A water jet with velocity V jet impinges normal to a moving flat plate with velocity V plate Such that the jet splits equally into two halves as shown in Figure. The jet cross-sectional area is 2 cm?, V jea is 20 m/s and V is 10 m/s and plate density of water is 1000 kg/m³. Consider steady flow and neglect weight of the jet, weight of the plate and frictional losses. The absolute value of the force required to keep the plate moving at constant velocity V plate is N. jet plate

A water jet with velocity V jet impinges normal to a moving flat plate with velocity V plate Such that the jet splits equally into two halves as shown in Figure. The jet cross-sectional area is 2 cm?, V jea is 20 m/s and V is 10 m/s and plate density of water is 1000 kg/m³. Consider steady flow and neglect weight of the jet, weight of the plate and frictional losses. The absolute value of the force required to keep the plate moving at constant velocity V plate is N. jet plate

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: A pipeline has been proposed to carry natural gas 1715 miles from Alaska's North Slope to Calgary,…

A: Solution:

Q: Please show flow assumptions and directions in each loop (hardy cross), and make sure mass is…

A: Flow in each branch is chosen by taking a hypothetical discharge value so that mass is conserved.

Q: Please solve this problem with step by step solutions so I can understand this problem.

A: Step 1: Analyze the diagram.We have a 20-ft long simply supported beam carrying a distributed load…

Q: al plate of 10 mm thickness swing freely about the upp ter of 20 mm diameter impi 50 mm below the…

Q: Estimate the force F exerted by the airflow on the door.

Q: s it important to consider pressure changes when transporting compressible fluids in pipelines? 2.…

Q: An old pipe of diameter 2.5” is carrying water at a velocity of 4 ft/s. Determine the Reynolds…

A: Given: Diameter of pipe, D = 2.5 in Velocity of flow, v = 4 ft/s Length of pipe, L = 200 ft…

Q: | For the conic body shown in Figure (3) which rotating with constant angular velocity of 12 rad/s,…

Q: Free the stack from its confines and compare it to its unrestrained version.

A: The "stack" is a term used in computer science and programming to refer to a section of memory used…

Q: H=81.137 O H=91.137 O H=71.137 C H=61.137 Exz- If the lowrate between two tanks is (o.s m/s), And…

A: To Determine Head loss, H

Q: 2. What is the ratio of maximum velocity to the average velocity when the fluid passes through two…

A: The maximum velocity occurs at the centre. At the centre, the radius is equal to zero. The average…

Q: 1. A balloon rises from the ground with a constant acceleration of 4 ft per sec?. Five seconds…

A: The values given in the question are as follows: Constant acceleration of balloon(a)=4 ft/sec2…

Q: A 0.4 kg rubber ball has a horizontal velocity of 1.554 m/s at point A and goes through a projectile…

A: Horizontal velocity, Initial height, To find: The peak height of the trajectory point.

Q: An engineer claims that flow of SAE 30W oil, at 20°C, through a 5- smooth pipe at 1 million N/h, is…

A: To determine whether the flow is turbulent or laminar we have to calculate Reynold's number. The…

Q: On a rough surface, Daniel pushes a carton with a mass of 30.0kg. The force F that is he applies is…

A: Given:- The mass of the carton = 30 kg The force applied by the Daniel on carton = 608 N The angle…

Q: A plate 0.03 mm distant from a fixed plate, moves at 80 cm/s and requires a force of 4 N per unit…

Q: A 5-micron droplet of water is being carried in. standard air towar a 500-micron drop of water at a…

A: Given: The mass of the droplet (m1) is 5 microns. The mass of the droplet (m2) is 500 microns. The…

Q: A 1:16 scale model of a submarine moving far below the surface of water is tested in a water tunnel.…

A: Given data- 1:16 scale model, Speed of prototype = 8 m/s, To Find- The corresponding velocity of the…

Q: Find final velocity of car U=4.01 m/s a=2 m/s2 t=3 s

A: Introduction : The given question is related with mechanics . In this question we are provided with…

Q: Water is flowing in a 60mm pipe at rate of 15 m3 per hour. what is the maximum velocity of a flow

Q: The principal sources of ground water are O O O O O sediments water O magma O meteoric water O no…

A: Nearly 70 % is total water on the earth surfaces.

