An electric motor shaft with a pinion transmits 350 kW power at 1500 rpm to a gear in a reduction gearbox with following specifications: The Gear ratio = 8:1; Distance between centres = 820mm mm approximately; Involute teeth of standard proportions (addendum = 1.2 m) with pressure angle of 20.5°; Permissible normal pressure between teeth = 320 N per mm of width. Find: a) The nearest standard module if no interference is to occur b) The number of teeth on each wheel c) The necessary width of the pinion d) Normal and Tangential load on the tooth of the pinion due to power transmitted

Q: Epicyclic gear box is shown in Figure.2, the gear box has outer gear C with 120 teeth, B has 50, D…

A:

Q: A linear actuator having a in single-thread Acme screw is used to raise a load of 1600 lb. A plain…

A: Given:The diameter of the thread, The value of the load, The mean diameter of the thrust collar, The…

Q: If a pinion having 20 teeth transmit the power to the gear shaft having 40 teeth, the gear ratio of…

A: If a pinion having 20 teeth transmit the power to the gear shaft having 40 teeth, the gear ratio of…

Q: The figure below represents a pair of spur gear fitted on a lathe machine. A power of 6 kW at 657…

A:

Q: campute the bending stress number for the goer pair described by the given data beLow. KS= 1, Km=…

A:

Q: Example: Design a compound gear train for an exact reduction ratio of 180:1 given: ϕ =20o Module:…

A:

Q: Ex] A double-threaded right-handed worm gear transmits 15 Hp at 1150 rpm. The pitch of the worm is…

A:

Q: You design a gearbox with a gear ratio of 5 (GR=5=TGB/Tm) to pull a load (FL) of 76 lbf using a…

A: Given data: Gear ratio = 5  Load = 76 lbf Winch radius = 0.25 inch We have to determine the torque…

Q: 1.Please design a pair of spur gears in the milling machine. It is known that power input is 7.5kW,…

A: Given : P = 7.5 kW N = 1450 rpm u = 2.08 To find : Design pair of spur gears Note : some values are…

Q: There are two pairs of closed soft tooth surface spur gears A and B, Parameters of A: modulus m =…

A: Two parts of spur gears-For Gear A-modulus, m=2mmAccuracy oftwo pairs of gear is = grade 8.

Power Transmission Elements

It is defined as the energy transfer from one location to another location. The energy will start moving from the energy generation source to the energy applied position to obtain the work output. From this method, a large amount of electric energy moves from the power station to various electrical substations.