A vertical pipe, closed at the bottom end, is filled to a depth of 1.00 m with water and then an amount of oil of density 0.800 x 103 kg/m³ is added to make the total depth 2.00 m. The oil and water don't mix with the oil floating on top of the water. What is the increase in pressure at the bottom end of the pipe as a result of adding the fluids? Edit View Insert Format Tools Table 12pt v Paragraph v BIU 品总

A vertical pipe, closed at the bottom end, is filled to a depth of 1.00 m with water and then an amount of oil of density 0.800 x 103 kg/m³ is added to make the total depth 2.00 m. The oil and water don't mix with the oil floating on top of the water. What is the increase in pressure at the bottom end of the pipe as a result of adding the fluids? Edit View Insert Format Tools Table 12pt v Paragraph v BIU 品总

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Related questions

Q: Water is flowing in a pipe with a varying cross-sectional area, and at all points the water…

Q: Most towns use a water tower to store water and provide pressure in the pipes that deliver water to…

A: Given data: Mass of the water, m=6.00×105 kg Height of the Smith’s house, h=7.00 m H=18.0 m Density…

Q: A horizontal segment of pipe tapers from a cross-sectional area of 43.5 cm² to 0.500 cm². The…

Q: A cylindrical container with a cross-sectional area of 69.2 cm? holds a fluid of density 776 kg/m3.…

A: Data Given , Cylindrical Cross-sectional area ( A ) = 69.2 cm2 = 69.2 × 10-4 m2 Fluid density ( ρ…

Q: An unknown liquid flows smoothly through a 6.0-mm-diameter horizontal tube where the pressure…

A: Given data: Initial diameter of the tube, di=6 mm=6×10-3 m Initial pressure gradient, ∆pLi=420 Pa/m…

Q: Question 1. A mouse of mass m and an elephant of unknown mass stand on the right and left hand side,…

Q: A horizontal water pipe goes from a large diameter to a small diameter and then back to the first…

Q: 5 The tube shown in the figure below is called Venturi tube which can be used as a fluid flowmeter.…

A: (a) Using equation of continuity,

Q: A horizontal segment of pipe tapers from a cross-sectional area of 48.3 cm to 0.500 cm. The pressure…

A: Given data: Area of cross section of one of the larger end of the pipe is, A1 =48.3 cm2 = 0.483 m2…

Q: Most towns use a water tower to store water and provide pressure in the pipes that deliver water to…

Q: Fresh water moves at a constant speed through a pipe. The pipe bends upward, but the diameter does…

Q: D ▷ D ********** A fluid with specific weight 321b/ft³ flows through the pipe below as it narrows…

A: The objective of this question is to find the difference in heights in the barometer attached to the…

Q: 12 point VA VB An unknown fluid flows through a horizontal pipe with a decreasing square cross…

A: Given : The velocity of the fluid at the point A is vA = 4.7 m/s and the cross-section is…

Q: A boat whose mass is 5000 kg is floating on the surface of the water where Question 6 1/4 of its…

A: Solution:-Given thatmass of boat (mb)=5000 kgSubmerged volume of boat (Vs)=14×total Volume of boat…

Q: The cross-sectional area of a hypodermic syringe is 3.0 cm² and that of the needle, 0.6 mm². What…

A: Write the given values with the suitable variables. As=3 cm2=3×10-4 m2An=0.6 cm2=0.6×10-4 m2P=12 mm…

Q: The pipe goes up to the second floor of the building, 2.0 m higher, and the pressure remains…

Q: The lower portion of a vertical pipe, shown in the diagram below, has a radius of 12.0 cm until it…

A: Given:radius of lower portion, r1 = 12.0 cm = 0.12 mradius of upper portion, r2 = 8.00 cm = 0.08…

Q: Water is pumped into a pipe at 5 times atmospheric pressure. (Strictly speaking, this is the…

Q: Most towns use a water tower to store water and provide pressure in the pipes that deliver water to…

A: The pressure P at a distance h beneath the water surface at the vented top of the water tower is P=…

