A steam generating unit has a steam production of 2000 kg/h (170°C, 0.8MPA, X=1). Feed water is at 45°C. Consider that the fuel has PCI=12MJ and is powered at a rate of 470|| kg/h. Calculate thermal efficiency and the evaporation rate of a steam generator taking into account that it equipment is of the Flamotubular type. Answer: 91%; 4.25 kg/kg fuel.

A steam generating unit has a steam production of 2000 kg/h (170°C, 0.8MPA, X=1). Feed water is at 45°C. Consider that the fuel has PCI=12MJ and is powered at a rate of 470|| kg/h. Calculate thermal efficiency and the evaporation rate of a steam generator taking into account that it equipment is of the Flamotubular type. Answer: 91%; 4.25 kg/kg fuel.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A water tube boiler produces 250,000 pounds of steam per hour at 1200 psia and1000°F from feed water entering the boiler at 1500 psia and 360°F. Fuel oil havinga higher heating value of 18,200 Btu/lb is supplied to the burners at the rate of20,700 lb/hr. Furnace volume is 1500 cubic feet. Calculate the equivalentevaporation, lb/hrA. 300,117 B. 300,317 C. 300,517 D. 300,717
1. Steam is generated at 4.20 MPa and 460°C and condensation occurs at 0.105MP.. a. For a rankine engine operating between these limits compute the thermal efficiency and the heat rate. b. Considering that a Rankine cycle occurs between the same limits, determine Q.. Q,, w. and e C. What mass flow rate is required for a net output of 35,000 kW?
9. A vapour compression plant is powered by a 2kW motor and circulates R12 at 5kg/min. The R12 leaves the condenser at its saturation temperature with a specific enthalpy of 74.59kJ/kg and leaves the evaporated dry saturated with a specific enthalpy of 187.53kJ/kg. Calculate: (a). the dryness fraction at the evaporator inlet (b). refrigeration effect (c). coefficient of performance
اريد حل كتابة يد
ROOM (2) 700kPa x-0 CONDENSER k (1) 40°C 700OkPa EXPANSION VALVE (3) 100kPa EVAPORATOR (4) 100kPa x=1 OUTSIDE Consider a heat pump cycle operating with R134-a fluid at 0.01kg/s mass flow rate. Conditions are given in the figure. a) What are the values of heat supply rate to the room and heat absorption rate from the outside? b) What is COP of this heat pump? c) Assume we immediately put a watermelon of 8kg to the room at 2°C. Assuming a specific heat of 4200J/kg for the watermelon, how long will it take for the watermelon to reach room temperature of 20°C if we assume that heat pump only heats watermelon? CA122.minutes O D112 menute COMP.
The condensing pressure for a Rankine engine is 0.001325 MPavac. Calculate the following for steam flow rate = 16.3846 kg/sec of steam when the steam at the beginning of expansion is at 119.6 deg SH and 4.0 Mpaa. Draw the TS and equipment diagrams for the ideal and actual case and find for the following for the ideal case:
ercise 6 6.1 A surface condenser is fitted with separate air and condensate outlets. A portion of the cooling surface is screened from the incoming steam and the air is passes over these screened tubes to the air extraction and becomes cooled below the condensate temperature. The condenser receives 20 000kg/hr of dry saturated steam at 36.2°C. At the condensate outlet the temperature is 34.6°C TK and at the air extraction the temperature is 29°C. The volume of air and vapour leaving the condenser is 3.8m3/min. Assume constant pressure throughout the condenser, calculate: 6.1.1 the mass of air removed per 10 000kg of steam (2.63kg); 6.1.2 the mass of steam condensed in the air cooler per minute (0.5kg/min)%3B 6.1.3 the heat rejected to the cooling water (13451kW).
An ammonia ice plant produces ice from water at 30°C to ice at -5°C. It works on standard vapour compression cycle, dry saturated conditions at compressor inlet. The enthalpies at compressor inlet and condenser exit are 1443.9 kJ/kg and 366.1 kJ/kg. Mass flow rate of the refrigerant is 180 kg/h. The ice produced is. tons per day. Specific heat of water = 4.186 kJ/kgK; Specific heat of ice = 1.94 kJ/kgk Latent heat of water at 0°C = 335 kJ/kgK
A Rankine cycle is executed with steam expanding initially from 20 MPaa and 100 deg SH.Condensation occurs at T = 86.49 degree Celsius. All expansion and compression efficiencies are 90 %.Sketch the equipment layout and the TS diagram. Answer the following for (m = 10 + SN/10 ) kg/sec of steam circulated and fill up the blanks in theitems below:1. TS diagram with the cycle showing correct location of points with respect to saturation domeline with ne and nc = 90%.2. If the generator efficiency = 95%, brake engine efficiency = 90% what is the brake work in KW?Answer: ______________________3. Actual Steam Rate for the engine in Kg/KW-hr with efficiency values at item 2. Answer: _________________________
1. Steam is delivered to an engine at 5.4 MPa and 600°C. Before condensation at 31°C, steam is extracted for feedwater heating at 0.60 MPa. For an ideal cycle, find: (A) Amount of steam extracted (B) Wnet (C) eth
Bokr Py- 6000 kP Wpampin Pump Turbine P50 kPa Condenser "punpin Figure 2 (b) Determine the thermal efficiency of the cycle in part (a) when the liquid enters the pump 1.3°C cooler than a saturated liquid at the condenser pressure.
please answer 6 to 10