A well-mixed, insulated water storage tank isto be maintained at internal temperature60°C. The environmental temperaturearound the tank varies from -25°C to 30°C.The tank's exterior surfaces (total = 125m²) have four different levels of insulationas indicated in the table.SurfaceComponent Area,Effective RSI,22 m². °C/Wm²Surface A60.0Surface B30.0Surface C30.0Surface D5.0Saythat just one surface can be selected tohave its insulation upgraded such that itseffective RSI would be doubled. Whichshould be selected to achieve the greatestreduction in heat loss?10.015.04.00.5

For the water storage tank, well mixed at internal temperature 60°C Total Exterior surface area =…

A well-mixed, insulated water storage tank is to be maintained at internal temperature 60°C. The environmental temperature around the tank varies from -25°C to 30°C. The tank's exterior surfaces (total = 125 m²) have four different levels of insulation as indicated in the table.

A well-mixed, insulated water storage tank is to be maintained at internal temperature 60°C. The environmental temperature around the tank varies from -25°C to 30°C. The tank's exterior surfaces (total = 125 m²) have four different levels of insulation as indicated in the table.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

11. Change 15°F to degree kelvin Complete FBD, FORMULA, AND SOLUTION
A department store plans to construct a one-story building with a rectangular planform. The building is required to have a floor area of 10,000 f2 and a height of 15 ft. It is proposed to use brick walls on three sides and a glass wall on the fourth side. Use the Lagrange multipliers to find the dimensions of the building to minimize the heat loss, assuming that the relative heat losses per unit surface area for the roof, brick wall, glass wall, and floor are in the proportion 3:2:7:1
A well-mixed, insulated water storage tank is to be maintained at internal temperature 60°C. The environmental temperature around the tank varies from -25°C to 30°C. The tank's exterior surfaces (total = 125 m²) have four different levels of insulation as indicated in the table. Surface Component Area, Effective RSI, 2 2 m². °C/W m² Surface A 60.0 Surface B 30.0 Surface C 30.0 Surface D 5.0 Say that just one surface can be selected to have its insulation upgraded such that its effective RSI would be doubled. Which should be selected to achieve the greatest reduction in heat loss? 10.0 15.0 4.0 0.5
For the pipe network shown, the flow of water from A to the first junction is 2 cubic feet per second. Assuming all pipes have a roughness coefficient of 0.014 L2 D2 Pipe Length, ft Diameter, in Q₂ 1 980 2 490 Li Di SD₁ n = 0.014 3 250 Qs 4 980 L3 D3 LD 5 1480 Which of the following statements is TRUE? The head loss in pipes 1 and 5 are equal. The head loss in pipes 3 and 4 are equal. The headloss in pipe 2, 3 and 4 are equal. The sum of the head loss in pipes 3 and 4 is equal to the head loss of pipe 2. 88852 15 12 2 points Clear selection
Determine the thermal conductivity of brickwork of cavity wall comprising 220mm brickwork, 12mm plaster, 80mm cavity, k values are plaster 0.6W/m°C, cavity resistance 0.18m"C/W, internal resistance 0.12m²"C/W, external resistance 0.06 m"C/W. U value of the wall is 1.78.
100°? air flows through a round aluminum tube of ID 60mm and OD 80mm at 4 ?? .The tube is covered in 5mm thick fiberglass insulation. The tube is surrounded by RT air flowing at 5?? over the outside of the insulation. What is the heat rate through the wall of the tube? Assume that the air temperature is constant throughout the tube. Note: RT is 25 celsius
Civil Please show calculation with all steps
Note:hand written solution should be avoided.
3-Typical asphalt roofing shingles have a thermal conductivity of about 0.79 W/m-k. If the temperature inside the house is 75 F and the temperature outside is 5 F, find the heat flux (the rate of heat transfer divided by the surface area through which conduction occurs ) through a 2 cm thick asphalt shingle roof.
Please choose the correct answer: 1. In water cycle, ______ brings H2O from water in a lake to vapor at atmosphere. A. evaporation; B. evapotranspiration; C. precipitation; D. infiltration 2. A drinking water well in NJ is seriously polluted due to saltwater intrusion. The major pollutant is _____. A. Oxygen demanding materials; B.salts; C. nutrients; D. toxic heavy metals 3. The real reason to cause saltwater intrusion is the different of _____ between freshwater and seawater. A. density; B. temperature; C. velocity; D. all of the above 4. Which of the following represents a non-point pollution source? A. Leaking underground gas tanks; B. CSO; C. urban runoff; D. an outlet of untreated industrial wastewater into a river
A circular duct has an outside diameter of 71⁄2 inches. Insulation that is 11⁄8inches thick is wrapped around the duct. What is the diameter of the insulatedduct?
A well-mixed, insulated water storage tank is to be maintained at internal temperature 60°C. The environmental temperature around the tank varies from -25°C to 30°C. The tank's exterior surfaces (total = 125 m²) have four different levels of insulation as indicated in the table. Surface Component Area, Effective RSI, 2 2 m². °C/W m² Surface A 60.0 Surface B 30.0 Surface C 30.0 Surface D 5.0 Say that just one surface can be selected to have its insulation upgraded such that its effective RSI would be doubled. Which should be selected to achieve the greatest reduction in heat loss? 10.0 15.0 4.0 0.5