A vertical summit curve was designed to connect two intersecting tangents. Elevation PVC = 250.55m, elevation PVI = 256.55m and elevation PVT = 252.35 m. The length of curve is 240m. PVC L/2 PVL midpoint L/2 PVT 18. Determine the location of the highest point measured from the PVC. a) 165.23 m b) 151.58m c) 189.56m 19. Determine the elevation of the midpoint of curve. a) 225.67m b) 253.80m c) 245.45m d) 134.57m d) 234.56m

A vertical summit curve was designed to connect two intersecting tangents. Elevation PVC = 250.55m, elevation PVI = 256.55m and elevation PVT = 252.35 m. The length of curve is 240m. PVC L/2 PVL midpoint L/2 PVT 18. Determine the location of the highest point measured from the PVC. a) 165.23 m b) 151.58m c) 189.56m 19. Determine the elevation of the midpoint of curve. a) 225.67m b) 253.80m c) 245.45m d) 134.57m d) 234.56m

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A 800ft vertical curve has its PVI at elevation 232.25ft. The initial and final grades are 3.7% and -5% respectively. Determine the elevation of a point 349ft from PVC.
Draw the figure if necessary. Show complete formulas and solutions. Round off to 3 decimal places.
Please I need to solve the question
Please all parts answer..
I need the answer as soon as possible
Note: Solve and draw
A 600ft vertical curve has its PVI at elevation 264.96ft. The initial and final grades are 2.1% and -4.2% respectively. Determine the elevation of a point 422ft from PVC. Round your answer to 3 decimal places.
a horizontal curve has a design speed of 45 mph the curve must have a radius of 750 ft if f= 0.12 what should be the superr elevation? please show all step
The reduced level at the intersection of a rising gradient of 1.7% and a falling gradient of 2.3% on a proposed road is 52.50m. Given that K value is 55. The throught chainage of the intersection point is 4020m and proposed vertical curve is to have equal tangent. As a civil engineering you are required to prepare the following vertical curve design calculations : A) The through chainage of the points of the vertical curve if the minimum required length is to be used (LV) and the vertical curve setting out data at 20 metres interval. b) The chainage and reduced level of the highest point on the curve. c) Through chainage at highest point was located exactly under a bridge, if the RL of soffit is 57.42m, calculate the headroom based on proposed vertical curve design.
A sag Vertical curve has a profile elevations @ BC and at distance L/2 are 206 and 202.5 m respectively and the PI elevation is 200 m. Find the following elevation at. a) 0.25L b) 0.75L c) EC Find the Station and elevation of the lowest point.