A closed cylindrical tank 2m in diameter and 7m high has 3m tall of water and 3m of oil (SG = 0.8). The surface of oil is %3D under a pressure of 40 KPa. The orifice is located at the vertical side of the tank and it is 1m above the bottom of the tank. If the jet strikes the ground 1.5m below the vena contracta and Cv = 0.92, determine a) the theoretical velocity and b) The horizontal distance from the vena contracta to the point where the jet strikes the ground. (This is a multiple answer question. You must have 2 selected choices since there are 3 required answers in the problem)

Q: = constant 5. Bernou lli's equation is expressed as asY'2g Research on the corresponding units por…

A:

Q: Given an element with stresses as indicated in figure below, find the following: a) The maximum and…

A: Find:a) The maximum and minimum principal stressesb) The maximum shear stress, and the average…

Q: a) The maximum and minimum principal stresses b) The maximum shear stress, and the average normal…

A: ###Determination of given parts question of a stress system ### Principle stresses ###

Q: Rigid bar ABCD is loaded and supported as shown. Steel [E = 30600 ksi] bars (1) and (2) are…

A:

Q: AMPLE PROBLEM Determine the force in members BC, BF, GF. Determine the force in members CH, FH, FE.…

A: To find force in the members GF,BC,BF,FE,CH,FH

Q: a. Name three practical structural applications in ocean engineering when employing beam theory is…

A: Note: We'll answer the first question since the exact one wasn't specified. Please resubmit a new…

Q: The 34-kg crate is stationary when the force P is applied. Determine the resulting acceleration of…

A:

Q: If the body forces acting on the body are zero. Using the stress-strain relations and strain…

A:

Q: A uniform beam of length L carries a concentrated load wo at x = =(x-4). y(x) = Elday dx4 subject to…

A:

Q: In your words, discuss the strengths and limitations of the Bishop’s (1959) equation

A:

Q: Ultimate strength is the highest ordinate in the tress-strain diagram.

A: Power can be defined as energy divided by time. The unit of power is watt. Power and time are…

Q: The beam below supports 3-point loads. The beam is supported by a pin at A and a roller at D. a)…

A:

Dimensional homogeneity

The term dimensional homogeneity means that in an equation, the dimensions of each term on both sides are equal, which means the dimensions of the left-hand side (LHS) of an equation are similar to the dimensions of the right-hand side (RHS). For a dimensionally homogeneous equation, the powers of fundamental dimensions will be identical on both sides of the equation.