A vertical U-tube with two legs 2 m apart is filled with water and rotated about a vertical axis 0.5 m from one leg. The differenco in elevation of water levels in the two legs, open to almosphere, when the speed of rotation is 45 rpm is, nearly.

A vertical U-tube with two legs 2 m apart is filled with water and rotated about a vertical axis 0.5 m from one leg. The differenco in elevation of water levels in the two legs, open to almosphere, when the speed of rotation is 45 rpm is, nearly.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: The pressure intensity for a inclined plate is maximum on the surface of the earth and decreases as…

A: Pressure intensity increases as we move from earth's surface to to the centre of the earth, while it…

Q: A half parabolic gate 3m in tall and 1m wide is submerged and there are two different liquid on each…

A: Given- hg=3mb=1mGL=0.85GR=1.00

Q: An open tank contains water upto a depth of 1.5 m and above it an oil of sp. gr. 0.8 for a depth of…

Q: immersion is such that the center of pressure on the plate is 8cm from its center of gravity.…

A: This question is from Fluid mechanics

Q: Determine the depth of a liquid needed to create a pressure difference of 225 kPa if the liquid is…

A: Determine the depth of a liquid needed to create a pressure difference of 225 kPa if the liquid is…

Q: 1. Water is to be delivered from a reservoir through a pipe to a lower level and discharged into the…

Q: Find the (i) slope of the liquid surface, (i) Pressure at B, for the liquid contain subjected to…

Q: an open circular vessel is 1m in diameter and 2m in height. it contains water filled to a depth of…

Q: A vertical U-tube with two legs 2 m apart is filled with water and rotated about a vertical axis 0.5…

Q: water flows through an orifice at the vertical side of large tank under a constant head of 2.4 m.…

Q: 900N/m 1.1m 1.3m + 750N/m 1.1m

A: Loading and dimensions are given There will be reactions and moments at 2 fixed supports Form…

Q: A rectangular channel carrying supercritical stream is to be provided with a hydraulic jump type of…

Q: Air at 20°C flows over a very large bank of 2 cm OD tubes that are kept at 100°C. The air flow is…

A: We have to determine the value of h on the first tubes and on the tubes deep in the array if the air…

Q: An orifice is located in the side of a tank with its centre 10 cm above the base of the tank. The…

A: Given-Height of orifice h=10 cm=0.10 m,Water level height H=1 m,Coefficient of velocity C=0.98,We…

Q: Q.I Arigid horizontal bar of negligible mas is Conected to two vods as shown in fig If w = 15 kg the…

Q: Pressure in a pipe carrying oil (Specific Gravity 0.92) is 20 kN/m². A piezometer is connected to…

A: Given data : Pressure (P)=20 KN/m2Specific gravity (S.G)=0.92Density of water (ρWater)=1000 kg/m3

Q: he side of a square plane surface is 0.51m and to be placed vertically below the water surface. The…

A: The centre of pressure of a vertical surface submerged in water is given by h*=IGAh-+h- where…

Q: Water at four-degree Celsius flows through a pipe that has a conical shape and is sloping downward;…

A: given data: point 1: pressure (P1)=3×105 Paspeed (V1)=1 m/s density of water at 4∘c=1000 kg/m3

Q: Oil flows through a small standard 25m diameter orificce under a head of 5.4 m at the rate of…

Q: The pressure at point m in the figure shown was increased from 85 kPa to 125 kPa. This causes the…

A: Given, P1 = 85 KPa P2 = 125 KPa movement of Hg in sloping tube = 28 mm = 0.028 m let the change in…

Q: Determine the total headloss in the system. C=120 and flowrate is 0.20m3/s CHOICES: a.16.40,…

Q: a 100mm height cylinder with specific weight of 5kn/m^3 is submerged ina a a fresh water with…

Q: Water flows through an orifice at the vertical side of a closed cylindrical tank. The water level…

Q: 2. Use Virtual Work Method to calculate the deplection at C for the frame shown in the accompanying…

Q: a. Calculate the maximum positive value of shear force at K. 2.6 kN 2.8 KN 2.4 KN 3.2 kN

Q: The cross section of a trapezoidal channel is shown. Side slopes are 2V:3H and the discharge is 30…

Q: 7. The pressure intensity for a horizontal plate is maximum on the surface of the earth and…

A: Surface of earth is geoid i.e. Earth like and acceleration due to gravity (g) is 9.81 m/s2 at…

Q: A closed tank 2m high and 1m in diameter contains 1.5 m water. The air in the space above water is…

A: Following are the given information. Closed tank height =2 m Closed tank diameter =1.0 m Height of…

Q: 8-89 Water at 15°C is drained from a large reservoir using two horizontal plastic pipes connected in…

A: We have to detemine the dscharge rate from the reservoir.

