, the switch, the inductor, and…

Q: 25. find the magnetic energy stored in inductor when it reaches the steady state ( time = infinity).…

A: Given, RL circuit

Q: 3 When switch S in Fig. E25.29 Figure E25.29 is open, the voltmeter V reads 3.08 V. When the switch…

A:

Q: Discharging Capacitor: Kirchoff's loop rule applied to the discharging capacitor circuit gives 2- C…

A: The time constant of an RC circuit is the product of the resistance R and capacitance C,…

Q: A 5.0-cm-diameter coil has 20 turns and a resistance of 0.50 N. A magnetic field perpendicular to…

A:

Q: An RLC circuit consists of a 69.3 2 resistor, a 3.66 µF capacitor, and a 73.5 mH inductor.…

A: Given data: The resistance, R=6 Ω The inductance, L=73.5 mH=73.5×10-3 H The capacitor, C=3.66…

Q: 3. Consider the circuit below, with a 12V battery connected between the leads on the left. =12v S…

A:

Q: A moving coil ammeter gives a full scale deflection for a current i = 60 mA and its coil has a…

A: Current for full scale deflection of a moving coil ammeter (i) = 60mA Resistance of coil (Rc) = 0.5…

Q: The emf frequency in the figure (Figure 1)is 7.00 kHz. You may want to review (Pages 911 - 913).…

A:

Q: None

A: thank you

Q: An 8-bit DAC has a Vref of 12 V. The binary input is 10111011. Find the analog output voltage.

A:

Q: An inductor L=47 H is connected in series with a resistor R=25 ohms and a voltage source V=12 V and…

A: Inductance,L=47 H Resistance, R=25 ohm Voltage,v=12 volt

Q: The current in the RL circuit shown below reaches half its maximum value in 0.5 ms after the switch…

A:

Q: ww In the circuit the emfe153 veols sad the indoctance L606 ml What will be the magnitade of the…

A: Given, R=4.30 ΩL=60.6 mHε=153 Voltt=17.8 ms

Q: It takes 2.51 ms for the current in an LR circuit to increase from zero to 0.75 its maximum value.…

A:

Q: A 4.4-μF capacitor has a voltage of 52 V between its plates. What must be the current in a 5.9-mH…

A: Energy stored in a Capacitor (C) in terms of Voltage (V): The energy (W) stored in a capacitor is…

Voltage Across Inductor

An actor is a passive electrical component that consists of a coil bent in the form of wire which uses electromagnetism to produce electric current through the coil. When the electric current flows through a conductor that is the coil, a magnetic flux is developed around the conductor. This flow of current through the coil creates a magnetic field based on Fleming's Right-hand thumb rule. If there is any decrease in the current passing through the inductor, then the magnetic field will also decrease and energy is released through the generation of electric current. There is also a secondary voltage inducing in the same coil due to the magnetic flux, since it opposes any changes in the electric current flowing through the circuit. An inductor is also called choke, coil, or solenoid. A choke is designed to block certain frequencies when the DC current passes. A winding coil is coated with insulation to give extra insulation and protect the circuit. They are usually tightly wrapped around a central core which is cylindrical in nature so that the magnetic flux can be induced. The solenoid is a three-dimension coil that is used to exhibit electromagnetism when the magnetic field is developed due to the current flowing through the coil. The sign convention of the inductor is the same as the power dissipating device. When the current flows into the positive side of the voltage across the inductor, the value is positive and the inductor dissipates power whereas when the inductor releases the power back to the circuit, the current has a negative sign convention.