You find an antique car jack like the one shown in the figure at an estate sale. After cleaning it up, you establish that the amount of friction is negligible and that theinput and output pistons have a diameter of 0.30 in. and 1.9 in., respectively. Determine the force F needed to support a 1000-lb load at the output piston.24.9×Does the oil in the hydraulic system of the jack obey Pascal's Law? How is the pressure provided by the oil at the output piston related to the pressure applied to theoil at the input piston? Can you write an expression for the input and/or output force in terms of the input and/or output pressure and the appropriate area? Noticethat the construction of the jack makes the point where the jack handle is attached to the jack base a convenient pivot point about which to determine the torques. lb1000 lb3.0 in.12 in.-input pistonoutput piston

Step 1: Given,Diameter of input pistondi=0.30inArea of input…

Answered: You find an antique car jack like the…

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

A water intake at a pump storage reservoir (see the figure below) has a cross-sectional area of 0.637 m². The water flows in at a speed of 0.470 m/s. At the generator building, at distance D = 156 m below the intake point, the cross-sectional area is smaller than at the intake and the water flows out at 9.44 m/s. What is the difference in pressure between inlet and outlet? Reservoir Number 202.6 Units D Intake MPa Generator building Outlet-
Asap plzzx
2c please
▾ Part A What gauge pressure must a pump produce to pump water from the bottom of the Grand Canyon (elevation 730 m) to Indian Gardens (elevation 1370 m)? Express your result in pascals and in atmospheres. Pgauge 6.27x108 Pa Submit ✓ Correct Part B Pgauge= Previous Answers Submit VΓΙΑΣΦ Request Answer ? atm
Solve
Water is pumped through a vertical 5.0 cm cement-lined steel pipe to an elevated tank on the roof of a building. The measured pressure at the discahrge side of the pump is 1380 kPa. What pressure can be expected at a point in the pipe 76 m above the pump when the flow is 9.5 L/s? Use f= 0.023 Include your free body diagram. a.100 kPa b.225 kPa c.150 kPa d.75 kPA
Assume that the left side of your heart creates a pressure of 121 mm Hg by exerting a force directly on the blood over an effective area of 16.0 cm2. What force (in N) does it exert to accomplish this? N
As shown in the figure below, a hydraulic system has two pistons of different diameter and uses a liquid of density p = 850 kg/m³. The smaller piston has a diameter of 4.7 cm and a mass of 1.6 kg and the larger piston a diameter of 14 cm and a mass of 2.8 kg. Determine h, the height difference between the two pistons. m
Water flows through a pipe that gradually descends from a height of 6.78 m to the ground. Near the top, the cross-sectional area is 0.4 m2, and the pipe gradually widens so that its area near the ground is 0.8 m2. Water leaves the pipe at a speed of 16.8 m/s. What is the difference in the water pressure between the top and bottom of the pipe? Your response differs significantly from the correct answer. Rework your solution from the beginning and check each step carefully. Pa Need Help? Read It
You are trying to lift a car to change a tire using a hydraulic jack. You apply a force of 57 N to the input piston who's diameter is d1. As a result, the output piston, which has a diameter d2, applies a force to the car. The ratio d2/d1 has a value of 7.2. Ignore the height difference between the input piston and output piston and determine the force that the output piston applies to the car.
Two identical containers are open at the top and are connected at the bottom via a tube of negligible volume and a valve that is closed. Both containers are filled initially to the same height of 1.00 m, one with water, the other with mercury, as the drawing indicates. The valve is then opened. Water and mercury are immiscible. Determine the fluid level in the left container when equilibrium is reestablished. Number Units Water Valve Mercury 100 m 4
Air P = 76 kPa SG₁ = 13.55 40 cm 22 cm Consider a dual-fluid manometer attached to an air pipe as shown in the image. If the SG of one fluids is 13.55, determine the SG of the other fluid for the indicated absolute pressure of air. Take the atmospheric pressure to be about 100 kPa. SG₂

Recommended textbooks for you

College Physics

Physics

ISBN:

9781305952300

Author:

Raymond A. Serway, Chris Vuille

Publisher:

Cengage Learning

University Physics (14th Edition)

Physics

ISBN:

9780133969290

Author:

Hugh D. Young, Roger A. Freedman

Publisher:

PEARSON

Introduction To Quantum Mechanics

Physics

ISBN:

9781107189638

Author:

Griffiths, David J., Schroeter, Darrell F.

Publisher:

Cambridge University Press

College Physics

Physics

ISBN:

9781305952300

Author:

Raymond A. Serway, Chris Vuille

Publisher:

Cengage Learning

University Physics (14th Edition)

Physics

ISBN:

9780133969290

Author:

Hugh D. Young, Roger A. Freedman

Publisher:

PEARSON

Introduction To Quantum Mechanics

Physics

ISBN:

9781107189638

Author:

Griffiths, David J., Schroeter, Darrell F.

Publisher:

Cambridge University Press

Physics for Scientists and Engineers

Physics

ISBN:

9781337553278

Author:

Raymond A. Serway, John W. Jewett

Publisher:

Cengage Learning

Lecture- Tutorials for Introductory Astronomy

Physics

ISBN:

9780321820464

Author:

Edward E. Prather, Tim P. Slater, Jeff P. Adams, Gina Brissenden

Publisher:

Addison-Wesley

College Physics: A Strategic Approach (4th Editio…

Physics

ISBN:

9780134609034

Author:

Randall D. Knight (Professor Emeritus), Brian Jones, Stuart Field

Publisher:

PEARSON

SEE MORE TEXTBOOKS