Q: Problem An open circular tank of 20 cm diameter and 100 cm long contains water upto a height of 60…

A: Given Diameter of cylinder D=20 cm, Hence, R=10 cm, Length L=100 cm, Height H=60cm, Speed N=300…

Q: A 0.9 m diameter vertical cylindrical tank which is 1 m high and is open to the atmosphere contains…

A: Given data:- Diameter of the cylindrical tank (): 0.9 m- Radius of the cylindrical tank (): = 0.45…

Q: A vertical U-tube with two legs 2 m apart is filled with water and rotated about a vertical axis 0.5…

Q: Q:-Determine the force exerted on the cone curved surface. The liquid in the tank has a specific…

Q: The pressure in the air space above the surface of oil (SG = 0.78) in a closed tank is 125 KPa…

A: As Pabs = PGAGE + PATM SO, PGAGE = 125 - 101.325 = 23.675KPa

Q: Water flows through an orifice at the vertical side of a large tank under a constant head of 2.2.…

A: Head, H=2.2 m y=1.5 m Assume coefficient of velocity, Cv=0.98

Q: If the pressure in the tank of oil (sp gr 0.80) is 60 psi, what is the equivalent head in feet of…

A: Note... 1 psi= 6894.757 N/m2 1 m = 3.28084 ft.

Q: Determine the horizontal component of the total hydrostatic force (kN) the oil exerts on the face AB…

A: Given: Overhang, 1.883m long Find: Horizontal component of the total hydrostatic force

Q: vertical 150 mm pipe leaves a water tank of surface elevation 24. Between the tank and elevation 12,…

A: Fluid flow rate measurements are a related application of Bernoulli's principle. The Venturi effect…

Q: 3.) Determine the total pressure and center of pressure on a circular plate of diameter 3700mm which…

A: The pressure force on a submerged body is equal to product of pressure at centroid and area of body.…

Q: A vertical water jet is issuing upwards from a nozzle with a velocity of 10 m/s. The nozzle exit…

Q: 8 kN/m 12 kN m OB – 5m- - 3 m

A: Derive equations for shear and bending moment and draw SFD and BMD

Concept explainers

Pressurized pipe flow

A 15-kilometer-long pipe with a pipe diameter of one meter transports water at a speed of one meter per second. The pipe has a friction coefficient of 0.005. Calculate the frictional head loss?

Question

A vertical U-tube with two legs 2 m apart is filled
with water and rotated about a vertical axis 0.5 m
from one leg. The differenco in elevation of water
levels in the two legs, open to almosphere, when
the speed of rotation is 45 rpm is, nearly.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

) Water flows through a vertical contraction (venturi) section. Piezometers are attached to the upstream pipe and minimum area section as shown. The velocity in the pipe is V= 24 m/s. The difference in elevation between the two water levels in the piezometers is d = 33 cm. What is the velocity (m/s) at the minimum area? レ 24 m1S d= 33 cmm
I need the answer as soon as possible
3. Under a constant head of 3.2 meters, water flows through an orifice on the vertical side of a huge tank. 1 m below the orifice, how far horizontally from the vena contracta will the jet contact the ground?
An open, clean glass tube is inserted vertically into a pan of water. What tube diameter is needed if the water level in the tube is to rise one tube diameter (due to surface tension)? The contact angle is 0 and ss = 0.073 N/m
Hydraulics problem
A vertical tube 4 meters long with one end closed is immersed vertically with the open end down into a tank of water until the open end is submerged to a depth of 2 meters. Assume atmospheric pressure is 101.5 kPa. Which nearly gives the height of water inside the tube in meters? а. 0.5 ОЬ. 1.6 Ос. 0.8 O d. 1.1
A 2.8 - m square plate is immersed in water in a vertical position such that the two edges of the square are horizontal. The immersion is such that the center of pressure on the plate is 8cm from its center of gravity. Determine the distance from the water surface to the center of pressure. (A) 7.67m B 8.67m 9.21m 8.25m D
Water flows through a pipe at 150 L/s that changes gradually in diameter from 165 mm at point A to 473 mm 4.3 m higher than at point A and B are at point respective pressures 49.8 kPa. В. В is point A. The 72 КРа and Determine the head loss of the pipe. а. b. Determine the total energy at point B with datum at point A. Determine the total energy at point A with datum at C. point A.
A vertical rectangular plane surface is submerged in water such that is top and bottom surface are 1.5 m and 6.0 m respectively below the free surface. The position of centre of pressure below the free surface will be at a distance of
The specific energy for a 5 m wide rectangular channel is to be 4 Nm/N. If the rate of flow of water through the channel is 20~m^{3}/s. determine the alternate depths of flow.
The total pressure or pressure intensity is not zero for any point on inclined surface in space.