7. A central air conditioner removes heat at the rate of 44,500BTU/hr from inside of a house at 20.0°C.Outside of the house it is 40.0°C. The coefficient of performance of this air conditioner is K=14.2.a) Find the magnitudes of Qc, Qh, and Wk in joules for one hour ofoperation of the air conditioner. Use 1 BTU=1,054J.b) Draw the heat flow schematic on the figure to the right for onehour of operation of the air conditioner. Show your energyvalues on the figure and show arrows for energy flow directions.Thc) Find the power in horsepower of the motor needed to drive thisrefrigerator.RefrigeratorTed) What is the maximum K that could possibly be achieved by any air conditioner for this house underthese conditions?e) Fill in on the line below the maximum K, show your value from part d), show the given K, and identifythe possible and impossible regions on the line.WorthlessPerfectrefrigeratorrefrigeratorK=0Kmax=

Consider given data as below. Rate of heat remove, Qremove=44500 BTUhr Temperature inside house,…

Answered: 7. A central air conditioner removes…

Similar questions

A system with a piston expands when it gives off 51.9J of heat to the surroundings. The piston is working against a pressure of .581 atm. The final volume is 58.6L and the initial volume was 65.1L. What is the change in internal energy?
An ideal gas has been subjected transformations AB and BC (see pic/link) Find the change in the inner energy during the whole transformation (AB+BC), if the change in volume is 1 m3.
1. When the pins fall away, the gas is compressed by a constant external pressure to 5 atm. Calculate AS and find the maximum work that could have been extracted from the same change in state had the process been carried out reversibly. The system is in contact with the surroundings at 250K. TE250k O.5 moler ielealget at latm -Perti Satm
An aircraft engine takes in 8900 JJ of heat and discards 6700 JJ each cycle. Part A. What is the mechanical work output of the engine during one cycle? Part B. What is the thermal efficiency of the engine? Express your answer as a percentage.
A solid cylindrical bar conducts heat at a rate of 25 W from a hot to a cold reservoir under steady state conditions. If both the length and the diameter of this bar are doubled, the rate at which it will conduct heat between these reservoirs will be O 12.5 W. O 200 W. O 100 W. O 25 W. O 50 W.
The heat engine shown in the figure uses 2.0 mol of a monatomic gas as the working substance. (Figure 1) Figure p (kPa) 600 400 200- 0 0 0.025 0.050 V (m³) Part A Determine T₁, T₂, and T₁. Enter your answers numerically separated by commas. Express your answer using two significant figures. T₁ T₂. T₂ = 600,1800,1200 K Submit Previous Answers ✓ Correct Part B Determine AEth. W. and Q for 1-2. Enter your answers numerically separated by commas. Express your answer using two significant figures. AEth. Ws. Q = 3.0x104.1.3x104.4.3x104 J Submit ✓ Correct ▾ Part C Previous Answers Determine AEth. W. and Q for 2-3. Enter your answers numerically separated by commas. Express your answer using two significant figures. AEth. Ws. Q= Submit ▾ Part D ΠΑΣΦ Request Answer I ? J