A. The food compartment of a refrigerator, shown in fig., is maintained at 4°C by emoving heat from it at rate of 360000 J/min. If the required power input to the frigerator is 2 Kw, determine (a) the coefficient of performance of the refrigerator nd (b) the rate of heat rejection to the room that houses the refrigerator. Kitchen On 2 kW Or. 360 kJ/min Food compartment 4°C

A. The food compartment of a refrigerator, shown in fig., is maintained at 4°C by emoving heat from it at rate of 360000 J/min. If the required power input to the frigerator is 2 Kw, determine (a) the coefficient of performance of the refrigerator nd (b) the rate of heat rejection to the room that houses the refrigerator. Kitchen On 2 kW Or. 360 kJ/min Food compartment 4°C

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

A Carnot heat engine operates between thermal reservoirs at Th and Tc. What is the theoretical efficiency, η, of this engine? -Part (a) Write an expression for thermal efficiency, η. - Part (b) Solve numerically for the thermal efficiency, η, assuming that Th = 820°C and Tc = 440°C.
It uses an underground lake as the cold reservoir of a Carnot heat pump that maintains the temperature of a science lab at 318.5 K. To deposit 11346 J of heat in the lab, the heat pump requires 1108 J of work. Determine the temperature of water in the underground lake, in Kelvin.
Water vapor enters the turbine at a pressure of 6 MPa, a mass flow of 400 kg/s and a temperature of 500 °C. It leaves the turbine as 8 kPa saturated steam. The heat transfer from the turbine to the environment is 180 °C at an average surface temperature of 8 MW. The kinetic and potential energy effects are negligible. a) Calculate the power and exergy dissipation in MW for a control volume surrounding the turbine. b) If the turbine is located in a facility where the ambient temperature is 27 °C, determine the exergy destruction for an enlarged control volume containing the turbine and its immediate surroundings. dead state; T0=300 K, P0=100 kPa
The heat engine shown in the figure uses 2.0 mol of a monatomic gas as the working substance. (Figure 1) igure p (kPa) 600- 400 200 0 0 0.025 0.050 V (m³) 1 of 1 Part E part. What is the engine's thermal efficiency? Express your answer using two significant figures. η = Submit VE ΑΣΦ Request Answer ? %
The figure belows shows three components of an air-conditioning system, where T3 = 95°F and m3 = 1.5 lb/s. Refrigerant 134a flows through a throttling valve and a heat exchanger while air flows through a fan and the same heat exchanger. Data for steady-state operation are given on the figure. There is no significant heat transfer between any of the components and the surroundings. Kinetic and potential energy effects are negligible. Saturated liquid R-134a T3, m3 m₁ = i Throttling valve lb/s 4 P4= 60 lbf/in.² Air T₁ = 535°R Cp=0.240 Btu/lb-ºR Fan wwwwww T₂=528°R +2 5 Wey = -0.2 hp Saturated vapor Ps= P4 Modeling air as an ideal gas with constant cp = 0.240 Btu/lb. °R, determine the mass flow rate of the air, in lb/s. -Heat exchanger
The rate of heat leaking into a house from the warmer outdoors is given by A(TH – TC) where TC and TH denote the indoor and outdoor temperatures, respectively, and A is a constant. If the outdoor temperature is 32°C, what will be the ratio of the power required to maintain an indoor temperature of 21°C to that required to maintain an indoor temperature of 25°. Assume the air conditioning system operates at its maximum possible coefficient of performance.
p (kPa) Он 400 5) The figure shows a pV diagram for a cycle of a heat engine for which Q, = 25 J. What is the thermal efficiency of the engine? 200 (Hint: remember to convert cm³ to m³!) A) 17% B) 34% C) 8.5% D) 64% E) 40% 100 V (em³) 200
A heat pump moves heat from the chilly 8°C air outside a house to the toastier 21°C air inside. The actual coefficient of performance of the system is 3.2, a typical value. How much energy would it take to add 11 kJ each second if the heat pump ran at the maximum theoretical efficiency?
Problem 2: This problem compares the energy output and heat transfer to the environment by two different types of nuclear power stations—one with the normal efficiency of 36 %, and another with an improved efficiency of 47 %. Suppose both have the same heat transfer into the engine in one day, 2.5 × 1014 J Part (a) How much more electrical energy is produced by the more efficient power station? Part (b) What is the change in the heat transfer to the environment after the upgrade to the more efficient power station?
An electric heater supplies heat to a system at a rate of 100 W. If system performs work at a rate of 75 Joules per second. At what rate is the internal energy increasing?
(a) How much heat transfer occurs to the environment by an electrical power station that uses 1.25×1014 J of heat transfer into the engine with an efficiency of 42.0%? (b) What is the ratio of heat transfer to the environment to work output? (c) How much work is done?
A Carnot heat engine operates between thermal reservoirs at Th and Tc. What is the theoretical efficiency, η, of this engine? Part (a) Write an expression for thermal efficiency, η. Part (b) Solve numerically for the thermal efficiency, η, assuming that Th = 910°C and Tc = 310°C.