A small part of a power systems is shown in the single-line dlag-am in Figure 1. Grid Transformer 1 Overhead Transformer 2 Load transmission line 180 MVA 100 km long 150 MVA (112+j84) MVA x = 0.05 0/km 330/132 kV X = 8 % 132/11 kV X= 5 % 330 kV X = 10 0 Figure 1 Part of a power system (a) Briefly explain why over-head transmission lines are used for long distance transmission of electricity instead of underground cables. (b) What type of support would you recommend for the overhead transmission line in Figure 17 Briedy describe this type of support, clearly stating why you think it is the most suitable support for the overhead line in Figure 1. (c) Caleulate all the impedances in the power system in per-unit using a common base power of 200 MVA.

A small part of a power systems is shown in the single-line dlag-am in Figure 1. Grid Transformer 1 Overhead Transformer 2 Load transmission line 180 MVA 100 km long 150 MVA (112+j84) MVA x = 0.05 0/km 330/132 kV X = 8 % 132/11 kV X= 5 % 330 kV X = 10 0 Figure 1 Part of a power system (a) Briefly explain why over-head transmission lines are used for long distance transmission of electricity instead of underground cables. (b) What type of support would you recommend for the overhead transmission line in Figure 17 Briedy describe this type of support, clearly stating why you think it is the most suitable support for the overhead line in Figure 1. (c) Caleulate all the impedances in the power system in per-unit using a common base power of 200 MVA.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Vbase_zonel Sbase_zonel . * For the power system shown in Figure Q1b, calculate the per unit impedances of all components with given zone 1 voltage base 22kV and power base 100 MVA (for the system). = 22 kV = 100 MVA Generator: . YG₁ Zone 1 100 MVA 22 kV (0.1+ j0.5) pu 1 . E 1 T₁ YY Transformer 1: 100 MVA 25/130 kV (0.1+j0.5) pu Zone 2 L = (10+j100) S2 Figure Q1b. T₂ Zone 3 YA Transformer 2: 50 MVA 110/33 kV (0.1+j0.5) pu M₂Y Load (motor): ● 50 MVA . 33 kV (1+j0.5) pu
consider the ID as 12345679
Consider an ideal transformer with N1 ¼ 3000 and N2 ¼ 1000 turns. Let winding 1 beconnected to a source whose voltage is e1ðtÞ ¼ 100ð1 jtjÞ volts for 1a ta 1 ande1ðtÞ ¼ 0 for jtj > 1 second. A 2-farad capacitor is connected across winding 2. Sketche1ðtÞ, e2ðtÞ, i1ðtÞ, and i2ðtÞ versus time t
1. A single-phase power system as shown in Figure 1 consists of a 240 V, 60 Hz generator supplying a load, Zod = 8 + j6 Q through a transmission line of impedance, Zne = 0.08 + j0.14 Q. Answer the following questions: (1) transformer, T; and T2. Determine the voltage at the load and transmission line losses without the (ii) Determine the voltage at the load and transmission line losses with the transformer, T, and T2. T1 T2 1:10 10:1 IG Zaine Zioad source Figure 1
Subject name: Power System Protection
2- Determine the number of turns per-phase in each winding of a 3-phase transformer with a ratio of 20000/2000v. to work on a 50Hz network. The high-voltage winding is delta connected and the low-voltage is star-connected. Each core has a gross sectional area of 560 cm². Assume a flux density of about 1.2 wb/m². [1490/86]
An autotransformer have two separate windings, and are known as double-wound transformers. Select one: O True O False A 8 pole generator has a wave wound armature with 67 slots with 29 conductors per slot. Then the number of parallel paths in armature is
Two transformersA and B are connected in parallel to a load of (2+j1.5) ohm.Their impedances in Secondary terms ZA = (0.15+j0.8) ohm and Zb = (0.1+j30.6)ohm Their no-load termind voltages are EA=200<0 V and EB=210<0 Volt.Find the power and Power factor of each transformer? %3D %3D
This is a practice question from my Introduction to Circuits course. I'm not sure how to even start this. Thank you for your assistance.
Y=3