A tubewell of 30 cm diameter penetrates fully into an artesian aquifer. The strainer length is 15 m. The yield from the well under a drawdown of 3 m through the aquifer consisting of sand of effective size of 0-2 mm and coefficient of permeability of 50 m/day, with rauius of drawdown of 150 m, is nearly 21. (a) 240 lls (b) 120 l/s (c) 24 l/s (d) 12 lls

A tubewell of 30 cm diameter penetrates fully into an artesian aquifer. The strainer length is 15 m. The yield from the well under a drawdown of 3 m through the aquifer consisting of sand of effective size of 0-2 mm and coefficient of permeability of 50 m/day, with rauius of drawdown of 150 m, is nearly 21. (a) 240 lls (b) 120 l/s (c) 24 l/s (d) 12 lls

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

The permeability of sand in horizontal and vertical directions are 3 × 10- 3 cm/sec and 1 x 10-3 cm/sec and the permeability of clay in horizontal and vertical directions are 9 x 10-7 cm/sec and 3 × 10-9 cm/sec, then the ratio of X seepage Loss per meter length of dam in sand to clay is:
Yuri wants to determine the permeability of an aquifer. The aquifer has a test well 300-mm in diameter with two observation wells. A pumping test was conducted for 24 hours with the discharge being held constant at 5,896.3 m^3/day. The first one, 82.87 meters from the test well, has a draw-down of 0.86 meters. The second one, 44 meters from the test well, has a draw-down of 1.21 meters.The static water table penetrates the well to a depth of 28 meters. Determine the radius of influence of the aquifer in meters. Round off to three decimal places.
Problem G: For Problem 27 to 28. In a constant head permeability test the following are given L= 250 mm and A=105 cm?. If the value of k = 0.014 cm/secand flow rate of 120 cm3/min which is to be maintained. 27) What is the head difference, h in the specimen? b) 34.341 cm 28) Determine the discharge velocity in cm/sec? b) 0.109 a)34.136 cm c) 33.901 cm d) 34.014 cm a) 0.0189 c) 1.019X102 d) 0.019
← Darcy' Law A sand sample of 35 m² cross sectional area and 20 cm long was tested in a constant head permeameter. Under a head of 60 km, the discharge was 120 ml in 6 min. The dry unit weight of sand used for the test was 1120 g. and GS = 2.68 Take Sw = 1 g/ cm³ The hydraulic conductivity (in cm/sec) is × 10-³ X
7.7 In a constant-head permeability test, the length of the specimen is 200 mm and the cross sectional area is 78.5 cm². If k = 2.1 x 10-2 cm/sec, and a rate of flow of 130 cm³/min has to be maintained during the test, what should be the head difference across the specimen?
d) What is the equivalent permeability which will govern the productivity of the following well? re= 700 ft Ke = 500 md %3D rw = 4 inch ka= 5 md ra= 2 ft
Thank u
A falling-head permeameter containing a silty, fine sand has a falling-head tube diameter of 4.2 cm, a sample diameter of 10.4 cm, and a length of 15.6 cm. The initial head is 15.5 cm. It falls to 1.4 cm over a period of 468 min. Find the hydraulic conductivity.
D. Law,
A well in an unconfined aquifer is pumped at the rate of 50 L/s ( 800 gal/min.). The thickness of the aquifer is 30 m. and the elevation of the phreatic surface is 25 m. above the underlying aquiclude at an observation of well 20 m away from the well and 34.6 m above at a well 50 m. away. What is the value of K for this aquifer?
During the recuperating test, the water level was initially lowered by 2.65 m and is recuperated by 1.45 m in 1 hour. Determine the yield (in litre per sec) from an open well of diameter 3 m under a depression head of 3.45 m.