An AC voltage source of 100V and 50HZ is supplying a coil that has an inductance of 100 mH in series with a resistance of 35 Q as shown below. Calculate:RIms100Vrms 50HZThe power factorOa. 0.724 LaggingOb. 0.704 LaggingOc. 0.684 LaggingOd. 0.744 LaggingThe apparent power consumedOa. 217.6 VAOb. 212.6 VAOc. 207.6 VAOd. 222.6 VAIf a capacitor added in parallel as shown to increase the power factor to unity, find the capacitance value If a capacitor added in parallel as shown to increase the power factor to unity, find the capacitance valueRIms100Vms 50HZOa. 45.21 uFOb. 47.21 UFOc. 43.21 uFOd. 41.21 UF

Due to guidelines we can solve one complete question at a time if you want another question 's…

An AC voltage source of 100V and 50HZ is supplying a coil that has an inductance of 100 mH in series with a resistance of 35 N as shown below. Calculate: Ims 100Vms 50HZ The power factor Oa. 0.724 Lagging Ob. 0.704 Lagging Oc. 0.684 Lagging Od. 0.744 Lagging The apparent power consumed Oa. 217.6 VA Ob, 212.6 VA Oc. 207.6 VA Od. 222.6 VA

An AC voltage source of 100V and 50HZ is supplying a coil that has an inductance of 100 mH in series with a resistance of 35 N as shown below. Calculate: Ims 100Vms 50HZ The power factor Oa. 0.724 Lagging Ob. 0.704 Lagging Oc. 0.684 Lagging Od. 0.744 Lagging The apparent power consumed Oa. 217.6 VA Ob, 212.6 VA Oc. 207.6 VA Od. 222.6 VA

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

A 90 kHz sinusoidal voltage has zero phase angle and a maximum amplitude of 30 mV . When this voltage is applied across the terminals of a capacitor, the resulting steady-state current has a maximum amplitude of 629.60 μA . Pt A. What is the frequency of the current in radians per second? Pt B. What is the phase angle of the current? Pt C. What is the capacitive reactance of the capacitor?
Note: Please do not handwritten.
Please answer all subpart either dislike is ready.. please answer all subpart please I will like it..
When a load is connected to a power line with a frequency of 230V (rms) 50 Hz, it draws 4500 W at a power factor of 0.80. Find the required capacitance value to increase the power factor to 0.85.
Consider the following circuit:
The current through the 20-Ohm inductive reactance is given. What will be the sinusoidal expression for voltage.i=-6 sin(wt-30°)
Question in the attachment
Determine and sketch the output voltage waveform for the circuit shown if the sinusoidal signal at the input has a peak-to-peak voltage of 30 volts with V=5volts. Identify the circuit.
Mechanical
The equation of alternating voltage isgiven by ν = 325.22 ???314?.Find (i) RMS value (ii) Frequency (iii)Average value.
Vm = 10 V T = 2 ms V0 = 7.07 V 1) Find the frequency of the voltage in Hz. 2) What is the frequency in kiloradians per second? 3) What is the rms value of the voltage?
The sinusoidal voltage trace displayed by the CRO, the time/cm switch is on 50 µs/cm and the volt/cm switch is on 20 V/cm. The width of one complete cycle is 3.6 cm and the peak to peak height is 5.8 cm. Determine the following: The frequency is = The peak to peak voltage is = The amplitude is = The R.M.S voltage is =