D ▷ D ********** A fluid with specific weight 321b/ft³ flows through the pipe below as it narrows from a diameter of 4-8 in to diameter of 2.9gin. The fluid has an inlet velocity of 0.7ft /s measure the pressure A fluid with specific weight 841b/ffs is used to points A and B. Find the difference in heights in the barometer attached of barometer, hi-ha Report your result in inches to hi S A. 4 K 'B A₂ h₂

D ▷ D ********** A fluid with specific weight 321b/ft³ flows through the pipe below as it narrows from a diameter of 4-8 in to diameter of 2.9gin. The fluid has an inlet velocity of 0.7ft /s measure the pressure A fluid with specific weight 841b/ffs is used to points A and B. Find the difference in heights in the barometer attached of barometer, hi-ha Report your result in inches to hi S A. 4 K 'B A₂ h₂

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

A scale reads 97 N when a piece of aluminum is hanging from it. What does it read when it is lowered so that the aluminum is submerged in water? The density of alluminum is 2700 kg/m3 Use g = 9.8 m/s2 Calculate answer to two decimals.
Determine the pressure at the bottom of a drum 0.50m deep and filled with water.
d
The gauge pressure in a balloon in measured by means of an open-tube manometer that uses water (density = 1.00 x 10° kg/m'). What gauge pressure p is indicated by a difference of 0.0151 m in the heights of the water columns? Pa
What would be the behavior of an object that was immersed in a fluid if the object and the fluid had the same density? Explain.
A liquid-filled tube called a manometer can be used to measure the pressure inside a container by comparing it to the atmospheric pressure and measuring the height of the liquid. Such a device (filled with water) is shown in the figure, measuring the pressure inside a balloon filled with an unknown gas. The water level on the side of the manometer which is open to the air is 22.3 cm higher than on the side connected to the balloon. a) Find the gauge pressure in the balloon, in units of Pa. Recall the density of water is 1000 kg/m3. b) Find the absolute pressure in the balloon, in units of Pa.
2. Find the work done in pumping out all fluid of density 3 kg/m³ in the tank from a small hole at the top of the conical tank shown below. You may assume that the acceleration due to gravity is g = 10 m/s?. 2 m water exits 6 m²