QUESTION 8 Ten volt (10V) magnitude sinusoidal voltage of frequency 1MHz is applied across a 100 Ohm resistor connected in series with a 1.66 nF (nano-Farad) capacitor. What is the magnitude of the sinusoidal voltage across the capacitor? Round your answer up. 2.5 Volts O 10 Volts O 5 Volts O 0 Volts

Q: The voltage rating of a capacitor used in an AC circuit refers to the maximum voltage. O continuous…

A:

Q: (b) 60 L₂ vor 100 mH roo 50 mH 2₁ & mH 4 mH 4 mH 3 L₂ 60 mH 2 mH L₂ 2 mH 000 LA Ly I mH Ls 2 mH La…

A:

Q: What is the form factor of this waveform...

A: The given waveform is shown below.

Q: V = 20Vpp 1kHz's sinusoidal wave)   In this Circuit, change the inductor to 2.2mH, 4mH, 10mH,…

A: Given Data:An RL series circuit with,AC voltage Frequency Inductors,To Find:The plot of the voltage…

Q: A series LRC circuit has a sinusoidal voltage supplied to it at 158 kHz with a peak voltage of 810…

A: Given a series LRC circuit has a sinusoidal voltage supplied to it at 158 Hz with a peak voltage of…

Q: Compute the amount of capacitance needed to correct  the power factor to 90%

A:

Q: an rc series circuit is connected to a 240v 60 hz power source an ammeter indicates a current of 20…

A: We have drawn a circuit diagram corresponding to the given information. The RMS value of input…

Q: The waveforms of the supply voltage e(t) and current i(t) of a circuit are shown in the figure…

A: We need to find out voltage across inductor for given current and we need to find out impedance for…

Q: If you apply 4V on pin 5 draw the waveform at each pin 2,3 on the same axis as the dual mode for the…

A: The objective of the question is to understand the waveform at pin 2 and pin 3 of a 555 timer when…

Q: 21 when a capacitor and resistor are connected in parallel how many degrees out of phase are the…

A:

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.