An engineer's level with a stadia constant of 0.30 m was set up on the line between two points, A and B, and the following hair readings were observed. Station sighted Upper reading Middle reading Lower reading 1.330 m 1.175 m 1.020 m C 1.972 m 1.854 m 1.736 m If the stadia interval factor of the level is 99.5, determine the following: a) Stadia interval observed on A b) Stadia interval observed on B c) Horizontal distance from level to the rod held at A d) Horizontal distance from level to the rod held at B e) length of line AB

An engineer's level with a stadia constant of 0.30 m was set up on the line between two points, A and B, and the following hair readings were observed. Station sighted Upper reading Middle reading Lower reading 1.330 m 1.175 m 1.020 m C 1.972 m 1.854 m 1.736 m If the stadia interval factor of the level is 99.5, determine the following: a) Stadia interval observed on A b) Stadia interval observed on B c) Horizontal distance from level to the rod held at A d) Horizontal distance from level to the rod held at B e) length of line AB

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A level instrument at a height of 1.320 m has been placed at a station having a Reduced Level (RL) of 112.565 m. The instrument reads -2.835 m on a levelling staff held at the bottom of a bridge deck. The RL (in m) of the bottom of the bridge deck is A. 116.720 B. 116.080 C. 114.080 D. 111.050
pls help me solve this. 1) a transit with stadia interval factor of 100.8 was set up at point C on the line bet. A and B. The ff. readings were observed: (*see from attached photo) If the distance from the focus is 0.38m. determine the ff.: a) horizontal distance bet. A and B b) Diff. in elevation bet. A and B of the value of HI are 300m and 315m respectively.
from the following data the mean preciptation as determind by the thiessen polygon methods is 50.6mm? station a b c d rain amount (mm) 40 ? 35 60 area covered (ha) 12 25 18 45 the missing raianfall amount in station b is ? a. 40mm b.none of these c.50mm d.30mm
From the given data of a differential leveling as shown in the tabulation: STA. B.S. H.I. F.S. ELEV. A 5.87 329.25 7.03 6.29 3.48 6.25 D 7.25 7.08 E 10.19 5.57 9.29 4.45 G 4.94 a.) Find the difference in elevation of station F and station E. b.) Find the difference in elevation of station G and station B. c.) Find the elevation of station D.
A line of three-wire differential levels goes from benchmark Gloria to benchmark Carey. The length of the line was determined to be 2097 m. The instrument had a stated compensator accuracy of pm 1.4 mm/ km. The instrument–rod combination had an estimated reading error of 0.4 mm per 40 m. Sight distances were kept to approximately 50 5 m. If the observed difference in elevation is 15.601 m, what is the estimated error in the final elevation difference? If benchmark Gloria had a fixed elevation of 231.071 m and Carey had a fixed elevation of 246.660 m, did the job meet acceptable closure limits at a 95% level of confidence? Justify your answer statistically.
A-15 m- 33 m Q2) The figure to the right shows a rectangle ABCD, in which A, B, and C are the stations where staff readings were obtained with a level set up at E and D. The observed readings are given in Table. 20 m Staff reading at level location A B C 1.85 0.803 D 2.42 1.361 1.659 48 m If A is a benchmark having elevation of 70 m. Note: the deflection angle in Line of sight (5) is + 0.1146 degree. Level 1. calculate the correct elevations B and C 2. if the height of instrument at E = 1m, and at D= 1m, what is the height difference between D and E
A backsight reading of 2.73 m is taken on point A and subsequently a foresight reading of 1.35 m is taken on point B from a level station established midway between the points. The difference in elevation between points A and B is
A transit with a stadia interval factor of 100 was set up at C with elevation of 500m. and the following stadia reading were observed at points A and B: POSITION OF VERTICAL HAIR READINGS AZIMUTH ROD ANGLE UPPER (a) MIDDLE (c) LOWER (b) ROD HELD AT A 25°36' -25°35' 1.43 m 0.175 m 0.920 m ROD HELD AT B 305°40' +18°28' 2.022 1.854 1.686 If the stadia constant is 0.30m. determine the following: a. Elevation at points A and B HI at C is 1.00 m b. The distance of line AB c. Grade from point A to point B
In the two peg-test methods of a dumpy level, the following observations were taken. Instrument set Instrument set up near A up near B Rod reading on A Rod reading 2.35 m 1.05 m on B 2.90 m 1.25 m [ Select ] Determine the error in the line of sight. [ Select ] If the line of sight is not in adjustment, determine the correct rod reading on A with the instrument still set up at В.
A transit with stadia interval factor of 100.80 was set up at point C on the line between points A and B. The following readings were observed: If the stadia constant is 0.318m, determine difference in elevation between points A and B.