Q: A 5 cm diameter horizontal jet of water with a velocity of 30 m/s strikes a flat plate that is…

A: Assumptions: The flow is steady, frictionless, and incompressible water is discharged to the…

Q: What is the velocity (ft/s) of oil in the pipe? What is the Reynolds number?

A: This question has been taken from fluid mechanics

Q: 8. Shown in Figure 4.8 is a small decorative wheel fitted with flat paddles so the wheel turns about…

A: GIVEN : TO CALCULATE : Force exerted on the wheel when it is stationary. CONCEPT : F = Rate of…

Q: A horizontal pipe of cross section 8 cm2 has a constriction of cross section of 2 cm². Gasoline…

A: Calculate the speed in constriction?

Q: According to principle of transmissibility of forces, the effect of a force upon a body is . O al…

A: Solution:- According to the transmissibility's principle- If a force acting on a rigid body is…

Q: A 4 kilogramme block travelling at 6 m/s collides with a 3 kg block moving at 2 m/s in an elastic…

Q: A square block (a x a) in a plan, has a height l and a relative density of 0.8. What would be a…

A: relative density of block=0.8 relative density of water=1.0

Q: 2. Determine the speed of the block if

Q: Which among the following is formula Tor prce when it acts along the direction of flow? O pav Sin²e…

A: To find : Formula force when it acts among direction of flow.

Q: 5-13. Calculate the mg/L of the following: a. 0.2500 M NaOH b. 0.0704 M Na2SO4 c. 0.0340 M K2Cr2O7…

A: To calculate the concentration in mg/L from molarity (M), you need to use the formula: mg/L=M×molar…

Concept explainers

Storm Sewers and Detention

The storm drains system transports rainwater or stormwater and other runoff from roads, parking lots, and roof downpipes directly to nearby creeks, rivers, or the sea without any treatment.

Question

A water jet with velocity.........

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 5 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Which degree deflection angle cause a greater reactive force when a jet of water strikes a deflector? The 30-degree angle or 90? Explain to justify.
EXPLAIN BRIEFLY THE TWO TYPES OF REVOLVING FIELD IN ACCORDANCE OF ITSCONSTRUCTION.
Please answer completely
I need the answer as soon as possible
Need within 1hr pls, thanks A cylinder rolls without slipping at such instant. it has velocity of 2 m/s from center and acceleration of 3.5 m/s^2 Radius is 0.8 m. determine the position of the instantaneous center of zero velocity.
A container for an emergency beacon is a rectangular shape 31.75 in wide, 40.55 in long, and 20.20 in high. Its center of gravity is 9.55 in above its base. The container weighs 253 lb. Required Calculate ymc to the nearest 100th of an inch. Also state if the box will with the 31.75-in by 40.55-in side parallel to the surface in plain water is STABLE or UNSTABLE in the units box.
PLEASE HELP!!
Describe about the aquitards or preventors of flow.
A flat plate of area 2.5 x106 mm² is pulled with a speed of 0.6m/s relative to another plate located at a distance 0.15 mm from it. Find the force and power required to maintain this speed, if the fluid separating them is having viscosity as 0.2 Ns/m².
a) Determine the force required to just submerge a Size 5 soccer ball (assume 9" diameter) in a swimming pool. Neglect the weight of the soccer ball material & air inside. b) Determine the force required to just submerge a 3ft diameter beach ball in a swimming pool. Neglect the weight of the beach ball material & air inside. c) Do the same calculations for submerging the soccer ball and beach ball but this time in a vat filled with mercury. d) Compare the forces and explain your results.
I need the answer as soon as possible