A permeability pumping test was carried out in a confined aquifer with the piezometric level before pumping is 2.18 m. below the ground surface. The aquiclude (impermeable layer) has a thickness of 5.98 m. measured from the ground surface and the confined aquifer is 7.5 m. deep until it reaches the aquiclude (impermeable layer) at the bottom. At a steady pumping rate of 17.8 m³/hour the drawdown in the observation wells. were respectively equal to 1.60 m. and 0.42 m. The distances of the observation wells from the center of the test well were 18 m. and 34 m. respectively. Compute the depth of water at the farthest observation well.

Q: What is the measurement benchmark

A: The given questions asks about the measurement of benchmark.

Q: What is wrong with the picture at right?" (<25 words) YES! Safel NOI Unsafel

A: A picture including of two images where different cases of cylinders were given.

Q: I need this answer handwritten mention question number also and please on white page I'll UPVOTE for…

A: Solution: The given problem is symetrical section with symmetrical loading: Hence it is enough to…

Q: ACTIVITY 6: LINE TYPES ft. a Simple Object Dimension line (Thin) 8 cm Extension line 5 mm THK Metal…

A: It comes under Engineering Drawing, also known as Engineering Graphics.  For Mechanical Engineering,…

Q: Please answer problem 4 and problem 5 please

A: Solution: Problem 4: Let L = a x b ∑Mc=0 RAa+b-Pb=0RA=Pba+b=PbL

Q: Could you show the calculations for the table

A: The discharge through the section = Q = 100, 150, 200, and 250 cfs The slope of the section = S =…

Q: In the MIPS instruction "jr $1", what information does register $1 contain?     the address of the…

A:

Q: What is the most common scale used for temperature

A: The Celsius and fahrenheit scale is used most commonly used.. Kelvin scale is primarily used in…

Q: This is incorrect, please redo it, I have attached what the correct answers are supposed to be S

A: For a given soil profile, there is an upward seepage occurring. The velocity of the upward flow, v =…

Q: Convert 24 inches to feet.

A:

Q: A. WATER LINES, PIPES, CONNECTIONS AND FIXTURES  B.  SEWER LINES, PIPES, CONNECTIONS AND FIXTURES…

A: Hi! Thank you for the question As per the honor code, We’ll answer the first question since the…

Q: Convert 1600 mils into equivalent value in grads O 90 degrees O 180 degrees O 270 degrees

A: To convert mils to degree

Q: What are Line of Balance Charts?

A: A line of balance chart is a graphical report of the schedule of projects that uses progression…

Q: i need all parts of question on the right hand corner solve I STATED FILL IN THE BLANKS.

A: Only 3 subparts can be answered at a time according to guildlines. Please resubmit the question…

Q: WHICH ACI CODES DID YOU USE?

A: A building layout is given, we need to find out which ACI code is used in solving the problem

Q: MAY 30 For the truss shown below disregarding the weight of the structure: 20 KN All vertical…

A:

Unit Conversion

Standard units are also called SI units. SI units are used for measuring a physical quantity satisfying certain conditions. There are two types of units: fundamental units and derived units. Fundamental units are physical quantities that are independent, that is, they do not depend on other quantities like mass, length, or time. There are plenty of quantities in our lives which need to be measured and compared. Measuring is the comparison of a particular physical quantity with its reference value. A unit is a measure of a fixed physical quantity. A physical quantity is the product of a unit and the numerical value we need to compare with.