A V-Belt drive is designed so that it has the input sheave on the shaft of an electric motor (normal torque) rated at .55 hi at 1160 rpm full-load speed. The drive is to a bucket elevator that is to be used 12 hours daily at approximately 675 rpm. The center distance is about 19.5 in. Add the detailed steps of your design to your attached worksheet. Hints: 1) In your design choose an appropriate belt section, specify the small pulley diameter, the large pulley diameter and the length of the belt. Determine the Belt length in inches, in two significant figures. Please enter below a numerical value only, no units are needed.

A V-Belt drive is designed so that it has the input sheave on the shaft of an electric motor (normal torque) rated at .55 hi at 1160 rpm full-load speed. The drive is to a bucket elevator that is to be used 12 hours daily at approximately 675 rpm. The center distance is about 19.5 in. Add the detailed steps of your design to your attached worksheet. Hints: 1) In your design choose an appropriate belt section, specify the small pulley diameter, the large pulley diameter and the length of the belt. Determine the Belt length in inches, in two significant figures. Please enter below a numerical value only, no units are needed.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Hello, could you please help. i need to work out the holding torque, thanks
I will rate helpful. Thank you.
hand written plzz
hand written plz asap
A 2hp motor is to drive a food shredder. The motor is projected to run at 1450 rpm and the required speed at the food shredder is 60 rpm. Design a double reduction drive consisting of belt and chain for this application. Please give solution and show drawing if needed
Design a driver shaft to be used with the following belt drive. Assume the shaft is simply supported by two bearings at both ends, and the effective diameter for the driving pulley is 100 mm. Do the following 1) Sketch shaft layout 2) Select Shaft components required to lock the axial position of the pulley and allow torque transmission 3) Size the driver shaft diameter and length if the driving torque is 5 Nm. And rotation speed of 1500 rpm. You are free to choose your own material **** Use DE-Goodman criteria for sizing and make sure that the shaft works within its critical speed.*** Answer: DRIVER SHAFT Design this driving shaft Shaft A SLACK SIDE TIGHT SIDE M R DRIVEN SHAFT
A belt conveyor transports 18 tonnes per hr at 20°. Calculate the height in m to lift the load vertically up sufficient to give 33.5 m inclined belt length. 1750-rpm motor, V-belt drive to helical gear speed reducer. Belt speed, 61 m/min. Discharge over tail pulley. No tripper.