Oil flows through a small standard 25m  diameter orificce under a head of 5.4 m at the rate of 0.0031 m3/s. The jet strikes a wall 1.52 m away and 0.119 m vertically below the centerline of the contracted section of the jet. Compute the coefficient of velocity

Q: Water is flowing into a frustum of a conical vessel 2 m high at 100liters per minute. The vessel has…

A: To determine the height of water when the water surface is rising at 25.72 mm/min.

Q: Water at 20°C flows through a 300-mm-diameter pipe that discharges into the atmo- sphere as shown in…

A:

Q: Laminar flow of a fluid of viscosity 0.883 Ns/m² and specific gravity 1.26 occurs between a pair of…

A: Fluid of viscosity,  = 0.883 Ns/m2The plate distance, b = 10 mm=0.01 mSpecific gravity = 1.26Upper…

Q: plate moves 10 cm/s to the right is 0.5 cm above a stagnant wall. The fluid bet. the plate and the…

A:

Q: pipe (d = 80 mm). I pe is 2000 kN/m² th um velocity. flow of oil. ictional drag over 1 tress at 10…

A:

Q: Q4. 30 m height water backs up behind a 36 m height concrete dam. Leakage under the foundation gives…

A:

Q: A siphon consisting of a 3 cm diameter tube is used to drain water from a tank. The outlet end of…

A:

Q: An orifice maintains its head at 2.25m determine the actual velocity knowing that Cc= .9 and C=.96…

A:

Q: A 75 mm diameter orifice discharges 0.023 m/s of liquid under a head of 2.90 m. The diameter of the…

A:

Q: A conical funnel has radius 4 cm and height 8 cm. A liquid is draining from the funnel at a constant…

A: Draining rate (Q) = 1.3 cm3/sRadius of cone (R) = 4 cmHeight of cone (H) = 8 cm(a) Depth of the…

Q: Piston A has a cross-section of 1200 cm^2 while that of B is 800 cm^2. B is higher than A by 2m. If…

A: Force: The movement or change in the motion of the component due to applied external action on a…

Q: A small pipe 0.60 m long is filled with water and capped at its ends. If placed in a horizontal…

A:

Q: A cubical tank of 0.5 side is filled with Hg with specific gravity 13.6, find the pressure on the…

A: Cubical tank side a=0.5 m SG =13.6 Acceleration A=0.5g, Pressure on the side of the tank=?

Q: Water is flowing through a tube with the constant surface area as shown in the Figure Q2. 150 kPa 2…

A: Friction factor = 0.025 Velocity = 1.5 m/sec Viscosity of water ,μ = 8.9 x 10-4 Pa.s Length of flow…

Q: An upward flow of oil (mass density 800 kg/m°, dynamic viscosity 0.8 kg/m-s) takes place under…

A: Mass density of fluid (ρ) = 800 kg/m3 Dynamic viscosity (μ) = 0.8 kg/m-s Diameter of pipe (D) = 0.1…

Q: 1. The piston at A has a cross-sectional area of 600 cm² while that of B is 100 cm². The difference…

A: Area of piston at point A, (AA) = 600cm2 = 600 × 10-4 m2 at point B, (AB) = 100cm2 = 100 × 10-4 m2…

Q: 2. A closed vertical cylindrical vessel, 1.50m in diameter, 3m high is 8/10 full of liquid (SG=1.03)…

A:

Q: An upward flow of oil (mass density 800 kg/m³, dynamic viscosity (0.8 kg/m-s) takes place under…

A:

Q: An upward flow of oil (mass density 800 kg/m³, dynamic viscosity 0.8 kg/m-s) takes place under…

A: Given- Mass density = 800 kg/m3 Dynamic viscosity=0.8 kg/m-s Pressure at sections 1 and 2 are- 435…

Q: A sharp edged orifice 152mm in diameter discharges oil under a head of 1.04m. The average velocity…

A:

Q: 3 Water flows in a horizontal tube 150 m long and 16 cm in diameter at a speed of 0.1 m/s. Note that…

A:

Q: An upward flow of oil (mass density 800 kg/m³, dynamic viscosity (0.8 kg/m-s) takes place under…

A: Given data  Density of oil = 800 kg/m3 Dynamic viscosity= 0.8 kg/ms  Diameter of pipe (D) = 0.1 m…

Q: A pipe carries an oil of specific gravity 0.8 with pressure 19.62 kPa. The pipe is 3.5 m above datum…

A:

Q: 7. For the Pitot Tube below, determine the height that the fluid rises, L, in the column if water is…

A: Velocity of flow through pitot tube is given and it has been asked to determine height of fluid…

Q: A 50 mm diameter siphon discharges oil (SG=0.88) from a reservoir (elev. 20m) into open air (elev.…

A:

Q: Air of M =2 and P = 75 kPa flow on a wedge (total angle 20°). Calculate the two oblique shock angles…

A:

Q: Situation: Gas flows in a round conduit that tapers to a smaller diameter. D₁ = 1.1 m, D2 = 0.56 m,…

A: Given data  -D1 = 1.1 mD2 = 0.56 m V1 = 16 m/s p1 = 2.0 kg/m3  p2 = 1.8 kg/m3  Find out - Mean…

Q: An upward flow of oil (mass density 800 kg/m³, dynamic viscosity (0.8 kg/m-s) takes place under…

A: Solution: Given: mass density, ρ = 800 kg/m3 dynamic viscosity, μ = 0.8 kg/m-s pipe diameter, D =…

Q: 'Z Book L2 - Fig P 35 10

A: step 1-

Q: Problem P68 (6) Let's extend the previous problem. In our lectures, all the momentum problems…

A: The problem is given in the above figure.  Data given,  Pressure at section 1 = 100 KPa = 100 kn/m2…

Q: A plate moves 10 cm/s to the right is 0.6 cm above a stagnant wall. The fluid bet. the plate and the…

A:

Pressurized pipe flow

A 15-kilometer-long pipe with a pipe diameter of one meter transports water at a speed of one meter per second. The pipe has a friction coefficient of 0.005. Calculate the frictional head loss?