Q: Water at a gauge pressure of P = 3.8 atm at street level flows into an office building at a speed of…

A: Ans:- Image-1

Q: Invalid path. A 1.05-kg beaker containing 1.99 kg of oil (density = 916.0 kg/m) rests on a scale. A…

A: density of iron = 7800 kg/m3volume of iron block = mass/density = 1.98/7800 = 0.000253846…

Q: Question 5 A pipe has a radius of 10 cm, and the fluid flowing through this pipe is 15 m/s. The pipe…

A: As per Bernoulli's principle during a fluid motion, an increase in the speed of fluid will cause a…

Q: The depth of water behind the Hoover dam is 393 m. The density of water is 1,000 kg/m³. What is the…

A: Given Depth h = 393 m Density = d = 1000 kg/m3 Acceleration due to gravity g = 9.8 m/s2

Q: Most towns use a water tower to store water and provide pressure in the pipes that deliver water to…

Q: The human lungs can T function satisfactorily up to a limit where the pressure differ- ence between…

A: Calculate the pressure difference between the outside and inside of the lungs.…

Q: 1. The 3 cm diameter water pipe in the figure splits into two 1 cm diameter pipes. All pipes are…

A: Since the pipe is split into two equal dia pipes flow will be equal in both small dia…

Concept explainers

Variation of pressure

From the equation of pressure, pressure is directly proportional to the applied force.

Question

A vertical pipe, closed at the bottom end, is filled to a depth of 1.00 m with water and then an amount of oil of
density 0.800 x 10 kg/m is added to make the total depth 2.00 m. The oil and water don't mix with the oil
floating on top of the water. What is the increase in pressure at the bottom end of the pipe as a result of adding
the fluids?
Edit View
Insert
Format Tools Table
12pt v
Paragraph v
BIU
T? v
总
...

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Water flows from the pipe shown in the figure with a speed of 7.0 m/s. (Figure 1) Figure 10 cm² Open 5.0 cm² 4.0 m 1 of 1 Part A What is the water pressure as it exits into the air? Express your answer with the appropriate units. p = Submit Part B Value h = Request Answer What is the height h of the standing column of water? Express your answer with the appropriate units. Submit Value Provide Feedback LA Units Request Answer ? Units ?
Solve
The gauge pressure in a balloon in measured by means of an open-tube manometer that uses water (density = 1.00 x 10° kg/m'). What gauge pressure p is indicated by a difference of 0.0151 m in the heights of the water columns? Pa
You find an antique car jack like the one shown in the figure at an estate sale. After cleaning it up, you establish that the amount of friction is negligible and that the input and output pistons have a diameter of 0.30 in. and 1.9 in., respectively. Determine the force F needed to support a 1000-lb load at the output piston. 24.9 × Does the oil in the hydraulic system of the jack obey Pascal's Law? How is the pressure provided by the oil at the output piston related to the pressure applied to the oil at the input piston? Can you write an expression for the input and/or output force in terms of the input and/or output pressure and the appropriate area? Notice that the construction of the jack makes the point where the jack handle is attached to the jack base a convenient pivot point about which to determine the torques. lb 1000 lb 3.0 in. 12 in.- input piston output piston
A horizontal segment of pipe tapers from a cross-sectional area of 44.6 cm2 to 0.500 cm2. The pressure at the larger end of the pipe is 1.30 × 105 Pa, and the speed is 0.0400 m/s. What is the pressure at the narrow end of the segment? ___Pa
Assume that the left side of your heart creates a pressure of 121 mm Hg by exerting a force directly on the blood over an effective area of 16.0 cm2. What force (in N) does it exert to accomplish this? N
Water flows through a pipe that gradually descends from a height of 6.78 m to the ground. Near the top, the cross-sectional area is 0.4 m2, and the pipe gradually widens so that its area near the ground is 0.8 m2. Water leaves the pipe at a speed of 16.8 m/s. What is the difference in the water pressure between the top and bottom of the pipe? Your response differs significantly from the correct answer. Rework your solution from the beginning and check each step carefully. Pa Need Help? Read It