An upward flow of oil (mass density 800 kg/m³, dynamic viscosity (0.8 kg/m-s) takes place under laminar conditions in an inclined pipe of 0.1m diameter as shown in the figure. The pressures at sections 1 and 2 are measured as p₁ = 435 kN/m² and p₂ = 200 kN/m². 2- 45° 5m F5 egia s The discharge in the pipe is equal to

Q: Given the following information about a length of pipe: P1 = 440 kPa V1 = 0.0085 m/s z1 = 5 m v2 =…

A: Applying Bernoulli`s equation between point 1 and 2 in the given pipe flow:…

Q: Water flows from the tank shown in the figure below. At a depth of 1.5 ft the rate of change of…

A:

Q: The pressure heads are measured at two sections in a pipeline and are found to be 8.3 m at point A…

A: Step 1: Step 2: Step 3: Step 4:

Q: Review the three cases of flow through porous media shown below. For each case, consider and…

A: This is a question about Darcy’s law, which describes the flow of a fluid through a porous medium.…

Q: P1 =346 kPa D; =0.12 m P2 107 kPa D2 43 m

A:

Q: uid mechan

A: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question and…

Q: An upward flow of oil (mass density 800 kg/m³, dynamic viscosity (0.8 kg/m-s) takes place under…

A:

Q: An upward flow of oil (mass density 800 kg/m³, dynamic viscosity (0.8 kg/m-s) takes place under…

A: Given data  Density of oil = 800 kg/m3 Dynamic viscosity= 0.8 kg/ms  Diameter of pipe (D) = 0.1 m…

Q: The gauge pressure of water at A is 150.5 kPa. Water flows through the pipe at A with a velocity of…

A:

Q: Glycerin at 20 °C flows upward in a vertical 75-mm-diameter pipe with a centerline velocity of 3.8…

A: i hope its helpfull.thank you.

Q: In a smooth pipe of uniform diameter 30 cm a pressure of 60 kPa was observed at section 1 which was…

A:

Q: The water tank has a rectangular crack on its side having a width of 100 mm and an average opening…

A: width of crack (wc) = 100 mmopening of crack (Lc) = 0.1 mmT=20o CLength of crack (L) = 200 mmh=2 m

Q: 9.95. The mean velocity of water in a 150 mm horizontal pipe is 0.9 m/s. Calculate the loss of head…

A: Given, Diameter of the pipes= 150mm and 50mm Velocity in the 150mm pipe, v2= 0.9m/s Pressure in the…

Q: A straight pipe AB, of length 10 m, tapers from a diameter of 40 cm at A to 20 cm at B. The centre…

A:

Pressurized pipe flow

A 15-kilometer-long pipe with a pipe diameter of one meter transports water at a speed of one meter per second. The pipe has a friction coefficient of 0.005. Calculate the frictional head loss?