A solution of Acetone in Water is to be extracted using Chloroform as the solvent. The feed is 1000 kg/h of a solution containing 35 wt% acetone. The solvent comes from a solvent recovery unit and essentially pure chloroform. Inlet solvent flow rate is 350 kg/h. The exiting raffinate should contain 10 wt% acetone. Find the outlet concentrations and

Q: Problem No 3: A material contains 75% water and 25% solid is fed to a granulator at a rate of 4000…

A:

Q: Methanol is produced by reacting carbon monoxide and hydrogen at 644 K over a ZnO–Cr2O3 catalyst. A…

A: Given: CO+2H2→CH3OH CO and H2 ratio of 2mol H2/ mol CO fed to catalyst bed at 644 K and 34.5 MPa…

Q: Carbon dioxide is added at a rate of 10 kg/h to an air stream and the air is sampled at a sufficient…

A:

Q: 1. A 100 kg of 20% aqueous solution of was fed in a diluting stream of pure water to produce a 8%…

A:

Q: 3. Sea water is to be desalinized by reverse osmosis (RO) using the process shown in Figure 1. The…

A: Note: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question…

Q: The wet feed material to a continuous dryer contains 50%wt water and is dried to 27% by…

A: Given that- Flow rate of feed= F1 Dryer has water, x1w = 50%=0.5 So, solid content, x1s =50%=0.5…

Q: 8. Acetone is an important chemical in manufacturing process as well as an organic solvent. However,…

A:

Q: One hundred kg/hr of a 50 wt% solution of solute C in solvent A is to be extracted at 25 °C in a…

A: Given = 100 Kg/h of a 50 wt% solution of solute CT = 25^cTo find = Number of counter current stages

Q: A mixture containing 45.0 %mole benzene (B), 30%mole toluene (T), and 25 %mole xylene (X) is fed to…

A: Given :Mixture containingBenzene Toluene Xylene Bottom product:Xylene Benzene87.9% of the xylene in…

Q: Problem 2 Ethane is burned with 50 % excess air. The percentage conversion of the ethane is 90 %. Of…

A: Given Ethane burned with 50% excess air % Conversion of ethane=90% of Ethane burned  Formed CO=25%…

Q: a water solution containing 10% acetic acid is added to a water solution containing 30% acetic acid…

A: Given Water solution,1(10% acetic acid)+ Water solution,2(30% acetic acid)→Product Flow rate water…

Q: In a paint manufacturing process, two different colored paints are being mixed in an infinitely…

A: Concentration of Paint A = 30%Volumetric flow rate of paint A = 10 Liters/MinuteConcentration of…

Q: An aqueous solution containing 10 moles percent ammonia is to be separated via continuous flash…

A: An aqueous solution of ammonia and water is separated in a flash distillation column.

Q: 100. mol/hr of a mixture of hexane (60.0 % by mol) and acetone are fed into a flash drum and…

A: The objective of the question is to determine the total flow rates of both streams exiting the flash…