A) what is the number of drop of the flownet? B) What is the flow of water in the unit of cm^2/min? C) What is the water pressure, u, at point A? (Assume the water unit is 10 kN/m^3) D) What is the total head at point B/ E) What is the water pressure at point B? (Assume the water unit is 10 kN/m^3)

Q: An orifice at the bottom of a rectangular tank has a cross-sectional area of 0.004m². The tank has a…

A: We have to find coefficient of discharge and time to lower the water surface from 5.6m to 3m.

Q: Show all the necessary figures (if applicable) 1.5) Points A and B are separated by 915 m of new…

A:

Q: Please solve under Water Supply Engineering.

A:

Q: (Flowrate) Water flows through the rectangular channel shown in the figure below with a uniform…

A: a)b)

Q: Water is pumped through a vertical steel pipe to an elevated tank. D = 10 cm, P₁= 1.6 MPa, L = 80 m,…

A: Given data:- The given diameter, D=10 cm=0.1 m The given Pressure at 1, P1=1.6 MPa The given Length,…

Q: Problem Water is pumped through a vertical steel pipe to an elevated tank. D = 10 cm, P₁= 1.6 MPa, L…

A: Given data:- Diameter of pipe, D=10 cm Length of the pipe, L=80 m Pressure, P1=1.6 MPa=1.6×106 N/m2…

Q: Find the depth in a lake at which the pressure is 18500 lb/ft2. Recall Dwater=62.4 lb/ft3

A:

Q: Water is siphoned from the tank as shown in the figure below. the length of the pipe is 12 m and has…

A: Diameter of Siphon d = 400mm length of siphon = 12m Roughness ratio = 0.001 a) Neglecting all the…

Q: (7) Water flows in a rectangular channel with base width B-5 m and depth D=1.5 m. It then flows…

A: Given data Initial and final depth 1.5 and 0.5 mWidths 5 m find out Discharge Force

Q: Water flows with a flow rate of 0.6 cumec through an inclined pipe PQ of length 10 m lengt having a…

A: Flow rate = 0.6 cumecLength of pipe PQ = 10 mAngle = 30 degreePressure = 30 kN/m2We have to…

Q: 3) Water is moving with a velocity of 5.0 m/s through a pipe with a cross-sectional area of 4.0 cm?.…

A:

Q: 8. The flow net for the dam below is shown under the following conditions: Ah = 15 m, the soil…

A: A- Number of flow channels= Flowline- 1 Nf=5-1Nf=4 Number of potential drops=Potentialline- 1…

Q: Question-1 Hydraulic Engineering (Open Channel Hydraulics) Water is flowing in the trapezoidal…

A:

Q: Q1: For the set up shown in the following figure. Determine the total head, pressure head, elevation…

A: As head at E is more than head at B flow is in upward direction. n = Porosity = 0.34K = Permeability…

Q: Two Water flows from reservoir A to reservoir B through two pipes as shown below. Determine 1) the…

A: Given data: Assume α = 1.0  It is asked to determine : 1) the discharge in the pipe 2) the…

Q: The flow rate in a long rectangular channel (n = 0.014) is equal to the last three digits  of your…

A:

Q: 1. A circular orifice 30 mm in diameter, in the interval side of a vessel, discharge water under a…

A:

Highway Drainage

Highway drainage is the process of extracting and regulating the excess surface water on the pavement by giving the desired slope. The construction of a highway drain helps to divert the water present on the surface, and sub-grade by the means of slope. Highway drainage systems are a necessary part of smooth functioning of traffic, since the highway drainage systems provide proper disposal of unwanted substances from the highways.